2003 PEUGEOT 807 Owners Manual


 

:

-
. #

-(
: '8
 =

((

=
!

8 &8
 %


"




0
 >

"

>
$#

:!


7
(


&

!

&
8
 *



?
#


>




'


 '8
 '


%
0 '8
 *
((

0
 >



##




!
6
0
 *



>



"


7
8
 %

##

<


#
(
: 8
 &>*'

&8

8
 >
$#
##




!

&&
8
 9!



"


&'
0
 >







&
0
 *
#

##




!
& 8
 



12-05-2003
 


  
  




!"
#$%


&
!'%' Less than a minute after switching
off the ignition, operate the wipersstalk to position the wiper bladesalong the windscreen uprights(maintenance position).


("'
!"
#$  Lift the wiper arm, then disconnectthe windscreen-wash pipe.
 Unclip the blade and remove it.
 Fit the new blade.
 Reconnect the windscreen-washpipe and push back the wiper arm.
'
")"

$%"
!"%
'
"
'"&
!'%'*
% 
'

'
$
'!"

!"%
%+,


""
!"
#$  Lift the wiper arm, then unclip the blade and remove it.
 Fit the new blade and push backthe wiper arm.  - 

.  After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message
/''&0
&'$
1/
appears on the multifunction displayand the active functions are put on
standby.
A flat battery will prevent the engine from starting.

12-05-2003
-
'
"

#"0
)%

#"0
""2– Disconnect the battery,
– Follow the instructions for use given by the battery charger manufacturer,
– Reconnect starting with the negative (–) terminal,
– Check that the terminals and connectors are clean. If they are covered with sulphate (white or greenish deposit), disconnect them and clean them.
'
%"

1
("'&
'"
#"02 – Connect the red cable to the positive (+) terminals of the two batteries,
– Connect one end of the green or black cable to the negative (–) terminal of the slave battery,
– Connect the other end of the green or black cable to an earth point on the bro- ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.

%
$1%#
'
$%'

#"0
(

1
%
'
'
#
)%$
('"

!"'$
'(
&'"

'
&',
 


Ð Before disconnecting
the battery, you must wait for 2 minutes afterswitching off the igni-tion.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð Close the windows and sunroof before disconnecting the battery.If they do not operate normallyfollowing reconnection of the
battery, they must be reintialised(see sections "Electric windows -Safety auto-reverse" and "Sun-roof - Safety auto-reverse".
Ð After every reconnection of the battery, switch on the ignitionand wait 1 minute before starting to allow the electronicsystems to be initialised. If slightdifficulties are experienced after this, please contact a
PEUGEOT dealer.

12-05-2003
 

3
 
-.
4
')
(
5
%
'

"'$6
You should always use a tow bar. The removable towing eye is inside the engine compartment.

"'&

("'2
 Unclip the cover by pressing the bottom part,
 Screw in the removable towing eye until it locks.

"'&

""2  Unclip the top of the cover using a coin,
 Screw in the removable towing eye until it locks.
(
57
%
'

"'$
'06It is preferable to raise the vehicle using professional lifting equipment.
When towing with the engine switched off,there is no braking or
steering assistance.
!
()"%

'(

)'&
"#'8 When being towed with four wheels on the road, it is essential to observethe following rules:
– selector lever in position
,
– tow the vehicle at a speed below 30 mph (50 km/h) over a distance limited to 30 miles (50 km) maxi-mum,
– do not add oil to the gearbox.

12-05-2003
 
 *
4 *

,,,
Only use original PEUGEOT tow bars which have been tested andapproved from the design stage ofyour vehicle. The tow bar must be fitted by a
PEUGEOT dealer.
"1
$1
%"#)'
'(
'$%2
distribute the
load in the trailer so that the heaviest loads are as close as possible to theaxle and the nose weight is close tothe maximum authorised without,
however, exceeding it. ''2
towing a trailer on a slope
increases the coolant temperature.As the fan is electronically controlled, its cooling capacity is not dependenton the engine speed.
On the contrary, use a high gear to lower the engine speed, and reduceyour speed. In all cases, pay attention to the coolant temperature. '2

