Page 300 of 388
Front side marker lights
Turn the light socket counterclockwise and pull it out and
remove the light bulb.
Rear combination lights
1. Turn the trim cover clip (A) counterclockwise and
remove the trim cover clip. Partially remove the trim
cover in the trunk.
N10D0170N20I0170
300 EMERGENCIES
Page 301 of 388
2. Remove the light case mounting nuts. Disconnect the
connector.3. Slide the light unit outward to remove it. Remove each
bulb socket assembly by turning it counterclockwise.
Remove the bulb from the socket by turning it counter-
clockwise while pressing it inward.
N20I0160N20I0290
A - Stop and tail light
B - Rear turn signal and tail
light
C - Rear side marker light
EMERGENCIES 301
8
Page 302 of 388
High-mounted stop light
Remove the socket assembly and bulb together by turn-
ing it counterclockwise.
Remove the bulb from the socket by pulling out.
License plate light
Remove the lens mounting screws, remove the socket
assembly and the bulb together by turning it counter-
clockwise. And remove the bulb by pulling out.
N10V0710N10J0310
302 EMERGENCIES
Page 303 of 388
Back up lights
1. Remove the light mounting screw and pull the entire
light bracket out.2. Push the connector (A) to disconnect and remove the
light bulb.
N11H0140
N11H0150
EMERGENCIES 303
8
Page 304 of 388
3. Remove the entire socket and bulb assembly (B) by
turning it counterclockwise.4. When mounting the light unit, align the pin (C) on the
light unit with the hole in the body.
N11H0160N11H0170
304 EMERGENCIES
Page 305 of 388
Trunk light
Pull both clips away from the center as shown and
remove the light unit. Then remove the bulb by pulling
out.
Dome light
1. Insert a flat blade screwdriver into the notch of the
light assembly and pry gently downward to remove it.
Type 1
NOTE
: Wrap a cloth around the tip of the screwdriver to
avoid scratching the light assembly.
N10O0230
Clips
N10M0380
EMERGENCIES 305
8
Page 306 of 388
2. Remove the light bulb from the light holder.Reading lights
Insert a straight blade screwdriver into the notch of the
light assembly and pry gently to remove the lens.
Remove the light bulb from the light holder.
NOTE: Wrap a cloth around the tip of the straight blade
screwdriver in order to avoid scratching the lens.
N10M0410
N11I0040
306 EMERGENCIES
Page 307 of 388
Rear personal light
Insert the tip of a flat blade screwdriver at the edge of the
lens, pry gently to remove the lens, and then remove the
bulb from the light holder.
NOTE: Wrap a cloth around the tip of the screwdriver in
order to avoid scratching the lens.
N10Q0090
EMERGENCIES 307
8