2003 ASTON MARTIN DB AR1 Q warning

F - Owner Maintenance
1-F-38
Fuse Boxes
Three fuse/relay boxes are fitted to DB AR1 containing the fuses to protect
electrical and electronic systems of the vehicle. The box locations are
indicated on the diagram above.
The forward left and right fuse boxes are located beneath a plate in the
passenger side footwell. The rear fuse box is located in the boot, close to the
battery.
WARNING: Do not add to or alter the electrical systems of DB AR1 unless fitting
Aston Martin approved options to the manufacturers instructions. Use of
unapproved components, incorrect dismantling, incorrect reassembly or incorrect
replacement of components may create electrical overloads and a fire risk.
WARNING: Do not attempt to repair a blown fuse. This could cause a fire hazard
or serious damage elsewhere in the electrical circuits.
WARNING: Do not install a fuse which exceeds the amperage for each location
listed on the following fuse charts.

F - Owner Maintenance
1-F-55 Aston Martin recommends the use of 'AUTOGLYM' car care products or
preparations of similar reputable manufacture for adding to the washing
water. The use of mild 'detergents' as directed by the manufacturers will also
help. When dust and mud have been removed with a hose brush and water,
finally dry with a chamois leather, which should be rinsed regularly in clean
water.
WARNING: Washing and polishing agents containing silicone should not be
applied to glass. This will reduce the efficiency of the windscreen wipers, causing
smears which will reduce visibility, particularly during darkness and in the rain.
During the winter months, it is advisable to wash the car more frequently,
paying particular attention to the underside to combat the detrimental
effects of any salt and sand contamination picked up from treated roads.
Polishing
Approximately twice a year, a good quality polish should be applied and
then buffed, using a soft lint-free cloth.
Alloy wheel rims should be treated with a cleaner which is specifically
manufactured for this purpose.

F - Owner Maintenance
1-F-56
Upholstery, Carpets and Seats
The seats and soft trimmed components of DB AR1 are covered in Natural
Leather Hide and Alcantara. The Natural Leather Hide is supplied by Bridge
of Weir, Scotland.
In general, this natural leather upholstery requires little attention. The seats
should be brushed with a soft brush from time to time and may be cleaned
occasionally with a cloth damped in soap and water. DO NOT use
detergents, quick cleansers or furniture polishes.
Several times a year, a leather conditioner or preservative should be used.
Appropriate care materials are contained in the 'Bridge of Weir Leather Care
Kit', obtainable from your Aston Martin Dealer.
Alcantara trim and seat panels may be brushed with a soft brush. Stains from
water based substances such as coffee, tea or soft drinks should be cleaned
as soon as possible with mild soap and water. Please consult your dealer for
instructions on the removal of more difficult stains such as oil, grease or
ballpoint Ink.
Carpets should be cleaned regularly with a vacuum cleaner. Any stains or
grease marks should be removed with a good quality solvent suitable for use
on carpets.
WARNING: Fumes from cleaning solvents may be dangerous in confined spaces.
Make sure that the car is well ventilated and follow the manufacturer's printed
instructions when using these products.

F - Owner Maintenance
1-F-57
Care and Maintenance of Seat Belts
To ensure that they are in proper working order, regularly check the seat
belts. Look for fraying, cuts, burns and similar problems. Ensure that the
latches and buckles function correctly. If a belt is not in good condition or
is not working properly, consult your Aston Martin Dealer.
Any belt that has been worn during a serious collision should be replaced
by an Aston Martin dealer.
To clean the belts, use mild soap and water; do not use bleach, solvents or
dyes as they can weaken the material. Allow the belts to dry before use.
WARNING: In the interest of safety, do not allow seat belts to be retracted until
completely dry.
Underbonnet Cleaning
Underbonnet cleaning using high pressure hoses or steam cleaners should
not be done. The electronic control modules and fuse boxes will be
damaged by indiscriminate use of high pressure cleaning equipment.
Aerial Care
Regular cleaning with a special aerial cleaner will ensure smooth and reliable
operation of the aerial.
Always wipe the aerial in an upwards direction
Lubricate using an aerial maintenance wipe cloth.
In freezing conditions, check that no ice has formed over the top of the
aerial, which could prevent it being raised and cause damage to the motor.

