WW-34
FRONT WIPER AND WASHER SYSTEM
Revision: 2004 November 2004 FX35/FX45
INSTALLATION
Note the following, and install in the reverse order of removal.
NOTE:
After installation, add water up to the upper level of the washer tank inlet, and check for water leaks.
Removal and Installation of Washer MotorAKS0057G
REMOVAL
1. Remove fillet molding (RH) and fender protector (RH). Refer to
EI-14, "
Removal and Installation" , EI-25, "Removal and Installa-
tion" in “EI” section.
2. Disconnect washer motor connector and tube.
3. Pull out washer motor in direction shown by the arrow in the fig-
ure. Remove washer motor from washer tank.
INSTALLATION
Note the following, and install in the reverse order of removal.
NOTE:
When installing washer motor, there should be no packing twists, etc.Washer tank mounting screw : 5.8 N·m (0.59 kg-m, 51 in-lb)
Washer tank mounting nut : 5.8 N·m (0.59 kg-m, 51 in-lb)
Washer tank inlet mounting bolt : 6.9 N·m (0.70 kg-m, 61 in-lb)
SKIA5079E
REAR WIPER AND WASHER SYSTEM
WW-51
C
D
E
F
G
H
I
J
L
MA
B
WW
Revision: 2004 November 2004 FX35/FX45
Check Valve InspectionAKS0057X
A check valve is provided in the washer fluid line. Be careful not to
connect check valve to washer tube in the wrong direction.
Removal and Installation of Rear Wiper and Washer SwitchAKS0057Y
Refer to WW-33, "Removal and Installation of Front Wiper and Washer Switch" .
Removal and Installation of Washer TankAKS0057Z
Refer to WW-33, "Removal and Installation of Washer Tank" .
Removal and Installation of Washer PumpAKS00580
Refer to WW-34, "Removal and Installation of Washer Motor" .
SEL411H
