2003 PEUGEOT BOXER DAG display

PEUGEOT SERVICING
Your vehicle benefits from extended service intervals.
¥ For petrol engines: every 20,000 miles (30 000 km) or every two years.
¥ For dual-fuel Petrol or LPG*/CNG** engines: every 20 000 miles (30 000 km)or every two years.
Warning, LPG/CNG checks every 10,000 miles (15 000 km) or every year.
¥ For direct injection diesel engines: every 12,000 miles (20 000 km) or every two years.
The extension of the service intervals means that the engine oil level must be checked regularly: topping up of the oil between oil changes is normal. This is why the PEUGEOT network is offering you an intermediate service between regular services.
The date of this visit is not shown by the service indicator. It is to be carriedout at least every 10,000 miles (15 000 km) for petrol engines and dual-fuelpetrol or LPG/CNG engines; every 6,000 miles (10 000 km) for direct injectiondiesel engines.
A PEUGEOT dealer will carry out a quick check and top up the levels if necessary (oil, coolant, windscreen wash up to 2 litres). If the oil level is too low there is a risk of serious damage to the engine: check the engine oil level at least every 2,000 to 3,000 miles (3 000 to 5 000 km),depending on the conditions of use. This extended servicing has been made possible by modifications to our vehicles and to the lubricants:
THUS IT IS ESSENTIAL TO ONLY USE ENGINE LUBRICANTS THAT ARE
SUITABLE AND RECOMMENDED BY THE MANUFACTURER.
* Liquid Petroleum Gas.
** Compressed Natural Gas.
PEUGEOT SERVICING
18
SERVICE INDICATOR This informs you of the distance remaining to the service in conformi-ty with the manufacturer's servicingschedule. Operation For a few seconds after the ignition has been switched on, the spannersymbolising a service lights up; thedisplay for the total distance recordertells you the distance remainingbefore your next service.The values displayed by the serviceindicator before the next service arethe following: 20 000 km (petrol:
30 000 km), 2 000 km, 200 km,
100 km and 50 km. Example:2 000 km remain before
the next service is due. When the ignition is switched on and for a fewseconds, the display shows:
17-11-2003

17-11-2003
Zero re-set
Your PEUGEOT dealer carries out this operation after each service.
However, if you carry out the service yourself, the re-set procedure is asfollows: Place the ignition key in the MAR
position (1st notch) and wait until the spanner stops flashing,
 Press the trip recorder re-set but-ton for five seconds.
The distance remaining to the nextservice is displayed.  Press the trip distance recorder zero reset button for five secondsto store the operation in the
memory.
Important: after this operation, if you
wish to disconnect the battery, lockthe vehicle and wait for at least fiveminutes, otherwise the zero re-setwill not be registered. MAINTENANCE OF PARTS SUBJECT TO WEAR
AND A CHECK OF
CONSUMABLES Certain essential components on your vehicle are subject to checks at specific frequencies. ¥ The brake fluid is to be replaced at a maximum of every 36,000/40,000 miles
(60 000 km) or every two years;
¥ The coolant is to be replaced every 72,000/80,000 miles (120 000 km) or
every 5 years;
¥ The passenger compartment filter must be checked at each service
by a PEUGEOT dealer (services and intermediate visits) or more often,
depending on the environment (dust, pollution, etc.);
¥ Replacement of the timing belt: contact a PEUGEOT dealer.
¥ The check on tyre inflation presure must be carried out cold at least once a
month .
PEUGEOT SERVICING 19

17-11-2003
1 -Coolant temperature gauge.
2 - Coolant temperature warning light.
3 - Speedometer.
4 - Left-hand direction indicator.
5 - Side lights and dipped beamheadlamps indicator light.
6 - Main beam headlamps indicatorlight.
7 - Right-hand direction indicator. 8 -
Rev counter.
9 - Low fuel level warning light.
10 - Fuel gauge.
11 - Brake fluid level warning light.
12 - Traction control (ASR) warninglight.
13 - Passenger air bag disarmedwarning light.
14 - Trip distance recorder displaycontrol and zero reset button. 15 -
Front air bags warning light.
16 - Anti-lock braking system (ABS) warning light.
17 - Automatic gearbox temperatureor fault warning light.
18 - Low coolant level warning light.
19 - Service indicator, oil levelgauge, automatic gearbox
display, clock and total distance
recorder.
20 - Diesel engine pre-heatingwarning light.
21 - Engine oil pressure warninglight.
22 - Battery charge warning light.
23 - Clock setting button.
24 - Engine diagnostics warninglight.
25 - Front brake pad wear warninglight.
26 - Handbrake warning light.
27 - Water in diesel filter warninglight.
28 - Electronic immobiliser keywarning light.
INSTRUMENTS AND CONTROLS
28
PETROL-DIESEL MANUAL AND AUTOMATIC GEARBOX
INSTRUMENT PANELS

