Page 22 of 130
1-15
E
Do not attempt to modify this watercraft!
Modifications to your watercraft may
reduce safety and reliability, and render
the watercraft unsafe or illegal for use.
Attach the engine shut-off cord (lanyard)
to wrist and keep it free from the handle-
bars so that the engine stops if the opera-
tor falls off. After riding, remove the
engine shut-off cord from the watercraft to
avoid accidental starting or unauthorized
use by children or others.
Scan carefully for swimmers and stay
away from swimming areas. Swimmers
are hard to see and you could acciden-
tally hit someone in the water.
Avoid being hit by another boat! You
should always take the responsibility to
watch for traffic; other boaters may not be
watching for you. If they do not see you,
or you maneuver more quickly than other
boaters expect, you risk a collision.
Maintain a safe distance from other boats
or watercraft, and also watch for boats’ ski
ropes or fishing lines. Obey the “Safe
boating rules,” and be sure to check
behind you before making a turn. (See
Safe boating rules on page 1-19.)
EJU01382
Recommended equipment
The following items should be carried on
board your watercraft:
Sound-signaling device
You should carry a whistle or other sound-
signaling device that can be used to sig-
nal other boats.
Visual distress signals
It is recommended that an authority-
approved pyrotechnic device be stored in
a waterproof container on your watercraft.
A mirror can also be used as an emer-
gency signal. Contact your Yamaha
dealer for more information.
Watch
A watch is helpful so you will know how
long you have been operating.
Towline
A towline can be used to tow a disabled
watercraft in an emergency.
UF1B71.book Page 15 Tuesday, November 12, 2002 4:17 PM
Page 24 of 130
1-17
E
Reverse can be used to slow down or
stop during low-speed maneuvering, such
as when docking. Once the engine is
idling, shift to reverse and gradually
increase engine speed. Make sure that
there are no obstacles or people behind
you before shifting into reverse.
Keep away from the intake grate 1 while
the engine is on. Items such as long hair,
loose clothing, or PFD straps can become
entangled in moving parts resulting in
severe injury or drowning.
Never insert any object into the jet thrust
nozzle 2 while the engine is running.
Severe injury or death could result from
coming in contact with the rotating parts
of the jet pump.
Stop the engine and remove the clip 3
from the engine shut-off switch 4 before
removing any debris or weeds, which may
have collected around the jet intake.
EJU01863
Water-skiing
You can use the watercraft for water-ski-
ing if it has the seating capacity to carry the
operator, a rearward-facing spotter, and the
water-skier when he or she is not skiing.
The watercraft must also have a cleat 1
designed to pull a ski towrope; do not attach
the towrope to any other location.
It is the watercraft operator’s responsibility
to be alert to the safety of the water-skier
and others. Know and follow all local water-
skiing regulations in effect for the waters in
which you will be operating.
The operator should be comfortable car-
rying passengers before attempting to pull a
skier.
The following are some important consid-
erations for minimizing risks while water-ski-
ing.
The skier should wear an approved PFD,
preferably a brightly colored one so boat
operators can see the skier.
The skier should wear protective clothing.
Severe internal injuries can occur if water
is forced into body cavities as a result of
falling into the water. Normal swimwear
does not adequately protect against
forceful water entry into rectum or vagina.
The skier should wear a wetsuit bottom or
clothing that provides equivalent protec-
tion.
UF1B71.book Page 17 Tuesday, November 12, 2002 4:17 PM
Page 25 of 130
1-18
E
A second person should be on board as a
spotter to watch the skier; in many places
it is required by law. Let the skier direct
the operator’s control of speed and direc-
tion with hand signals.
The spotter should sit securely on the
passenger seat and hold onto the hand-
grip 2 with feet firmly on the floor of the
footwell for proper balance while facing to
the rear to watch the skier’s hand signals
and his or her condition. Your control while pulling a skier is
affected by the skier’s ability, as well as
water and weather conditions.
When preparing to pull a skier, operate
the watercraft at the slowest possible
speed until the watercraft is well away
from the skier and slack in the towrope is
taken up. Make sure that the rope is not
looped around anything.
After checking that the skier is ready and
that there is no traffic or other obstacles,
apply enough throttle to raise the skier.
Make smooth, wide turns. The watercraft
is capable of very sharp turns, which
could exceed the abilities of the skier.
Keep the skier at least 50 m (150 ft),
about twice the distance of a standard
towrope, from any potential hazard.
