2004 CADILLAC SRX Owners Manual

Reprogramming a Single HomeLink®
Button
To program a device to HomeLink®using a HomeLink®
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
®button.
Do not release the button.
2. The indicator light will begin to ash after
20 seconds. While still holding the HomeLink
®
button, proceed with Step 2 under “Programming
HomeLink®.”
Resetting Defaults
To reset HomeLink®to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to ash.
2. Continue to hold both buttons until the HomeLink
®
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
®at
1-800-355-3515, or on the internet at
www.homelink.com.
Storage Areas
Glove Box
The glove box is located in front of the passenger’s seat
on the instrument panel. To lock the glove box door,
insert your key into the lock cylinder and turn it
clockwise. Turn the key counterclockwise to unlock
the door.
Cupholder(s)
Your vehicle has cupholders located between the front
seats. Slide the cover back to expose them. There are
also cupholders in the armrest of the second row
seat. Press the panel on the front of the armrest to
expose the cupholders. On the outboard sides of
the third row there may also be cupholders.
Cell Phone Storage Area
Your vehicle has a closeable cell phone/sunglasses
storage area inside both of the front doors. Press
the button to open the door.
2-45

Center Console Storage Area
Your vehicle has a center console storage area located
between the front seats. It includes storage areas,
and accessory power outlet(s) on the rear of the
console.
Map Pocket
There are map pockets located near the bottom of the
front doors.
Assist Handles
Your vehicle has assist handles located above the
doors.
Garment Hooks
Your vehicle has garment hooks located between the
rear doors and the liftgate.
Luggage Carrier
{CAUTION:
If you try to carry something on top of your
vehicle that is longer or wider than the luggage
carrier — like paneling, plywood, a mattress
and so forth — the wind can catch it as you
drive along. This can cause you to lose
control. What you are carrying could be
violently torn off, and this could cause you or
other drivers to have a collision, and of course
damage your vehicle. You may be able to carry
something like this inside. But, never carry
something longer or wider than the luggage
carrier on top of your vehicle.
2-46

If you have the luggage carrier, you can load things on
top of your vehicle. The luggage carrier has side
rails attached to the roof. You can get sliding crossrails
through your dealer to use for tying things down.
These let you load some things on top of your vehicle,
as long as they are not wider or longer than the
luggage carrier.
Convenience Net
The convenience net attaches to the oor or back wall
of the rear of the vehicle using six anchor points.
The net can be used like a hammock across the rear of
the vehicle or hooked on the oor. Put small loads,
like grocery bags, behind the net. It can help keep them
from falling over during sharp turns or quick starts
and stops.
The net is not for larger, heavier loads. Store them in
the rear of the vehicle as far forward as you can.
Cargo Cover
If your vehicle has a cargo cover, you can use it to
cover items in the rear of the vehicle. Pull the cover from
the passenger’s side to the driver’s side and slide the
ends into the slots to secure it. When it is not in
use, take the ends out of the slots and allow the cover
to roll back up.
2-47

Cargo Management System
Your vehicle may have a cargo management system.
It provides extra storage space for the rear of the
vehicle.
The cargo management system has three compartments.
The one closest to the front of the vehicle opens from
behind the second row. The center compartment has a
divider. The compartment closest to the rear of the
vehicle has a removable storage bin.
Sunroof
Sunroof (UltraView)
{CAUTION:
People who are in a crash and not wearing a
safety belt properly can suffer much worse
injuries. They can hit things inside the vehicle
or be ejected from it, and be seriously injured
or killed. This is true for any vehicle occupant,
in any motor vehicle, but if you have the
Ultraview roof it is, if anything, even more
important. In a rollover or other crash, the
Ultraview roof can be damaged or destroyed.
People who are unbelted would then be at
even greater risk of being ejected from the
vehicle. Always fasten your safety belt, and
check that your passengers’ belts are fastened
properly too.
Your vehicle may have a single sunroof over the rst
two rows of seats.
2-48

