2003 Peugeot 307 CC ignition

22-09-2003
PRACTICAL INFORMATION141
Fuse N¡ Rating
Functions
1 10 A Automatic gearbox reversing lights switch - Automatic gearbox starting inhibitor relay control - Manual gearbox reversing lights switch -
Vehicle speed sensor.
2 15 A Canister solenoid valve - Fuel pump.
3 10 A Power steering control unit - ABS or ESP control unit.
4 10 A Injection control unit - Fan unit relay control - Additional heating relay control -
Automatic gearbox control unit - Automatic gearbox sequential control -
Automatic gearbox shiftlock relay.
5Ð Not used.
6 15 A Front fog lamps.
7Ð Not used.
8 20 A Fan unit relay control - Engine ECU supply.
9 15 A Left-hand dipped beam.
10 15 A Right-hand dipped beam.
11 10 A Right-hand main beam.
12 10 A Left-hand main beam.
13 15 A Horn.
14 10 A Wash-wipe pump.
15 30 A Oxygen sensors - Exhaust gas recirculation solenoid valve - Ignition coil -
Injectors supply.
16 30 A Petrol engine air pump with automatic gearbox.
17 30 A Low/high speed wiper.
18 40 A Air conditioning blower.

22-09-2003
PRACTICAL INFORMATION
142
CHANGING A WINDSCREEN WIPER BLADE Special front windscreen wiper position 
Within one minute of switching
off the ignition, operate thewipers stalk to position the wiperblades in the centre of the wind-screen (maintenance position).
Changing a wiper blade  Lift the wiper arm, then unclip the blade and remove it.
 Fit the new blade and push backthe arm.
Note: the shortest blade is fitted on
the vehicle's right-hand windscreenwiper arm.
To return the windscreen wipers to their normal position, switch onthe ignition and operate the wiperstalk. ECONOMY MODE FUNCTION After the engine has stopped, with the key in the accessories position,
certain functions (windscreen wiper,electric windows, courtesy lights,audio equipment etc.) can only beused for a cumulative duration ofthirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume the use of these functions
immediately, start the engine and letit run for a few seconds. LOAD REDUCTION FUNCTION When driving, certain functions (air conditioning, heated rear screen,
etc.) may be switched off temporari-
ly, depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
A flat battery will preventthe engine from starting.

22-09-2003
PRACTICAL INFORMATION143
BATTERY
To charge the battery using a battery charger:
Ð Disconnect the battery,
Ð Follow the instructions for use given by the battery charger manufacturer,
Ð Reconnect starting with the negative (Ð) terminal,
Ð Check that the terminals and connectors are clean. If they are covered with sul-
phate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery:
Ð Connect the red cable to the positive (+) terminals of the two batteries,
Ð Connect one end of the green or black cable to the negative (Ð) terminal of the slave battery,
Ð Connect the other end of the green or black cable to an earth point on the bro- ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect the cables.
It is advisable to disconnect the battery if the vehicle is not to be used for a period of more than one month.Ð Before disconnectingthe battery, you must wait for 2 minutes afterswitching off the ignition.
Ð Never disconnect a terminal when the engine is running.
Ð Never charge a battery without first disconnecting the terminals.
Ð
Close the windows and retractableroof before disconnecting the bat-
tery. If the windows do not operatenormally following reconnection of
the battery, they must be reini-tialised (see section "Reinitialisationof the electric windows)
.
Ð After every reconnection of the battery, switch on the ignition andwait 1 minute before starting toallow the electronic systems tobe initialised. If slight difficultiesare experienced after this,please contact a PEUGEOT
dealer.

PRACTICAL INFORMATION149
Manual closing of the roof (emergency mode) If the roof opening or closing cycle does not begin or does not function
correctly, check the following points: 
ignition key in position acces- sories or running position (1st or2nd notch),
 the screen must be pulled out,
 the boot must be closed,
 the vehicle speed must be below
6 mph (10 km/h),
 the roof fuse must be in good con-dition (see corresponding section),
 the windows must be initialised(see corresponding section),
 the battery voltage must be suffi-cient (the roof control button indi-cator light must be lit),
 the vehicle must not be subject to"Economy mode active" restric-
tions (see corresponding section),
 the exterior temperature must not
be below Ð20 ¡C.
When carrying out the roof closing operation, take carenot to catch your hands inthe mechanisms.
In the event of an electrical or hydraulic roof malfunction, it is
possible to close the roof manually.
Contact a PEUGEOT dealer to have the system checked. This possibility is a breakdown
solution.Following manual closing of the roof, the boot lid hinges will no longer belocked and the boot will no longer besealed.
Two people are required to carry out this operation. Considerable
force is necessary.  Park the vehicle, if possible on level ground.
 Lower the windows.
 Switch off the ignition.
 Apply the handbrake.
The following two tools are provided in the handbook pocket: Allen TM
key with 5 adaptor Aand
6 adaptor B,
 Torx TM
key with 20 adaptor Cand
30 adaptor D.
22-09-2003