Be alert to the hazard of the towrope han-
dle snapping back at the watercraft when
the skier falls or is unable to get up on the
skis.
Towing heavy or bulky objects other than
skiers, such as another boat or watercraft,
can cause loss of steering control and
create a hazardous condition. If you must
tow another boat in an emergency situa-
tion, operate slowly and cautiously.
UF1B71.book Page 18 Tuesday, November 12, 2002 4:17 PM
Page 28 of 130
2-1
E
EJU01008
Location of main components
1Handlebars
Use to control direction.
2Rear seat
3Front seat
4Footwell
Use to place feet for balance.
To keep proper balance while facing to the rear
to watch the skier.
5Sponsons
6Gunwale
7Bow eye
Use to attach rope for transporting, mooring or
towing the watercraft in an emergency.
8Hood
UF1B71.book Page 1 Tuesday, November 12, 2002 4:17 PM
Page 29 of 130
2-2
E
1Fuel tank filler cap
2Stern eye
Use to attach rope for transporting or mooring.
3Intake grate
Prevents debris from getting into the jet pump.
4Reverse gate
Controls direction of jet thrust when in reverse.
5Ride plate
6Jet thrust nozzle
Changes the direction of jet thrust according
to handlebar position.
7Speed sensor8Stern drain plugs
Use to drain water in the bilge when the water-
craft is on dry land.
9Cleat
Use to attach a towrope for pulling water-skier,
or a rope for mooring the watercraft.
0Handgrip
Use for suppor t when boarding the watercraft
or when seated facing rearward and acting as
a spotter for a water-skier.
AElectric bilge pilot outlet
UF1B71.book Page 2 Tuesday, November 12, 2002 4:17 PM
Page 39 of 130
2-12
E
EJU01877
Shift lever
The shift lever is located on the starboard
(right) side of the watercraft and is used to
control the reverse gate, which allows the
watercraft to move into reverse or forward.
When in the reverse position, the water-
craft can be launched from a trailer, or
backed up out of tight spots where you can-
not turn around easily.
To shift into reverse:
1. Release the throttle, and then let the
engine speed return to idle.
2. Pull the shift lever toward you.
WARNING@ Make sure that the throttle is com-
pletely released and that the engine is
at idle before shifting into reverse.
Do not use the reverse function to
slow down or stop the watercraft as it
could cause you to lose control, be
ejected, or impact the handlebars.
Use reverse for slow-speed maneuver-
ing only.
Make sure that there are no obstacles
or people behind you before shifting
into reverse.
Do not touch the reverse gate while the
shift lever is being operated, otherwise
you could be pinched.
To shift into forward:
1. Release the throttle, and then let the
engine speed return to idle.
2. Push the shift lever away from you.
UF1B71.book Page 12 Tuesday, November 12, 2002 4:17 PM
Page 48 of 130
2-21
E
EJU01796
Glove compartment
A glove compartment 2 is located in front
of the seat.
To open the glove compartment, slide the
latch 1 toward you, and then lift up the lid.
To close the glove compartment, push the
lid down until it locks securely.
NOTE:@ A removable beverage holder 3 is provided
in the glove compartment.
Do not use the beverage holder when oper-
ating the watercraft.
Glove compartment:
Capacity: 10.0 L (2.6 US gal, 2.2 Imp gal)
Load limit: 1.0 kg (2.2 lb)
EJU01797
Seat storage compartment
The seat storage compartment 1 is
located under the rear seat.
To open the seat storage compartment,
remove the rear seat. (See page 2-5 for rear
seat removal and installation procedures.)
Seat storage compartment:
Capacity: 15.0 L (4.0 US gal, 3.3 Imp gal)
Load limit: 9.0 kg (19.8 lb)
UF1B71.book Page 21 Tuesday, November 12, 2002 4:17 PM
Page 85 of 130
3-36
E
EJU01811
Transporting
When transporting the watercraft on a
trailer, secure the tie downs to the trailer
through the bow eye and stern eye.
CAUTION:@ Do not route ropes or tie downs over
the seat, as they may leave permanent
marks on the seat’s surface. Also,
wrap the ropes or tie downs with tow-
els or rags where they touch the body
of the watercraft to avoid scratching or
damage.
Before putting the watercraft on the
trailer or transporting it, be sure to put
the shift lever in the forward position,
otherwise the reverse gate may hit an
obstruction, which may cause dam-
age.
UF1B71.book Page 36 Tuesday, November 12, 2002 4:17 PM
