2004 JEEP GRAND CHEROKEE Owners Manual

Power Seat Adjuster Ð If Equipped
WARNING!
Do not ride with the seatback reclined so that the
shoulder belt is no longer resting against your chest.
In a collision you could slide under the seat belt and
be seriously injured or even fatally injured. Use the
recliner only when the vehicle is parked.
The power seat adjuster switches are located on the
outboard side of the seat.
6±Way Power Seat with Manual Recliner Ð If
Equipped
This seat switch is on the outboard side of the seat near
the floor. Use this switch to move the seat up or down,
forward or rearward, or to tilt the seat.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 65
3

This seat also has a manual recline lever located just to
the rear of the power seat switch. Pull up on the lever to
recline the seat.10±Way Power Seat with Power Recliner and
Power Lumbar Ð If Equipped
These seat switches are located on the outboard side of
the seat near the floor. Use these switches to move the
seat up or down, forward or rearward, to tilt the seat, to
recline the seat, or to increase/decrease the amount of
lumbar support.
66 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

CAUTION!
Do not put anything under a power seat. It may
cause damage to the seat controls.
Power Lumbar
The power lumbar control is located on the outboard side
of the seat. Use this switch to increase or decrease the
desired amount of lumbar support.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 67
3

Power Reclining Seat
The recliner control is on the outboard side of the seat.
Use this switch to recline the seatback and to return the
seatback to the upright position.
WARNING!
Do not ride with the seatback reclined so that the
seat belt is no longer resting against your chest. In a
collision you could slide under the seat belt and be
seriously or even fatally injured. Use the recliner
only when the vehicle is parked.
Memory System Ð If Equipped
If your vehicle is equipped with this system, your Re-
mote Keyless Entry Transmitter or Memory System But-
tons on the driver's door panel can be used to recall the
driver's seat, driver's outside rear view mirror, and radio
station presets to saved positions.
68 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

The Memory Position Buttons located on the driver's
door will always recall stored settings. The Remote
Keyless Entry Transmitters can be programmed to recall
positions when the ªUnlockº button is pressed. For
customer programmable features refer to the section on
ªOverhead Consoleº for programming details, otherwise
see your authorized dealer.
NOTE:The vehicle must be in P (Park), and the seat belt
cannot be latched if the ignition is in the ON position, to
recall memory positions.
Your vehicle was delivered to you with two remote
keyless entry transmitters. They are color coded to match
the memory buttons on the driver's door. These trans-
mitters work in conjunction with the number ª1º (black)
and number ª2º (gray) memory seat buttons on the
driver's door. Once the memory button has been set, the
corresponding remote keyless entry transmitter is also
set.NOTE:If the memory system is not set to your desired
positions, the seat and driver's mirror will default to the
factory setting each time the Keyless Entry Transmitter is
used.
To set the memory buttons follow this procedure:
1. Turn the ignition key to the ON position.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 69
3

2. Press the memory button ª1º if you are setting the
memory for driver one or number ª2º if you are setting
the memory for driver two.
3. Adjust the seat, recliner, and driver's outside rear view
mirrors to the desired position.
4. Set the radio station presets as you desire (up to 10 AM
and 10 FM station settings).
5. Press and release the SET button. An indicator light on
the set switch will flash, telling you that you are in the set
memory mode.6. Press and release button number ª1º or number ª2º on
the driver's door, depending on which transmitter you're
using. The flashing indicator light on the set switch will
go out telling you that the driver memory has been set.
If your remote keyless entry transmitter is lost, you may
order a new transmitter from your local authorized
dealer. You must designate transmitter #1 or #2. Your
authorized dealer will have to program your vehicle to
match the new transmitter.
70 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Heated Seats Ð If Equipped
This feature heats the driver's and passenger's front
seats. The controls for the heated seats are located on the
instrument panel below the heater/air conditioning con-
trols. After turning on the ignition you can choose from
HI, OFF, or LO heat settings.An indicator on the switch shows which setting has been
selected. To turn off the heated seats, position the switch
in the middle.
60/40 Split Rear Seat
Either side of the rear seat can be folded flat to allow for
extended cargo space and still maintain some rear seating
room.
NOTE:Be sure that the front seats are fully upright and
positioned forward. This will allow the rear seatback to
fold down easily.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 71
3

To fold the 60/40 rear seat perform the following
steps:
1. Use the pull straps available on each seat cushion
section; pull the strap forward and pivot the cushion
forward flush with the front seatback.
2. Remove the headrests from the rear seatback. Press the
button and pull the headrest from the seatback.The headrest posts can be fitted into the openings pro-
vided in the folded seat cushion for storage.
3. Locate the seatback release handle on the outboard top
side of each rear seatback; lift up on the handle, and
rotate the lever forward until the seatback releases. Fold
the seatback completely forward.
72 UNDERSTANDING THE FEATURES OF YOUR VEHICLE