Page 124 of 184
!& !!&#
*%
!
#/
#
#
#
!& !!"!
*%
!
#
*
!
#
'$& !& !!") #
'
! !
!
!
!0
%#
# (
(
## #
*"%%
#
(
#
# #
" ( ,0120*"
# # ,0120*
Do not cover the rain sensor located at the bottom centre of thewindscreen.
When using an automatic carwash, switch off the ignition orcheck that the wiper control is notin the automatic position. In winter it is advisable to wait for the windscreen to completelyclear of ice before operating theautomatic wipe.
In winter, in the presence of a considerable amountof snow or ice, switch on
the rear screen demister.Once de-icing is com-
plete, remove the snow or icewhich has accumulated on the
rear wiper blade. You can nowoperate the rear windscreen
wiper.
'$& $! !! "!
* %
#
!
# (
#
"
#
%
# &&"#!"!!#!!1
.(#!&(&,,
"!&) #! - /&
3 %#
#
"
! 22'$& !!
"! & /&!22
%
%#
Page 159 of 184
/'"'.$3' '*:
.#)#
# +
02
#
#
%
)
) # )
%)
#
&'$( %
#
#
#
#
% 3
)
#
%
B&
#
)
"''"/07.$$#
2#
3
)
)
C
%
)
)
(
2
)
2
#
(# 2
2
#
2
3
#)
%
)
#
#
For your safety, alwayschange the wheel:
Ð on level, stable, non-slippery ground,
Ð with the handbrake on and the ignition switched off,
Ð with first or reverse gear engaged (position Pfor the
automatic gearbox),
Ð with the vehicle chocked. Never go underneath a vehicle that is supported only by a jack(use a ramp). After changing the wheel:
Ð have the tightening of the bolts and the tyre pressure checked by a PEUGEOT dealer as soonas possible.
Ð have the punctured wheel repaired and refit it to the vehicleas soon as possible.
Ð ask a PEUGEOT dealer to check that the spare wheel is fitted
correctly.
%
#
Page 170 of 184
12-05-2003
!"#$%
&!'%' Less than a minute after switching
off the ignition, operate the wipersstalk to position the wiper bladesalong the windscreen uprights(maintenance position).
("' !"#$ Lift the wiper arm, then disconnectthe windscreen-wash pipe.
Unclip the blade and remove it.
Fit the new blade.
Reconnect the windscreen-washpipe and push back the wiper arm.
' ")" $%" !"%
'"'"&!'%'*% '
' $ '!"
!"%%+,
"" !"#$ Lift the wiper arm, then unclip the blade and remove it.
Fit the new blade and push backthe wiper arm. -
. After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for thirty minutes, to prevent
discharging the battery.
Once the thirty minutes are over, the message
/''&0 &'$ 1/
appears on the multifunction displayand the active functions are put on
standby.
A flat battery will prevent the engine from starting.
Page 171 of 184

12-05-2003
-
'"#"0)%#"0""2– Disconnect the battery,
– Follow the instructions for use given by the battery charger manufacturer,
– Reconnect starting with the negative (–) terminal,
– Check that the terminals and connectors are clean. If they are covered with sulphate (white or greenish deposit), disconnect them and clean them.
'%"1("'&'"#"02 – Connect the red cable to the positive (+) terminals of the two batteries,
– Connect one end of the green or black cable to the negative (–) terminal of the slave battery,
– Connect the other end of the green or black cable to an earth point on the bro- ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
%$1%#'$%'#"0(1%''#)%$('"
!"'$'(&'"'&',
Ð Before disconnecting
the battery, you must wait for 2 minutes afterswitching off the igni-tion.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð Close the windows and sunroof before disconnecting the battery.If they do not operate normallyfollowing reconnection of the
battery, they must be reintialised(see sections "Electric windows -Safety auto-reverse" and "Sun-roof - Safety auto-reverse".
Ð After every reconnection of the battery, switch on the ignitionand wait 1 minute before starting to allow the electronicsystems to be initialised. If slightdifficulties are experienced after this, please contact a
PEUGEOT dealer.