2003 SUBARU FORESTER remote start

2-14
Keys and doors
Security system (if equipped)
The security system helps to protect your vehicle and
valuables from theft. The horn sounds and the turn
signal lights flash if someone attempts to break into
your vehicle. The starter motor is also interrupted to
prevent starting the vehicle without a key.
The system can be armed and disarmed with the re-
mote transmitter.
The system does not operate when the key is inserted
into the ignition switch.
System operation
The security system will give the following alarm indi-
cations when triggered: The turn signal lights will flash and the horn will
sound intermittently. In addition, the starter motor will
not operate. The alarm automatically resets after 30 seconds;
however, the alarm will reactivate if the vehicle is tam-
pered with again. The alarm will continue for six times
if any sensor continues to be activated.
The alarm is triggered by: Opening a door or the rear gate.
Application of physical shock to the vehicle (e.g. breaking glass or forced entry). Note that there are two
alarm levels for shock: warning and alarm. In warning
mode, the alarm detects lower level vibrations and
triggers 2 warning chirps on the horn and two flashes
on the lights as a deterrent to would be vandals. In
alarm mode, higher levels of shock are detected and
the system will go into full alarm.
Ignition switch being turned on while in armed state.
NOTE
With the valet mode selected, the security system
does not operate when the remote transmitter is
used for locking and unlocking. The security sys-
tem indicator light in the combination meter flash-
es twice per second to show that the valet mode is
selected. For details, refer to “Valet mode” in this section. Arming the system
To arm the system using remote transmitter
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close all doors and the rear gate.

2-16
Keys and doors

To arm the system using power door locking
switches
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors and the rear gate but leave only the
driver’s door or the front passenger’s door open.
6. Push the front side (“LOCK” side) of the power door
locking switch to set the door locks.
7. Close the door. An electronic chirp will sound one
time, the turn signal lights will flash one time and the
indicator light will start flashing slowly (approximately
once every two seconds) to inform you that the system has armed.
NOTE
The system can be armed even if the engine hood,
the windows and/or mo
onroofs are opened. Al-
ways make sure that they are fully closed before
arming the system. Disarming the system
Briefly press the “UNLOCK/DISARM” button (for less
than two seconds) on the remote transmitter. The driv-
er’s door will unlock, an electronic chirp will sound two
times, the turn signal lights will flash two times and the
indicator light will go off.
To unlock all other doors and the rear gate, briefly
press the “UNLOCK/DISARM” button a second time. Emergency disarming
If you cannot disarm the system using the transmitter
(i.e. the transmitter is lost, broken or the transmitter
battery is too weak), you can disarm the system with-
out using the transmitter.
To disarm the system:
1. Unlock the door with the key and then open the
door.
2. The alarm will sound.
6
7
HS2013CB

2-19
Keys and doors
– CONTINUED –
3. Open the doors and get out of the vehicle.
4. Before closing the doors, lock all doors with the in-
side door lock levers.
5. Close the doors. The system will automatically arm
after one minute.
In the passive mode, the system can also be armed
with the remote transmitter or with the power door
locking switches. If the remote transmitter or power
door locking switch is used to lock the vehicle, arming
will take place immediately regardless of whether or
not the passive mode has been selected.
In passive mode, the system will automatically
activate the alarm but WILL NOT automatically
lock the doors. In order to lock the doors you
must either lock them as indicated in step 4
above or with the key once they have been
closed. Failure to lock the doors manually will
result in a higher security risk.
Disarming the system
To disarm the system, briefly press the “UNLOCK/
DISARM” button on the transmitter. Tripped sensor identification
If an electronic chirp sounds four times and the turn
signal lights flash four times when you disarm the sys-
tem, this indicates that the alarm was triggered. The
number of times the indicator light flashes indicates
what sensor caused the alarm condition.
To enter identification mode:
1. Open the driver’s door and leave it open.
2. Turn the ignition switch to the “ON” position two
times. (“LOCK” “ON” “LOCK” “ON” 
“LOCK”)
3. The indicator light will start flashing.
3
5
4
HS2013DB

14-2
Index
A
ABS ................................................................ 7-22
Warning light ...................................... 3-12, 7-23
Accessory power outlet .................................. 6-9
Active head restraint ....................................... 1-7
Air cleaner element ........................................ 11-19
Air filtration system ......................................... 4-18
Aluminum wheel ............................................. 11-44
Aluminum wheel Cleaning .............................. 10-3
Ambient temperature gauge ........................... 3-9
Antenna system ............................................. 5-2
Anti-lock brake warning light (ABS) ........ 3-12, 7-23
Arming the system .......................................... 2-14
Ashtray ........................................................... 6-14
Audio set ........................................................ 5-3
Auto-dimming mirror/compass ....................... 3-29
Automatic/Emergency Locking Retractor
(A/ELR) ....................................................... 1-14
Automatic climate control system .................... 4-10
Automatic transmission .................................. 7-14 Capacities .................................................. 12-4
Fluid ........................................................... 11-24
Selector lever ............................................. 7-15
Shift lock release ....................................... 7-18
Temperature warning (AT OIL TEMP) ....... 3-12 B
Battery ............................................................. 11-49
Jump starting .............................................. 9-9
Replacing (remote keyless entry) . .............. 2-9
Brake
Booster ....................................................... 11-32
Fluid ............................................................ 11-30
Pad and lining ............................................. 11-36
Parking ....................................................... 11-37
Pedal .......................................................... 11-33
System ....................................................... 7-21
Warning light .............................................. 3-13
Braking ............................................................ 7-21
Braking tips ..................................................... 7-21
Brake pedal ..................................................... 11-33 Free play .................................................... 11-33
Reserve distance ........................................ 11-33
Breaking-in of new brake pads and linings ..... 11-36 Bulb Chart ........................................................... 12-9
Replacing ................................................... 11-54
C
Capacities ....................................................... 12-4
Cargo area cover (if equipped) ....................... 6-16
Cargo area light ............................................... 6-2
Cargo tie-down hooks ..................................... 6-18