2003 MITSUBISHI SHOGUN air conditioning

H14A059A
Front automatic air
conditioning*
EH14AOH
By setting the blower speed selection dial
and mode selection dial to the“AUT”
(AUTO) position and select the desired
temperature, the air conditioning oper-
ates to cool or warm automatically in order
to maintain the selected temperature. To
stop the air conditioning, set the blower
speed selection dial to the“
”(OFF)
position.
You can also operate it manually if neces-
sary.
The air conditioning can only be oper-
ated while the engine is running.
CAUTION
When using the air conditioning, the
idling speed may slightly increase as
the air conditioning compressor is
switch on/off automatically. Espe-
cially for vehicles with an auto-
matic transmission, while the vehicle
is stationary, fully depress the brake
pedal to prevent the vehicle from
creeping.
H14B104A
NOTE
(1) There is a photo sensor, and interior air
temperature sensor inside the vehicle.
A- Photo sensor
B- Interior air temperature sensor
Never place anything on top of the
cover for these sensors, doing so will
prevent them from functioning prop-
erly.
(2) May slightly increase as the air condi-
tioning compressor is switched on/off
automatically
For pleasant driving
6-43
Div:
Out put date:

H14B069A
H14B107A
Operating the system as an auto-
matic air conditioning
EH14BOH
In normal conditions, use the system in the
“AUT”(AUTO) mode and follow these
procedures:
1- Set the blower speed selection dial to
the“AUT”(AUTO) position.
2- Turn the temperature control dial to set
the desired temperature.
The temperature can be set within a
range of 15 to 29.
The temperature will gradually increase
as the dial is turned to the right.NOTE
(1) Set the temperature, under normal
operating conditions, at around 22.
(2) When the temperature is set to the
highest or the lowest setting under the
AUTO operation, the air selection and
the air conditioning will be automati-
cally changed as follows:
•Quick Heating (When the tempera-
ture is set to the highest setting)
Outside air will be introduced.
•Quick Cooling (When the tempera-
ture is set to the lowest setting)
Inside air will be recirculated and the
air conditioning will operate.
If the air selection is operated manu-
ally after an automatic changeover,
manual operation will be selected.
3- Set the mode selection dial to the“AUT”
(AUTO) position.
The outlet port (except“
”and“
”),
recirculation/outside - air select and blower
speed, and ON/OFF of air conditioning will
be controlled automatically.
For pleasant driving
6-44Div:
Out put date:

H14B128A
Multi centre displayIf your vehicle is equipped with the“Multi
centre display”or the“RV meter”, follow-
ing items are displayed. (Refer to“Multi
centre display”on page 4-27 or“RV meter”
on page 4-40.)
A- Road surface freeze warning symbol
When the outside temperature drops below
about 3°C, the alarm sounds and the road
surface freeze warning symbol (A) flashes
for about 10 seconds.
CAUTION
There is a danger the road might be
frozen even when the symbol (A) is
not illuminated, so please take care
when driving.NOTE
If your vehicle is equipped with“Multi cen-
tre display”, turning the temperature adjust-
ment dial during the period of the alarm will
have no effect on the display.
After completion of the warning, set the
temperature. (Refer to“Outside
temperature”on page 4-28.)
H14B131A
RV meterB- Set temperature display
C- Outside air temperature display
D- Blowe speed indicator
E- Air flow indicator
F- Front defroster indicator
G- AUTO indicator
H- Air selection indicator
(Recirculation of inside air/incoming air
flow outside)
I- Air conditioning operation indicator
For pleasant driving
6-45
Div:
Out put date:

NOTE
The display changes automatically as fol-
lowing.
•Multi center display
The outside air temperature is usually dis-
played for several seconds while the tem-
perature control dial is operated.
•RV meter
When this mode has been displayed
automatically after operation of the air
conditioning, the display will revert to its
previous display after about 10 sec-
onds if no further adjustments are made.Operating the system as a manual
air conditioning
EH14CAF
If you operate the blower speed selection
dial or the mode selection dial as you
desired, the system is still automatically
controlled except selected function which
dial is operated. To return all operations to
automatic operation, set the dials to“AUT”
(AUTO) position.
H14D101A
Change of mode selection
EH14D-W
The mode selection dial is operated
according to the need.
Turn the dial and the air outlet will be
changed.
H14D109A
Multi centre displayIf your vehicle is equipped with the“Multi
centre display”or the“RV meter”, the air
flow indicator (A) is displayed as shown in
the multi centre display. (Refer to“Multi
centre display”on page 4-27 or“RV meter”
on page 4-40)
For pleasant driving
6-46Div:
Out put date:

