22
29
Safety check
2
For this reason, check the
details in the following sections
before you start the journey:
– Fuel level
– Positions of the handlebar levers
–Brakes
–Brake fluid level
– Clutch fluid level
– Coolant level
– Shock-absorber setting and spring preload
– Wheel rim and tyre condition, tread depth and tyre
pressures
– Load, gross weight
–Lights
– Warning lights and indicator lights with ignition switched
on – Check regularly (every time
you stop for fuel), on the basis
of the following section:
– Engine oil level (every sec- ond/third stop for fuel):
– Brake pads
If you encounter any problems
or difficulties, it is always best to
contact your authorised BMW
motorcycle dealer.
He will provide the necessary
advice and assistance.
Checklist
10k41bkg3.book Seite 29 Donnerstag, 27. Mai 2004 5:30 17
48
Safety check
2
Wheels
Checking tyre pressures
Warning:
Incorrect tyre pressures have
a considerable influence on
handling and on tyre life.
Adjust tyre pressures to suit
total weight. Never exceed ei-
ther the motorcycle's gross
weight or the individual wheel
load limits ( 51).
– When tyres are cold:
• Remove valve caps
• Check/correct tyre pressure Tyre pressures:
Front Rear
O n e - u p 2 . 5 b a r 2 . 9 b a r
(36.3 psi) (42 psi)
Two-up 2.5 bar 2.9 bar
(36.3 psi) (42 psi)
Two-up
with luggage 2.5 bar 2.9 bar (36.3 psi) (42 psi)
• Fully tighten valve caps
Fully tighten valve caps
Warning:
At high road speeds, tyre
valves have a tendency to
open as a result of centrifugal
force.
Use only metal valve caps
with rubber seals.
Valve caps that are screwed
on well prevent air from es-
caping suddenly.
10k41bkg3.book Seite 48 Donnerstag, 27. Mai 2004 5:30 17
22
55
Safety check
2
Headlight basic setting
Note:
Do not prop the motorcycle on
the centre or side stand.
• Check tyre pressures and cor-
rect if necessary.
• Set the spring-strut adjuster to the position for one-up riding
–Make sure lever 2 is horizontal
(neutral position)
• Position the motorcycle on a
level surface 10 metres (33 feet)
(headlight) from a light-coloured
wall, and with the rider's weight
(approx. 85 kg/187 lbs) on the
seat
• Measure the distance H from
the ground to the centre of the
headlight
• Transfer this height H to the wall
and draw a cross on the wall at
this point • Draw a second cross
(x = 10 cm/3.94 in) lower
• Switch on the low-beam headlight
• Turn adjusting screw 1 to
align the headlight in such a
way that the light-dark cutoff
starts in the middle of the bot-
tom cross and rises to the
right to the height of the upper
cross, before dropping again
•Adjusting screw 1: – Turn screw counter-clock-wise: higher
– Turn screw clockwise: lower
Note:
Have the headlight basic set-
ting checked by a specialist
workshop, preferably an
authorised BMW motorcycle
dealer.
Lights
10k41bkg3.book Seite 55 Donnerstag, 27. Mai 2004 5:30 17
3
65
Starting – Riding – Parking
Running in
Running in new brake
pads
Warning:
New brake pads must “bed
down” and therefore do not
achieve their optimum friction
levels during the first 500 km
(300 miles).
This slight initial reduction in
braking efficiency can be
compensated for by exerting
greater pressure on the lever.
Try to avoid all unnecessary
hard braking during this initial
period.
Attention:
Comply with the notes on BMW
Integral ABS ( 74-81).
Running in new tyres
Warning:
New tyres have a smooth sur-
face. This must be roughened
by riding in a restrained man-
ner at various heel angles
until the tyres are run in.
This running in procedure is
essential if the tyres are to
reach their maximum level of
grip.
10k41bkg3.book Seite 65 Donnerstag, 27. Mai 2004 5:30 17
93
Index
i
TTank cap, 4
Telltale and warning lightsABS, 7, 68
Battery charge current, 8
Battery charge light, 69
Coolant temperature, 8, 69
Cruise control, 7
Engine oil pressure, 8, 68
High-beam headlight, 8
Low fuel level, 8, 68
Neutral, 7
Turn indicator, right, 7
Telltale lights Turn indicator, left, 7
Tools, 22
Tread depth, tyres, 47, 48
Troubleshooting ABS, 81
Troubleshooting chart, 81
Turn indicator switch, left, 12
Turn-indicator cancel switch, 13
Tyres Inflation pressure, 48
Running in, 65
WWarning lightsABS, 68
Battery charge light, 69
Coolant temperature, 69
Engine oil pressure, 68
General, 68
Low fuel level, 68
Warnings, braking, 72
T - Z
10k41bkg3.book Seite 93 Donnerstag, 27. Mai 2004 5:30 17