The sunroof/sunshade
switches are located in the
headliner between the
driver and front passenger.
One switch operates the sunroof and the other switch
operates the sunshade.
Press the back of the sunroof switch to open the
sunroof. If you press the switch to the rst detent the
sunroof will express open to a comfort stop. Press
the switch to the second detent to express open the roof
all of the way. Press the front of the switch to close
the sunroof. The rst detent will close it manually and
the second detent will express close the roof.
Press the back of the sunshade switch to open the
sunshade. Press the front of the switch to close
the sunshade. The sunshade can not be closed further
than the glass panel.Anti-Pinch Feature
If an object is in the path of the sunroof when it is
closing, the anti-pinch feature will detect the object and
stop the sunroof from closing at the point of the
obstruction. The sunroof will then reverse. To close the
sunroof once it has re-opened, remove the obstruction
and press the front of the sunroof switch.
Resynchronization
To resynchronize the glass and sunshade, do the
following.
1. With the engine running, press and hold the
sunroof switch in the open position and the
sunshade switch in the close position for six
seconds.
2. Release both buttons.
3. Press the sunshade switch in the close position
until the motor stalls in the closed position.
4. Press the sunroof switch in the close position until
the motor stalls in the closed position.
2-49

Sunroof (UltraView Plus)
{CAUTION:
People who are in a crash and not wearing a
safety belt properly can suffer much worse
injuries. They can hit things inside the vehicle
or be ejected from it, and be seriously injured
or killed. This is true for any vehicle occupant,
in any motor vehicle, but if you have the
Ultraview roof it is, if anything, even more
important. In a rollover or other crash, the
Ultraview roof can be damaged or destroyed.
People who are unbelted would then be at
even greater risk of being ejected from the
vehicle. Always fasten your safety belt, and
check that your passengers’ belts are fastened
properly too.
Your vehicle may have a single sunroof over the rst
two rows of seats and a smaller sunroof over the
third row seat.The sunroof/sunshade
switches are located in the
headliner between the
driver and front passenger.
With Venting Rear
Sunroof Shown
One switch operates the front sunroof and the another
switch operates the front sunshade. The third switch
is for the rear sunroof and the fourth switch is for
the rear sunshade.
Press the back of the front sunroof switch to open the
front sunroof. If you press the switch to the rst detent the
sunroof will express open to a comfort stop. Press the
switch to the second detent to express open the roof all of
the way. Press the front of the switch to close the sunroof.
The rst detent will close it manually and the second
detent will express close the roof.
2-50

Press the back of the front sunshade switch to open the
front sunshade. Press the front of the switch to close
the sunshade. The sunshade can not be closed further
than the glass panel.
On some vehicles the rear sunroof vents. Press the rear
of the switch to vent the roof. Press the front of the
switch to close it.
Press the back of the rear sunshade switch to open the
rear sunshade. Press the front of the switch to close
the rear sunshade. The sunshade cannot be closed
completely when the glass is open.
Anti-Pinch Feature
If an object is in the path of the sunroof when it is
closing, the anti-pinch feature will detect the object and
stop the sunroof from closing at the point of the
obstruction. The sunroof will then reverse. To close the
sunroof once it has re-opened, remove the obstruction
and press the front of the sunroof switch.
Resynchronization
To resynchronize the front and rear glass and sunshade,
do the following.
1. With the engine running, press and hold the rear
sunroof switch in the open position and the rear
sunshade switch in the close position for six
seconds.
2. Release both buttons.
3. Press the rear sunroof switch in the closed position
until the motor stalls in the closed position.
4. Press the rear sunshade switch in the closed
position until the motor stalls in the closed position.
5. Press and hold the front sunroof switch in the open
position and the front sunshade switch in the close
position for six seconds.
6. Release both buttons.
7. Press the front sunshade switch in the close
position until the motor stalls in the closed position.
8. Press the front sunroof switch in the close position
until the motor stalls in the closed position.
2-51

Vehicle Personalization
Memory Seat and Mirrors
If your vehicle has the memory feature, you can
program and recall memory settings for the driver’s
seating and outside rearview mirror driving positions
for up to two drivers.
The buttons for this feature
are located on the driver’s
door armrest.Use the following steps to program the buttons:
1. Adjust the driver’s seat including the seatback
recliner and both outside mirrors.
2. Press and hold button 1 for at least three seconds.
Two beeps will sound to conrm that the seat and
mirror positions have been saved.
3. Repeat the procedure for a second driver using
button 2.
The vehicle must be in PARK (P) to recall the stored
driving positions.
Press one of the numbered memory buttons to recall
the stored setting. Each time a memory button is
pressed, a single beep will sound.
Three chimes will sound and the setting will not be
recalled if you press button 1 or 2 when the vehicle is
not in PARK (P).
If you would like the stored driving positions to be
recalled when unlocking your vehicle with the remote
keyless entry transmitter or when you place the
key in the ignition, seeDIC Vehicle Personalization
on page 3-73.
2-52