H14C103A
Multi centre displayIf your vehicle is equipped with“Multi cen-
tre display”or“RV meter”, blower speed
indicator (A) is displayed as shown in the
illustrations, (Refer to“Multi centre display”
on page 4-27 or“RV meter”on page 4-40)
H14C134A
RV meter1- High blower speed
2- Low blower speed
H14C080A
Air conditioning switch
EH13G-Ca
The air conditioning can be operated while
the engine is running.
If this switch is turned to the“AUT”(AUTO)
position, the air conditioning compressor
will start and the indicator lamp (A) will illu-
minate. To stop the air conditioning com-
pressor, press the centre of the dial.
Pressing it once more will start the air con-
ditioning compressor again.
For pleasant driving
6-49
Div:
Out put date:

CAUTION
(1) When using the air condition-
ing, the idling speed may slightly
increase as the air condition-
ing compressor is switched
on/off automatically. Especially
for vehicles with an automatic
transmission, while the vehicle
is stationary, fully depress the
brake pedal to prevent the
vehicle from creeping.
(2) On 3500 models, if a problem is
detected in the air conditioning
compressor, the air condition-
ing operation indicator lamp
blinks. Stop the vehicle in a safe
place, turn off the engine, then
restart the engine. If the air con-
ditioning operation indicator
lamp does not blink, there is no
problem. If it does blink, have it
checked at an authorized MIT-
SUBISHI dealer.
Demisting of the windscreen and
door windows
EH03DOH
CAUTION
For safety, make sure you have a
clear view through all windows.
To remove the frost or mist from the wind-
screen and door windows, use the mode
selection dial (“
”or“
”).
H03D151A
- To keep the windscreen and door
windows clear of mist, and to keep
leg area heating (when driving in rain
or snow).
1- Set the air selection switch (A) to the
outside position.
2- Set the mode selection dial to the“
”
position.
3- Select the desired blower speed by turn-
ing the blower speed selection dial.
4- Select the desired temperature by turn-
ing the temperature control dial.
5- Push the air conditioning switch (B).
For pleasant driving
6-50Div:
Out put date:

H03D152A
- For quick demisting
1- Set the mode selection dial to the“
”
position.
2- Set the blower speed to the maximum
blower speed position.
3- Set the temperature to the maximum
temperature position.
NOTE
(1) While the mode selection dial is set to
the“
”position, the air condition-
ing will operate automatically and the
outside air position will also be selected
automatically. This is done for opti-
mum performance.
(In the case, the air conditioning indi-
cator lamp will not change.)
(2) Do not set the temperature control dial
around the max. cool position. Cool air
will blow against the window glasses
and form mist on them.
H04F099A
Cooling
EH04FAOb
Set the mode selection dial to the“
”
position.
Set the air selection switch (A) to the out-
side position and push the air condition-
ing switch (B).
Adjust the temperature by turning the tem-
perature control dial clockwise or anticlock-
wise. Select the desired blower speed.
NOTE
If the outside air is dusty or otherwise con-
taminated, or if high cooling performance
is desired, set the air selection switch to the
recirculation position and the tempera-
ture control dial all the way to the left.
Switch to the outside position periodically
to increase ventilation so that the win-
dows do not become fogged up.
CAUTION
(1) When using the air condition-
ing, the idling speed may slightly
increase as the air condition-
ing compressor is switched
on/off automatically. Especially
for vehicles with an automatic
transmission, while the vehicle
is stationary, fully depress the
brake pedal to prevent the
vehicle from creeping.
(2) On 3500 models, if a problem is
detected in the air conditioning
compressor, the air condition-
ing operation indicator lamp
blinks. Stop the vehicle in a safe
place, turn off the engine, then
restart the engine. If the air con-
ditioning operation indicator
lamp does not blink, there is no
problem. If it does blink, have it
checked at an authorized MIT-
SUBISHI dealer.
For pleasant driving
6-51
Div:
Out put date:

H14F020A
To stop the air conditioning
EH14F-G
By setting the blower speed selection dial
to the“
”(OFF) position.
All operations will stop except the change
of air selection.
H18A091G
Rear heater* /
Rear air conditioning*
EH18A-Z
The rear heater/air conditioning can be
operated when the ignition switch is at the
“ON”position.
1- Main switch
2- Blower speed selection dial
3- Temperature control dial
For pleasant driving
6-52Div:
Out put date: