2004 HONDA ODYSSEY Button

Î
Î
To use the horn, press the pad around the ‘‘H’’ logo.
:
Your Vehicle at a Glance
3
TRACTION CONTROL SYSTEM
POWER SLIDING
DOOR SWITCHES HEADLIGHTS/
TURN SIGNALS
REAR WINDOW
DEFOGGER
WINDSHIELD
WIPERS/WASHERS
CRUISE
CONTROL
HORN
STEERING WHEEL
ADJUSTMENT
CRUISE
CONTROL MIRROR
CONTROLS
(P.192)
(P.71)(P.73)CLOCK
(P.105)
(P.73)
(P. 32)
(P.69)
(P.160)
(P.74)
(P.160) (P.102) (P.85)
LIGHT CONTROL
SWITCH
AUDIO SYSTEM/
REAR
ENTERTAINMENT
SYSTEM
(P.126, 145)
(P. 112 )
STEERING WHEEL
AUDIO CONTROLS
(P.143) HAZARD WARNING
BUTTON
PASSENGER
AIRBAG OFF
INDICATOR

CONT INUED
Insert the hook at the end of the
shoulder belt plate into the metal
loop on the latch plate marked
CENTER.Makesuretheshoulder
belt is not twisted, as a twisted belt
can cause serious injuries in a crash.
Pull on the shoulder belt to make
sure it is securely attached.
Unlatch the metal shoulder belt plate
f rom the anchor on the ceiling, then
extend the belt by pulling the metal
plate.
The f ront seats and second row seats
have adjustable seat belt anchors. To
adjust the height of an anchor, press
andholdthereleasebuttonandslide
the anchor up or down as needed
(the anchor has f our positions).
Protecting A dults and Teens
Driver and Passenger Saf ety
Using t he L ap/Shoulder Belt in t he
Cent er Posit ion of t he T hird Row
15
METAL
HOOK
LATCH PLATE
RELEASE
BUTTON METAL PLATE

Your seat belt system includes lap/
shoulder belts in all seven seating
positions. The f ront seat belts are
also equipped with automatic seat
belt tensioners.Most seat belts are a one-piece lap/
shoulder belt. This seat belt goes
over your shoulder, across your
chest and across your hips.
To fasten the belt, insert the latch
plate into the buckle, then tug on the
belt to make sure the buckle is
latched (see page f or how to
properly position the belt).
To unlock the belt, push the red
PRESSbuttononthebuckle.Guide
the belt across your body so that it
retracts completely. Af ter exiting the
vehicle, be sure the belt is out of the
way and will not get closed in the
door.The seat belts in all positions except
the driver’s and the center seat in
the third row have an additional
locking mechanism that must be
activated to secure a child seat (see
page ).
If the shoulder part of the belt is
pulled all the way out, the locking
mechanism will activate. The belt
will retract, but it will not allow the
passenger to move f reely.
To deactivate the locking
mechanism, unlatch the buckle, and
let the seat belt f ully retract. To
ref asten the belt, pull it out only as
f ar as needed.
The seat belt system
includes an indicator on the
instrument panel to remind you and
your passengers to f asten your seat
belts.
If the driver’s seat belt is not
fastened before the ignition is turned
to ON (II), the indicator will come on
and a beeper will also sound. The
beeper will stop af ter a f ew seconds,
but the indicator will stay on until the
driver’s seat belt is f astened. 46
14
Additional Inf ormation About Your Seat Belts
Driver and Passenger Saf ety
Seat Belt System Components L ap/Shoulder Belt
(Except cent er posit ion of t hird row)
20

µAll seat belts have an emergency
locking retractor. In normal driving,
the retractor lets you move f reely in
your seat while it keeps some
tension on the belt. During a collision
or sudden stop, the retractor
automatically locks the belt to help
restrain your body.
To unlatch the belt, push the red
PRESS button on the buckle and
detach the shoulder belt f rom the lap
belt.
When properly assembled, the
combination lap belt and shoulder
belt in this position goes over your
shoulder, across your chest, and
over your hips (see pages for belt assembly, latching, and
positioning instructions). 15
16
Additional Inf ormation About Your Seat Belts
Driver and Passenger Saf ety
(Cent er posit ion of t hird row)
21

This indicator reminds you that it is
time to take your vehicle in for
scheduled maintenance.
Ref er to the Maintenance Schedules
f or Normal and Severe Driving
Conditions on pages and .Between 6,000 miles (9,600 km) and
7,500 miles (12,000 km), it will light
f or 2 seconds when you f irst turn the
ignition switch to ON (II), and then
f lash f or 10 seconds.
If you exceed 7,500 miles (12,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.
Your dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Honda dealer, reset the indicator as
f ollows.
Turn of f the engine. Hold the button for about 10
seconds until the indicator goes
of f .
For the f irst 6,000 miles (9,600 km)
af ter the Maintenance Required
Indicator is reset, it will come on f or
2 seconds when you turn the ignition
switch to ON (II).
Press and hold the Select/Reset
buttonintheinstrumentpanel,
then turn the ignition switch to
ON (II).
1. 2.
3.
205 206
Maintenance Required Indicator
Inst rument s and Cont rols
Maintenance Required
Indicator
65
SELECT/RESET BUTTON

This shows how much f uel you have.
It may show slightly more or less
than the actual amount. The needle
returns to the bottom after you turn
of f the ignition. This shows the total distance your
vehicle has been driven. It measures
miles in U.S. models and kilometers
in Canadian models.
It is illegal under U.S. f ederal law and
Canadian provincial regulations to
disconnect, reset, or alter the
odometer with the intent to change
the number of miles or kilometers
indicated.
Gauges
Inst rument s and Cont rols
Odometer
Fuel Gauge
66
NOTICE:
TACHOMETER SPEEDOMETERTEMPERATURE
GAUGE
TRIP METER FUEL GAUGE
TRIP METER SELECT/RESET BUTTON
MAINTENANCE
REQUIRED INDICATOR ODOMETER
Avoid driving with an
extremely low f uel level. Running out
of f uel could cause the engine to
misf ire, damaging the catalytic
converter.

The trip meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it.
There are two trip meters: Trip A
and Trip B. Switch between these
displays by pressing the Select/
Reset button repeatedly. Each trip
meter works independently, so you
can keep track of two dif f erent
distances.
To reset a trip meter, display it, and
then press and hold the Select/Reset
button until the number resets to
‘‘0.0’’.This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
mayrisetoneartheupperwhite
mark. If it reaches the red (Hot)
mark, pull saf ely to the side of the
road. Turn to page for
instructions and precautions on
checking the engine’s cooling
system.
250
Gauges
Inst rument s and Cont rols
Trip Meter
Temperature Gauge
67

Î
Î
To use the horn, press the pad around the ‘‘H’’ logo.
Controls Near the Steering Wheel
Inst rument s and Cont rols68
REAR WINDOW
DEFOGGER
LIGHT CONTROL
SWITCH
HORN
TILT
ADJUSTMENT
HEADLIGHTS/
TURN SIGNALS
CRUISE
CONTROL WINDSHIELD
WIPERS/WASHERS
POWER SLIDING DOOR
(EX and EX-L models)
MIRROR CONTROL SHIFT LEVER
TRACTION CONTROL
SYSTEM HAZARD WARNING
BUTTON
PASSENGER AIRBAG
OFF INDICATOR