Low coolant level warning light Illumination of this warning light indicates that the coolant level is too
low.
Stop immediately.
Warning: allow the engine to cool before topping up.
The cooling circuit is pressurised.
To avoid any risk of scalding, unscrew the cap by two turns to allow the pressure
to drop. When the pressure has dropped, remove the cap and top up the level.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS 29
Engine oil pressure warning light This comes on for a few seconds when the ignition is switched on. Illumination of this warning light while the engine is running indicates
that the oil pressure or level is too low.
Stop immediately. If there is a lack of oil in the lubrication circuit, top it up.
Contact a PEUGEOT dealer as soon as possible.
INSTRUMENTS AND CONTROLS
A permanently lit warning light or one that flashes while the engine is running indicates an operating fault. The illumination of certain warninglights may be accompanied by a bleep and a message on the multi-
function display. Do not ignore this warning: contact your PEUGEOT dealer as soon as possible.
Handbrake warning light This comes on for a few seconds when the ignition is
switched on.Illumination of this warning light indi-cates that the handbrake is applied
or has not been released correctly.Coolant temperature warning light This comes on for a few seconds when the ignition is
switched on.Illumination of this warning light indi-cates an abnormal increase in thecoolant temperature.
Stop immediately.
Contact a PEUGEOT dealer.
17-11-2003

17-11-2003
Minimum Check the level with the dipstick and top it up. The figure shown is only correct if the vehicle has been on levelground, with the engine stopped, for10 minutes. Minimum oil level gauge fault Flashing of the segments indicates a fault in the oil level gauge or a lack of oil. There is a risk the engine will be damaged.
Contact a PEUGEOT dealer. Maximum oil level gauge fault Flashing of the squares indicates a fault in the oil level gauge or a surplus of oil. There is a risk the engine will be damaged.
Contact a PEUGEOT dealer.
INSTRUMENTS AND CONTROLS33
Instrument panel display After switching on the ignition, three functions are shown in succession:
Ð service indicator (see correspon-
ding section),
Ð engine oil level indicator,
Ð total distance recorder (total and trip distances).
Engine oil level indicator When the ignition is switched on, the engine oil level is indicated for a fewseconds, after the servicing infor-mation. Maximum Check the level using the dipstick to confirm whether the display is correct;a surplus of oil can cause damage tothe engine.
Contact a PEUGEOT dealer without
delay. Trip recorder zero reset With the ignition on, press the button.Excessive oil level Check the level using the dipstick to confirm whether the display is cor-rect, a surplus of oil can cause dam-age to the engine.
Contact a PEUGEOT dealer without
delay.

17-11-2003
YOUR BOXER IN DETAIL39
Adjusting the bass When "BASS" is displayed, press button Jor Lto vary the setting.
Ð "Ð6" for a minimum bass setting,
Ð "0" for a normal setting,
Ð "+6" for a maximum bass setting.
Adjusting the treble When "TREBLE" is displayed, press button Jor Lto vary the setting.
Ð "Ð6" for a minimum treble setting,
Ð "0" for a normal setting,
Ð "+6" for a maximum treble setting.
Adjusting the front/rear sound distribution (Fader)When "FADER" is displayed, press button Jor L.
Button Jincreases the volume in the front.
Button Lincreases the volume in the rear.
Adjusting the right/left sound distribution (Balance)When "BALANCE" is displayed, press button Jor L.
Button Jincreases the volume on the right-hand side.
Button Lincreases the volume on the left-hand side.
Activation/Deactivation of the loudness (Loud) This function permits automatic accentuation of the bass and treble. Press button Qfor more than two seconds to activate or deactivate the function.
A confirmation bleep is heard, accompanied by the associated message "LOUD ON"or "LOUD OFF" .

17-11-2003
YOUR BOXER IN DETAIL41
Searching for a station occurs first in "SENS LO"sensitivity (selection of the most powerful transmitters) during scanning of
the waveband, then in "SENS DX"sensitivity (selection of the weakest and most distant transmitters).
To make a direct search in "SENS DX"sensitivity, press the "MENU PS" button to access the menu. Then
press button J or Ltwice to display "SENS LO", then button Kor Mto change the sensitivity.
Manual station search Deactivate the PTYand RDS functions by pressing their respective buttons Dand E, if they are active.
Briefly press button Kor Mrespectively to increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous scrolling of the frequency. The scrolling stops at the first station found as soon as the button is released. Manual storing of stations in the memory Select the station required. Press one of the buttons "1"to "6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore)
Press and hold the "BN-AS" button for more than two seconds.
Your radio automatically stores the 6 stations with the strongest signal in FM. These stations are stored in the FMT wave-
band.
If it is not possible to find 6 stations, the remaining memories are empty.
Recalling stations stored in the memory For each waveband, briefly press buttons "1"to"6" to recall the corresponding station.

17-11-2003
YOUR BOXER IN DETAIL
42
Scanning stored stations Press the "MENU-PS" button for more than two seconds. You will then hear each stored station on the select-
ed waveband for approximately ten seconds. If you are interested in a stored station, press the "MENU-PS"
button to stop the scan at this station.
RDS Using the RDS function on FM The RDS (Radio Data System) allows you to continue listening to the same station, whatever frequency it is using for the
region you are going through.
Briefly press the "AF-TA"button to switch the function on or off.
The multi-function display will show: Ð "RDS" if the function is selected.
Ð "RDS greyed out" if the function is selected but not available.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best reception and which is transmitting the same programme.
Traffic information programme Press the "AF-TA"button for more than two seconds to switch the function on or off.
The multi-function display will show: Ð "TA" if the function is selected,
Ð "TA greyed out" if the function is selected but not available.
If the station is able to transmit traffic information, the symbol "TP"is displayed when the TAfunction is active.
Any traffic information flash will be given priority, whatever source you are listening to (radio, cassette or CD).If you wish to interrupt a message, press the "AF-TA"button; this switches the function off.
Note: the volume of traffic information announcements is independent of the volume of normal radio listening. You can adjust it using the volume button. The setting will be stored and will be used when the next messages are broad-cast.