2004 HONDA CIVIC COUPE immobilizer

[x] Cancel search: immobilizer

Page 50 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual This section gives inf ormation about 
the controls and displays that
contribute to the daily operation of
your Honda. All the essential
controls are within easy reach............................
Cont

Page 52 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual Î
Î
CONT INUED
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Shif t Lever Position Indicator f or the HX is shown on page 134 .
Instrument Panel

Page 53 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual Instrument Panel
Inst rument s and Cont rols
Canada: DX
54
LOW OIL PRESSURE 
INDICATORDAYTIME RUNNING
LIGHTS INDICATOR
MALFUNCTION INDICATOR LAMP WASHER LEVEL
INDICATOR
TRUNK-OPEN INDICATOR
IMMOBILIZE

Page 54 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual Instrument Panel
Inst rument s and Cont rols
U.S.: DX
55
SUPPLEMENTAL RESTRAINT SYSTEM INDICATOR
IMMOBILIZER SYSTEM 
INDICATOR 
LOW OIL PRESSURE 
INDICATOR
MAINTENANCE REQUIRED INDICATOR
TRUNK-OPEN IN

Page 58 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual This indicator comes on f or a f ew 
seconds when you turn the ignition
switch to ON (II). It will go of f if you
have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the i

Page 68 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual Youshouldhavereceivedakey 
number tag with your set of keys.
You will need this key number if you
ever have to get a key replaced. Use
only Honda-approved key blanks.These keys contain electronic
circ

Page 69 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual The Immobilizer System protects 
your vehicle f rom thef t. If an
improperly-coded key (or other
device) is used, the engine’s f uel
system is disabled. 
When you turn the ignition switch to 
ON (II

Page 189 of 231

HONDA CIVIC COUPE 2004 7.G Owners Manual In this case, the starter motor’s 
speed sounds normal, or even f aster
than normal, when you turn the
ignition switch to START (III), but
the engine does not run.Are you using the proper starting
p
Page:   1-8 9-16 next >