2004 HUMMER H2 clock

{CAUTION:
Raising your vehicle with the jack improperly
positioned can damage the vehicle and even
make the vehicle fall. To help avoid personal
injury and vehicle damage, be sure to t the
jack lift head into the proper location before
raising the vehicle.
6. Turn the ratchet clockwise to raise the vehicle.
Raise the vehicle far enough off the ground so
there is enough room for the spare tire to clear the
ground.7. Remove all the wheel
nuts and take off the
at tire.
5-86

9. After mounting the
spare, put the wheel
nuts back on with
the rounded end of the
nuts toward the
wheel.
Tighten each wheel nut by hand. Then use the
ratchet/wheel wrench to tighten the nuts, with the
UP mark facing you, clockwise until the wheel
is held against the hub. You will not be tightening
the nuts fully yet.10. Lower the vehicle by turning the ratchet
counterclockwise, with the DOWN mark facing you.
Lower the jack completely.
Front PositionRear Position
5-88

11. Tighten the nuts rmly
in a crisscross
sequence as shown by
turning the ratchet
clockwise, with the UP
mark facing you.
{CAUTION:
Incorrect wheel nuts or improperly tightened
wheel nuts can cause the wheel to come loose
and even come off. This could lead to an
accident. Be sure to use the correct wheel nuts.
If you have to replace them, be sure to get new
GM original equipment wheel nuts. Stop
somewhere as soon as you can and have the
nuts tightened with a torque wrench to the
proper torque specication. See “Capacities
and Specications” in the Index for wheel nut
torque specication.
Notice:Improperly tightened wheel nuts can lead to
brake pulsation and rotor damage. To avoid
expensive brake repairs, evenly tighten the wheel
nuts in the proper sequence and to the proper torque
specication. See “Capacities and Specications” in
the index for the wheel nut torque specication.
12. When you install the wheel and tire, you must also
reinstall the center cap. Place the cap on the wheel
and tap it into place until it sits ush with the wheel.
5-89

Then use the ratchet and
spanner to tighten the nut
rmly. Try to move the
tire back and forth slightly
to be sure it is secure.
4. Reattach the wheel blocks (E) to the tire retainer
plate (C) and tighten the wing nut.
5. Reinstall the tire cover onto the spare or at tire.
Follow these instructions to store the jack and tools:
1. Lower the jack completely.
2. Place the jack in the mounting bracket.3. Tighten the wingnut (A)
until the jack is
securely fastened.
4. Place the tools in the bag.
5. Slide the securing clip over the bag and secure the
bag to the oor by tightening the wingnut (B) to the
stud coming out of the oor.
In order to reduce the potential of the jack
squeaking or rattling, you will need to preload the
jack so it ts tightly in the mounting bracket.
To do this, turn the u-hook/clevis at the top of the
jack clockwise until the jack is held tight in the
mounting bracket.
5-91