F - Owner Maintenance
1-F-60
Recommissioning After Storage
Provided that the car has been stored in accordance with the recommended
procedure, the following points only should require attention before using
the car on the road.
Check the tyre pressures, inflate if necessary and lower the car to the ground.
Fully charge and refit the battery. Reset the clock and electric windows.
Drain the engine sump and final drive unit, fit a new engine oil filter element,
then refill with the approved oils. Check the coolant level and if necessary
top up with the correct antifreeze/water solution.
Check all fluid levels and top-up as necessary. Fill the fuel tank
Caution: Starting the engine without sufficient lubrication can cause serious engine
damage. Take care to establish engine oil pressure as directed in the following steps
before allowing the engine to start.
Press and hold the accelerator hard to the floor (kickdown switch actuated).
This will temporarily inhibit the fuel injectors during cranking. Turn on the
ignition. Press and hold the starter button to crank the engine until normal
oil pressure is indicated on the oil pressure gauge. Release the starter button
and the accelerator pedal.
Start the engine normally and check that the oil pressure and ignition
warning lights go out as the engine starts indicating correct oil pressure and
battery charging. Raise the bonnet and check for leaks of fuel, oil and
coolant.
Finally, check the operation of all instruments, lights and accessories.

F - Owner Maintenance
1-F-61 Carefully test drive the vehicle and check the operation of all functions.
WARNING: Braking performance can be impaired initially due to a fine film of
corrosion on the brake discs. Drive conservatively and, when safe to do so,
frequently apply the brakes until the discs have been deglazed. Full braking
performance should then be restored.

G - Specifications
1-G-6
Wheels and Tyres
Normal Use
Unique Aston Martin 5 spoke aluminium alloy wheels, 8Jx18 front and
9Jx18 rear.
Front - Pirelli P Zero Rosso 225/40/18
Rear - Pirelli P Zero Rosso 275/35/18
Tyre Grade Spec. USA - Treadwear 140, Traction A, Temperature A.
Tyre Pressure:
Front and Rear: 2.7 bar 270 kPa 39 psi
Spare Wheel (if fitted)
115/85 R18
Tyre Pressure: 4.1 bar 414 kPa 60psi
Winter Wheels and Tyres
WARNING: Maximum speed with winter tyres is 210 kph (130 mph)
Four standard DB AR1 front wheels (8J x 18). Fitted with Pirelli 235/40
Winter 210 tyres.
This wheel tyre combination should be fitted to both axles and may be fitted
with DB AR1 snow chains.
Winter Tyre Pressures: 2.5 bar 250kPa 37psi

2-A-5
A - Service Schedules
Pre-delivery Inspection (PDI)
Before you receive your DB AR1, it will undergo a comprehensive pre-
delivery inspection at the Dealer's premises to ensure that it meets Aston
Martin's quality standards. The following checks will be made:
Levels and Leaks
Engine oil
Power steering oil
Brake Fluid
Clutch fluid (manual only)
Engine coolant level
Engine coolant specific gravity
Windscreen washer fluid
Fuel system
Gearbox oil/Auto transmission fluid
Rear axle oil - Differential
Battery
Mechanical Functions
Auto transmission
Selection and P & N functions
Manual gear selection
Clutch operation (manual only)
Throttle pedal operation
Parking brake operation
Steering column adjustment and lock
operation
Seat adjuster rails
Bonnet (Hood) release and catch
Door operation and locks
Storage compartments
Rear view mirror
Wheels and Tyres
Road wheel nuts
Tyre pressures
Front wheel tracking
Electrical Checks
Battery condition
Heated windscreen
Windscreen washers
Windscreen wipers
Air-conditioning controls
Gauges and warning lights
Radio/Cassette/CD player
Navigation (where fitted)
All speakers
Electric aerial
Inertia switch
Window mechanisms
Side and headlights (main and dip)
Front fog lights
Rear fog lights (where fitted)
Hazard warning lights
Instrument illumination and dimmer
Air conditioning panel illumination
Auto Trans. PRNDL illumination
Horns
Interior/map lights
Cigar lighter
Seat adjustment - all functions
Door mirror adjustments
Reset clock (if necessary)
Door / boot courtesy lights
Central locking system
Filler flap lock operation
Seat belt operation
Seat belt warning system
Security system / Remote control
Clutch pedal start inhibit
Interrogate DTC codes (not N.
America)
Record battery open-circuit voltage