Page 52 of 88
3
50
Starting – Riding – Parking
Placing motorcycle on
side stand
d Warning:
For safety reasons, never sit
on the motorcycle with the
side stand extended.
e Attention:
Stop the engine before using
the side stand.
Make sure the surface under
the stand is firm. On a gradient,
the motorcycle should always
face uphill; select 1st gear. • Switch off the ignition
Keep both feet on the ground
Hold the left handlebar grip
with your left hand
Keep your right hand on the
right handlebar grip and the
handbrake lever
Hold the motorcycle upright and balanced
U s e y o u r le f t f o o t a t t h e e x t e n -
sion pin to extend the side
stand fully (arrow)
Slowly lean the motorcycle to the side until its weight is
taken by the stand and dis-
mount from the motorcycle
Turn the handlebars to full left
lock (
b9)
Check that the motorcycle
is firmly supported
Side stand
10r1303g4.fm Seite 50 Dienstag, 30. September 2003 1:50 13
Page 53 of 88
3
51
Starting – Riding – ParkingRemoving motorcycle
from side stand
d Warning:
Make sure the side stand is
fully retracted before you ride
off.
– Allowing the motorcycle to roll with the side stand
extended represents a
safety risk.
Turn the ignition key to the "R " or " ON" position (
b9)
– Handlebars unlocked Both feet on the ground, no
weight on the motorcycle
Hold the left handlebar grip
with your left hand
Keep your right hand on the
right handlebar grip and the
handbrake lever
Slowly raise the motorcycle to
the upright position and keep
it balanced
Sit on the motorcycle and use your left foot to retract the
side stand
Side stand
10R13bkg4.book Seite 51 Montag, 22. September 2003 4:26 16
Page 54 of 88
3
52
Starting – Riding – ParkingPlacing motorcycle on
main (centre) stand
d Warning:
For safety reasons, never sit
on the motorcycle with the
main stand extended.
e Attention:
Stop the engine before using
the main stand.
Make sure the surface under
the stand is firm. Switch off the ignition
Hold the left handlebar grip
with your left hand
Hold the lifting handle with
your right hand
Place your right foot on the pin of the main stand, and
press the stand down until
both its curved feet touch the
ground
Apply all your body weight to the pin of the stand
Pull the motorcycle to the rear and upwards (arrow) until it
rests on the main stand
Check that the motorcycle
is firmly supported
Main (centre) stand
10R13bkg4.book Seite 52 Montag, 22. September 2003 4:26 16
Page 55 of 88
3
53
Starting – Riding – Parking
Removing motorcycle
from main stand
e Attention:
Make sure the main stand is ful-
ly retracted before you ride off.
• Turn the ignition key to the "R " or " ON" position (
b9)
– Handlebars unlocked
Hold the left handlebar grip
with your left hand
Hold the lifting handle with
your right hand
Push the motorcycle forward
off the main stand Check that the main stand
has fully retracted
Main (centre) stand
10r1303g4.fm Seite 53 Dienstag, 30. September 2003 1:51 13
Page 58 of 88
3
56
Starting – Riding – Parking
1
Switch on the ignition– Engine stop switch 1 in the
operating position
U
Ignition switch ON (b9)
Wait until the warning light for coolant temperature (
b7)
stops flashing
In an emergency only:
Move the kill switch 1 to posi-
tion
V
– The electronic engine man- agement, fuel pump and
starter motor electrical cir-
cuits are de-energised
Fully retract the side stand
L Note:
If the side stand is extended
and a gear engaged, you can-
not start the motorcycle.
Select neutral– Neutral indicator light
green
k (b7) ON
L Note:
Engine does not start:
– Move the gear lever to the
k
position or disengage the
clutch
Engine stops when first gear is
engaged:
– Fully retract the side stand; if necessary, consult the trou-
bleshooting chart
(
b Maintenance Instructions,
Chapter 1)
Before you start
10R13bkg4.book Seite 56 Montag, 22. September 2003 4:26 16
Page 59 of 88

3
57
Starting – Riding – Parking
Starting Press starter button2 (max.
5 seconds) and do not
release it until the engine is
running smoothly
Do not turn the throttle twist- grip when starting the engine.
L Note:
After releasing the starter but-
ton if the engine does not start,
wait at least 5 seconds before
pressing the starter button
again.
After switching off the ignition,
wait 3 seconds before switch-
ing it on again.
e Attention:
If you attempt to start the en-
gine when the battery is flat, you
will hear the relay chattering.
Further attempts will damage
the starter relay and starter mo-
tor.
Before trying again: recharge
the battery.
L Note:
At ambient temperatures below
0 °C (32 °F), pull the lever to
disengage the clutch when
starting the engine.
e Attention:
Do not allow the engine to idle
unnecessarily or for prolonged
periods of time – risk of over-
heating or fire. Ride away im-
mediately after starting the en-
gine.
Avoid high engine speeds after
a cold start.
Starting
2
10R13bkg4.book Seite 57 Montag, 22. September 2003 4:26 16
Page 60 of 88
3
58
Starting – Riding – Parking
ABS indicator light– ABS warning light1
(
b 64-69)
Coolant temperatureWarning light 2 j (red) flashes
for approx. 3 seconds after you
switch on the ignition.
The electronic engine manage-
ment system initialises itself
during this period.
e Attention:
If the coolant-temperature
warning light
j comes on,
switch off the engine and allow
it to cool down.
Check coolant level in the
expansion tank (
b43).
If the expansion tank is full, but
the warning light remains on, or
if coolant consumption is ex-
cessive, consult a specialist
workshop, preferably your au-
thorised BMW motorcycle deal-
er.
Telltale and warning lights
12
10R13bkg4.book Seite 58 Montag, 22. September 2003 4:26 16
Page 67 of 88
3
65
Starting – Riding – Parking
d Warning:
Do not operate high-power
radio equipment on the mo-
torcycle. There is a slight risk
of it affecting operation of the
ABS.
ABS checkStart-up is automatic when the
ignition is switched on.
Warning light 1 comes on.
ABS self-diagnosis
When you start the engine and
pull away:
– Warning light 1 goes out if the
ABS is in correct working
order
OEOptional extra
ABS faults– ABS warning light 1 remains
on:
the ABS function is not availa-
ble
e Attention:
If the fault cannot be rectified,
immediately consult a specialist
workshop, preferably an
authorised BMW motorcycle
dealer.
Anti-lock braking system (ABS)OE
1
10R13bkg4.book Seite 65 Montag, 22. September 2003 4:26 16