10-6 CAB
7) Apply the window glass sealing adhesive
2.
If you are using an air gun, air pressure should be
maintained at 147 - 294 kpa.
After drying primer completely, apply a sealing adhesive
(Sunstar #557 or equivalent) along the edge of the glass so
that the sealing adhesive has a 20 mm (0.79 in) junction a
t
middle of the vase of the glass.
Note :
Open time (1 min. or more) should be set after application
of the primer.
Bonding shall be done within 5 minutes after the sealing
adhesive has been applied.
8) Adjust the setting of the windshield glass with suction discs.
Set the windshield with sealing adhesive applied to entire
circumference in the body panel. Specifically, adjus
t
windshield support with the upper molding making contact
with the body panel, press the glass, and tighten the
windshield support.
9) Use unleaded gasoline and a soft cloth to wipe away any
excess adhesive.
Cure the bonding at a temperature of 68
- 86
F (20
-
30
C) for twenty-four hours.
Check that the windshield does not leak water.
8. Wiper Arm Assembly
Set the wiper arm/blade so that the tips of both blades
are positioned the specified value of
A and Bfrom the
upper edge of the cowl cover as shown in the figure.
A 40 mm (1.57 in)
B 52 mm (2.05 in)
Tighten the wiper arm assembly fixing nuts to the
specified torque.
Torque Nm (kgfm/lbft)
31 (3.1/23)