in certain cases of particularly
arduous use (towing the maximumload up a steep slope in high tem-peratures), the engine automatically
limits its power. In this case, cutting
off the air conditioning allows theengine power to be recovered, andtherefore the towing speed to be sig-nificantly increased (approximately12 mph [20 km/h] more). If the coolant temperature warning light comes on, stop the vehicle and
switch off the engine as soon as pos-sible.
0"%2
check the tyre pressures of the
towing vehicle and of the trailer, observing the recommended pressure. "+%2 towing increases the brak-
ing distance. Drive at a moderate speed, change down early and brake
gradually.
$
$2 sensitivity to side wind is
increased. Drive smoothly and at a moderate speed. 
)
$9)%&Adjust your headlamps so as not to dazzle other road users (see sectionon ''Manual adjustment of head-lamps''). Check the electrical sig-
nalling of the trailer.
)'&
#&
'""'
For vehicles with Xenon bulbs, this system automatically corrects theheight of the beam, whatever the
load of the vehicle. The driver is thenassured of having optimum lightingand not causing a nuisance to otherroad users.
 

:

12-05-2003
 

;
. 



To use the transverse roof bars, release the four locking levers provided for this purpose. From the left-hand side, slide them in their rails to the required notch.
Lock the four locking levers located at the base of the feet of each bar. '2when the roof bars are not in use, position them at the rear stop to avoid
excess consumption.
Use accessories approved by Automobiles PEUGEOT and follow the manufac- turer's fitting instructions.
8&)&
)'"%$

'

"''(
"+
77<
#%,
5
<<
+6 &'1
$
"(
'(

"''(
#"%
– Remove the bolt, the stop and the two washers at each location .
– Move the bars to the locations .
– Lift the two bars to remove them. – &!"12 refit the bolt, the stop
and the two washers at each loca- tion .
To refit, proceed in the reverse order.
"'
'(
)%2

12-05-2003

4
= This video assembly will enable the rear passengers to pass the timepleasantly while watching theirfavourite film or playing theirfavourite game, by means, in partic-
ular, of the connection of a DVDplayer or games console. The rear video kit consists of:
– a 4/3, 6.8 inch, LCD colour monitor,
– two high frequency, wireless, stereo headphones,
– a remote control,
– a base with two wired headphone outputs, a courtesy light with its switch and a monitor release button,
– three audio/video sockets in the glove compartment . The monitor's remote control incor-porates the following controls:
,
"POWER" button to switch the
monitor on/off.
7, "SOURCE" button for selection of
the input source, AV1 or AV2.
>, "SETUP" button for selection of
the settings.
, "VOL " and "VOL " buttons to
change the settings or increase/decrease the volume atthe wired headphones.
, Housing for the two LR03 batteries.
3, "MUTE" button to cut off/restore
the volume at the wired head-phones.
:, "DOMELIGHT" button to switch
the courtesy light on/off remotely.
 

?
The monitor has left/right and up/down position adjustment. It canalso be stored in its base by folding itand pushing it to lock it. Once stored,
the supply, and that of the wireless
headphones, is cut off automaticallyafter approximately fifteen minutes. The rear video kit accepts all types of
audio/video source, PAL/NTSC com-
patible, such as: DVD player, cam-
corder, games console, ... These sources are connected to the three audio/video sockets, 4
*in
the glove compartment only as the
47
sockets are not available.

12-05-2003
 

3<
The various controls are incorporat- ed in the wireless headphones: @Housing for the two LR03 batteries.

@ Headphones on/off button.

@ Headphones volume adjustment
control. To get the best out of theheadphones, you must adjustthem to your own size and adjustthe volume by rotating control .
This video assembly is intended to be operatedand used by the rear pas-
sengers only.
'2
the courtesy light can be con-
trolled directly by means of its switch
in the on or off position or remotelyby means of the remote control in theintermediate position. By pressing buttons and , you can
adjust the brightness, the contrast, the colours, ... For further details, refer to the oper- ating manual "ALPINE video kit".