11 - 4
Maintenance and service
the materials in the vehicle may be hazardous if
improperly used or handled, for example, bat-
tery acid.
Your vehicle should only be serviced by per-
sons fully competent to do so. Serious person-
al injury may result to persons not experienced
in servicing vehicles. Always use the proper tools and make certain
that they are well maintained. Never get under the vehicle supported only
by a jack. Always use a safety stands to sup-
port the vehicle. Never keep the engine running in a poorly
ventilated area, such as a garage or other
closed areas. Do not smoke or allow open flames around
the fuel or battery. This will cause a fire. Because the fuel system is under pressure,
replacement of the fuel filter should be per-
formed only by your SUBARU dealer. Wear adequate eye protection to guard
against getting oil or fluids in your eyes. If
something does get in your eyes, thoroughly
wash them out with clean water. Do not tamper with the wiring of the SRS air-
bag system or seatbelt pretensioner system, or
attempt to take its connectors apart, as that may activate the system or it can render it inop-
erative. The wiring and connectors of these
systems are yellow for easy identification. NEV-
ER use a circuit tester for these wiring.
If your SRS airbag or seatbelt pretensioner
needs service, consult your nearest SUBARU
dealer.
Before checking or servicing in the en-
gine compartment
Always stop the engine and set the parking
brake firmly to prevent the vehicle from mov-
ing. Always let the engine cool down. Engine
parts become very hot when the engine is run-
ning and remain hot for some time after the en-
gine is stopped. Do not spill engine oil, engine coolant, brake
fluid or any other fluid on hot engine compo-
nents. This may cause a fire. Always remove the key from the ignition
switch. When the ignition switch is in the “ON”
position, the cooling fan may operate suddenly
11 - 1 2
Maintenance and service
result in an oil leak.
11.Close the access cover by turning it clockwise and
reinstall the six clips in their original positions.
12.Pour engine oil through the filler neck.
Oil quantity (guideline):
4.2 US qt (4.0 liters, 3.5 Imp qt)
The oil quantity indicated above is only a guideline.
The necessary quantity of oil depends on the quantity
of oil that has been drained. The quantity of drained oil
differs slightly depending on the temperature of the oil
and the time the oil is left flowing out. After pouring oil
into the engine, therefore, you must use the dipstick to
confirm that the level is correct.
13.Start the engine and make sure that no oil leaks ap-
pear around the filter’s rubber seal.
14.Run the engine until it reaches the normal operat-
ing temperature. Then stop the engine and wait a few
minutes to allow the oil drain back. Check the oil level
again and if necessary, add more engine oil.
Recommended grade and viscosity
Oil grade:
API classification SL or SJ with the words “ENER-
GY CONSERVING” (if you cannot obtain the oil
with the SL or SJ grade, you may use SH or SG
grade oil.) or the new API certification mark (Star-
burst mark) displayed on the container.
API Service label
1) Indicates the oil quality by API designations
2) Indicates the SAE oil viscosity grade
3) Indicates that the oil has fuel saving capabilities
APISERVICESL
E
NERGYCONSERVING
SAE
5W µ30
1
2
3
HSB022BB
14-5
Index
J
Jack and jack handle ...................................... 9-19
Jump starting .................................................. 9-9 K
Key interlock release (AT vehicles) ................ 3-4
Keys ............................................................... 2-2 Key
Number ...................................................... 2-2
Reminder chime ........................................ 3-3
L
Leather seat materials .................................... 10-5
Light control switch ......................................... 3-17
Limited slip differential (LSD) .......................... 7-20
Loading your vehicle ...................................... 8-14
Lower and tether anchorages ......................... 1-35
Low fuel warning light ..................................... 3-14
LSD (limited slip differential) ........................... 7-20
Lumbar support .............................................. 1-5 M
Main fuse ........................................................ 11-53
Maintenance Precautions ................................................ 11-3
Schedule .................................................... 11-3 Seatbelt ..................................................... 1-26
Tools .......................................................... 9-19
Malfunction indicator lamp .............................. 3-10
Manual climate control system ........................ 4-4
Manual transmission ...................................... 7-11 Oil .............................................................. 11-22
Map light ......................................................... 6-3
Maximum load limits ....................................... 8-25
Meters and gears ........................................... 3-5
Mirrors ............................................................ 3-29
Moonroof ................................................ 2-26, 9-18 N
New vehicle break-in driving .......................... 8-2 O
Odometer/Trip meter ...................................... 3-5
Off road driving ............................................... 8-7
Oil pressure warning light ............................... 3-11
Oil filter ........................................................... 11-10
Oil level
Engine ....................................................... 11-9
Manual transmission .................................. 11-22
Rear differential ......................................... 11-27
Outside mirrors ............................................... 3-31
Overhead console .......................................... 6-6
