Page 1300 of 1574
9R-2 BODY FRONT ENDMAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
HOOD
1 Hood
2 Sping3 Hood Hinge Assembly
4 Bolt
Page 1301 of 1574
BODY FRONT END 9R-3
Removal & Installation Procedure
1. Remove the hood striker assembly.Notice When installing, tighten the bolt after setting the hole
between wratch and hood striker assembly. Installation Notice
Tightening Toque 8 - 11 Nm
2. Remove the hood Mounting bolt and hood lifter assembly. Installation Notice
3. Remove the hood lock, hood relese from the clip.
4. Remove the cable holder screw.
5. Pull the cable nut toward driver side.
6. Installation should follow the removal procedure in the reverse order.
Tightening Toque 14 - 26 Nm
Page 1302 of 1574
9R-4 BODY FRONT END Adjustment Procedure
1. Alignment between hood striker and latch hole. Loosen the mounting bolt of hood latch slightly and adjust
hood in forward/rearward and left/right directions. Then align the center between hood striker and latch hole.
Notice
Tighten the bolt fully after alignment. Installation Notice
Tightening Toque 13 - 26 Nm
2. Adjusting the height of hood overslam bumper. Unlock the hood and check the clearance between hood and fender by adjusting the hood overslam bumper in left/ right directions.
Normal 20 - 22 Nm
3. Hood Hinge. Loosen the hood lock bolts.
Adjust the lock in forward/rearward and left/right
directions, align with the hood striker and adjust the hood height.
