Page 216 of 321
216 OperationMaintenanceThe Mercedes-Benz Light Truck Center will
reset the service indicator following a com-
pleted service.Calling up the service indicator
Within 1 second press knob1 twice.
The FSS display will appear for ten sec-
onds.
Resetting the service indicator
In the event that the service on your vehi-
cle is not carried out by an authorized Mer-
cedes-Benz Light Truck Center, you can
reset the service indicator yourself.
Switch ignition on and immediately
press knob1 twice within one second.
The present status for days or distance
is displayed.
Within ten seconds turn the key in
steering lock to position0 (
page 33).
Press and hold knob1 while switching
the ignition on.
The present status for days or distance
is displayed once more.
Continue to hold knob1.
After approximately 10 seconds a sig-
nal sounds, and the display shows
10 000 miles (Canada: 15 000 km) for
approximately 10 seconds.
Release knob1.
iIf the service indicator was inadvertent-
ly reset, have a Mercedes-Benz Light
Truck Center correct it.
Only reset if the proper service has
been performed. Resetting the system
without performing the proper service
as called for by the FSS will cause the
FSS to incorrectly determine the next
service interval which will result in en-
gine damage not covered by the Mer-
cedes-Benz Limited Warranty.
If the battery is disconnected, the days
of disconnection will not be included in
the count shown by the service indica-
tor. To arrive at the true service dead-
line, you will need to subtract these
days from the days shown in the ser-
vice indicator.
Do not confuse the service indicator
with the engine oil level indicator
:
.
Page 226 of 321
226 Practical hintsWhat to do if …¿
The yellow malfunction indicator
lamp comes on while driving.
The BAS or ESP is malfunctioning.
It is possible that the engine output will be re-
duced.
Have the BAS/ESP checked at an au-
thorized Mercedes-Benz Light Truck
Center as soon as possible.
{
The yellow malfunction indicator
lamp comes on while driving.
4-ETS has switched off to prevent overheat-
ing of the brakes. Also see 4-ETS/ESP warn-
ing lamp (
page 224).
As soon as the brakes have cooled off,
4-ETS switches on again.
The indicator lamp goes out.
4-ETS is malfunctioning and has switched off.
Have the 4-ETS checked at your au-
thorized Mercedes-Benz Light Truck
Center as soon as possible.
ê
The yellow LOW RANGE indicator
lamp blinks after one or more
switching conditions.
The gear selection conditions have not been
adhered to.
Repeat the gear selection process
(page 118).
ê
The yellow LOW RANGE indicator
lamp blinks after switching the
ignition on.
LOW RANGE mode is malfunctioning.
Have the LOW RANGE mode checked at
your authorized Mercedes-Benz Light
Truck Center.
Problem
Possible cause
Suggested solution
Page 229 of 321
229 Practical hints
What to do if …
Problem
Possible cause
Suggested solution
É
-
The red brake warning lamp
lights up in addition to the yellow
ABS malfunction lamp and you
hear a warning sound.
There is a malfunction in the Electronic Brake
Proportioning (EBP) system.
The enhanced braking effect is not available.
Have the system checked immediate-
ly at an authorized Mercedes-Benz
Light Truck Center.
Failure to follow these instructions in-
creases the risk of accidents.
:
The yellow warning lamp blinks
after starting the engine or while
driving.
The engine oil level has sunk to the minimum
level. If the engine oil level continues to sink,
the warning lamp will light up.
Add approved oil at the next gas sta-
tion (
page 286).
If oil loss is visible on the engine, have
the malfunction corrected as soon as
possible at a Mercedes-Benz Light
Truck Center.
_
The red indicator lamp does not
go out after starting the engine.
The adjustable telescoping steering column
is not properly locked.
Lock the adjustable steering column
(page 37).
‡
The green front fog lamp indica-
tor lamp lights up when ignition
is turned on.
The front fog lamps are switched on.
Fog lamps (
page 105).
Page 232 of 321
232 Practical hintsWhat to do if …Problem
Possible cause
Suggested solution
?
The yellow “CHECK ENGINE”
malfunction indicator lamp
comes on while driving.
There is a malfunction of:
The fuel management system
The ignition system
The emission control system
Systems which affect emissions
Such malfunctions may result in excessive
emissions values and may switch the engine
to its limp-home (emergency operation)
mode.
Have the vehicle checked as soon as
possible by an authorized
Mercedes-Benz Light Truck Center.
An on-board diagnostic connector is
used by the service station to link the
vehicle to the shop diagnostics sys-
tem. It allows the accurate identifica-
tion of system malfunctions through
the readout of diagnostic trouble
codes. It is located in the front left
area of the footwell next to the park-
ing brake pedal.
The fuel cap is not closed tightly.
Check the fuel cap (
page 200).
Your fuel tank is empty.
After refuelling start the engine three
or four times in succession.
The limp-home mode is canceled. You do
not need to have your vehicle checked.
7
The indicator lamp lights up.
A BabySmart
TM child seat is installed on the
front passenger seat. The front passenger
airbag is therefore switched off.
The system is malfunctioning when there is
no BabySmart
TM child seat installed on the
front passenger seat.
Have the system checked as soon as
possible by an authorized
Mercedes-Benz Light Truck Center.
Page 307 of 321
307 Index
Headlamps
Automatic control 103
Bi-Xenon 293
Cleaning 220
Cleaning system 121
Cleaning system* 208
Refilling washer fluid 208
Switching off 51
Switching on 46
Washer fluid 290
Washer system 290
Headliner
Cleaning 221
Heated seats 91
Height adjustment
Head restraints 36, 37
Seat belts 43
Steering wheel 37
High beam flasher 47, 102
High beam headlamps
Replacing bulbs 247, 250
Switching on 102
High mounted brake lamp 248
Replacing bulbs 252Hood 202
Closing 203
Opening 202
Hooks
Loading 140
Hydroplaning 183
I
Identification labels 276
Certification label 276
Vehicle identification number
(VIN) 276
Ignition 33
Immobilizer 78
Activating 51, 78
Deactivating 78
Indicator lamp
Adjustable steering column 229
Brake pad wear 234
Coolant 230
Front fog lamps 229
Low engine oil level 229
Indicators, additional
Speedometer display 235
Infant and child restraint systems 63
Installing 67
LATCH child seat mounts 68Inflating
Spare tire 259
Information
About service and warranty 10
Button for Tele Aid* 165
Inside rear view mirror
Antiglare 119
Installing
Head restraint 92
Infant and child restraint systems 67
Wiper blades 254
Instrument cluster 24, 110, 294
Cleaning 221
Coolant temperature gauge 111
Display in the speedometer 111
Illumination 110
Lamps in 233
Outside temperature indicator 112
Instruments and controls see Cockpit 22
Integrated remote control
Canadian programming 171
Erasing memory 171
Hand-held transmitter 169
Operating 171
Rolling code programming 170