2003 ASTON MARTIN DB AR1 Q airbag

A - Before Driving
1-A-1
Contents
Vehicle Keys ....................................................................................... 1-A-2
The Security System and Door Locks .................................................. 1-A-3
Rain Cover ......................................................................................... 1-A-7
Adjustments Before Driving .............................................................. 1-A-10
Seat Belts .......................................................................................... 1-A-14
Airbags............................................................................................. 1-A-20
Interior Storage ................................................................................. 1-A-22

A - Before Driving
1-A-15 Pull upwards on the diagonal belt to ensure secure latching and to remove
all slack from the belt. Finally, double check that the lap belt is fitted snugly,
low down across the hips, and that there are no twists.
If it is necessary for an occupant to adjust their seat or seating position during
a journey, the belt tension might be disturbed. The occupant should
therefore (as soon as it is safe to do so) gently pull down the shoulder run of
the seat belt to create some slack and then immediately release it to re-
tension the belt for the new seating position.
Seat Belt Pretensioner
The seat belt pretensioner system is designed to hold vehicle occupants
against the seat back when a frontal collision occurs.
The seat belt pretensioner system works in conjunction with the airbag
system. In a serious frontal impact, as the airbags are triggered, the
pretensioners will also be triggered. These apply additional tension to the
front seat belts to hold the front seat occupants back in their seats.
Automatic Locking Retractors (ALR)
All vehicles are fitted with an ALR seat belt in the front passenger seat.
This system is designed to securely hold child seats. The ALR system
temporarily locks the belt securing the child seat.
Securing a Child Seat (ALR System)
Fit the child seat following the manufacturers instructions. Gently pull out
the relevant inertia reel seat belt until fully extended. The ALR system will
only engage at the maximum extension point of the seat belt.

A - Before Driving
1-A-16Thread the belt tongue through the child seat as instructed by the
manufacturer. Engage the tongue into the belt buckle. Adjust the tongue
position on the belt if necessary to ensure that the lower belt run is tight and
then allow the upper run of the seat belt to fully retract until the child seat
is securely held. The ALR system will be heard 'clicking' as the seat belt
retracts. When fully retracted, pull down on the upper run of the belt to
check that the ALR lock has engaged.
Child Seat Removal (ALR System)
To remove the child seat, release the belt as normal and allow it to retract
through the seat frame. The ALR system will disengage when the belt is fully
retracted. The belt may then be worn when required as a normal inertia reel
belt. Once the ALR is disengaged, the belt must be fully extended to re-
engage the system on the next occasion that a child seat is fitted.
WARNINGS - Seat Belts - General
Wearing your seat belt is crucial to your safety. Not wearing a seat belt increases
the chance of serious injury or death in the event of an accident. Be sure that you
and your passengers always fasten their seat belts and use them properly even
though airbags are provided. Seat belt usage is mandatory in most countries and
should be used in accordance with local laws.
By reclining the seat back, you decrease the protection you get from the seat belt
in the event of a crash. Adjust the seat back to an upright position (approximately
90° to the seat base.
Make sure that the seat back is locked in place. Otherwise it could move forward
in a sudden stop or crash and cause injury.

A - Before Driving
1-A-20
12
SECS
CHILD SEATS AND PASSENGER AIRBAGS
DO NOT install a rearward facing child seat in the front passenger seat position.
If a front seat position must be employed, use only a forward facing child seat
with the passenger seat set as far rearwards as practical.
Airbags
In order to provide optimum occupant protection the DB AR1 is equipped
with a driver airbag mounted in the centre of the steering wheel and front
passenger airbag located in the fascia panel immediately in front of the
passenger seat. The airbags are supplementary to the seat belts.
Note: There are important airbag safety labels on the sun visors (illustrated
below).

A - Before Driving
1-A-21
Some models may have additional safety labels elsewhere, easily visible to the
vehicle occupants. Ensure that you have read and complied with the instructions
on these labels prior to driving the vehicle.
Do not change or modify or tamper with the steering wheel, passenger side
fascia or any other part of the airbag system. Such actions could disable the
system or cause inadvertent inflation.
The airbags are designed to deploy only in a serious frontal collision. Their
purpose is to provide additional protection for the front seat occupants if
thrown forwards in an accident. The system is designed so that it will not
deploy in the event of trivial frontal impacts such as minor contacts when
parking. The airbag system is not designed to protect against side or rear
impacts.
WARNINGS:
No objects whatsoever should be attached to the centre cover of the steering
wheel or the passenger fascia panel. Such objects could cause harm if the vehicle
is in a crash severe enough to cause the airbags to deploy.
All occupants, including the driver, should always wear seat belts, whether or not
an airbag is provided , to decrease the risk of injury or death in the event of a crash
CHILD SEATS AND PASSENGER AIRBAGS
DO NOT install a rearward facing child seat in the front passenger seat position.
If a front seat position must be employed, use only a forward facing child seat
with the passenger seat set as far rearwards as practical.
Any work on the airbag system must only be done by an Aston Martin Dealer.

B - Controls
1-B-8
SRS (Supplementary Restraint System) (Amber)
Flashes if a fault is detected in the airbag system.
When you start the car, this lamp comes on for a few seconds
as a readiness indicator. If it does not come on when you start
the car, or if it does not go off after a few seconds, or if it comes
on whilst driving, the airbag system has detected a fault. Consult
your Dealer immediately if this light illuminates.
Frost Warning Lamp (Amber)
This lamp will illuminate if the external temperature falls to
+4°C. At or below this temperature there is an increased risk of
frost on the road surface.
Traction Control Warning (Green)
Traction control is normally on. This lamp illuminates if the
system is switched off. The lamp flashes when traction control
is active. See the traction control description in this section.
Sport (Auto transmission only) (Green)
Indicates that Sport Mode is selected, increasing the engine
speeds at which the automatic transmission changes gear.
Left Turn Direction Indicator (Green)
Flashes with the indicator lights during operation of the left turn
signal or hazard warning lights.
Right Turn Direction Indicator (Green)
Flashes with the indicator lights during operation of the right turn
signal or the hazard warning lights.

C - Driving
1-C-6
Warning Light Indications at Ignition On
As the ignition is switched on, the DB AR1 electronic control units each
complete a self check to ensure correct operation. During these checks, the
warning lights on the instrument panel will illuminate as follows:
• Bulb Check - All warning lamps illuminate for about three seconds as a
bulb check. (The Sport and Transmission Fail lamps are not illuminated
on manual transmission vehicles).
• The Ignition and Oil Pressure warning lights illuminate until the engine
starts.
• The Check Engine light will illuminate during the engine management
self-check and will extinguish when the starter button is pressed.
• The Seat Belt warning light illuminates and a gong sounds for six seconds
if the driver's seat belt is not fastened. On fastening the seat belt, the gong
immediately ceases. The warning lamp extinguishes at the end of the six
second warning period.
• The ABS and Traction Control warning lights illuminate and extinguish
if the system self checks are satisfactory.
• The Brake warning light will illuminate and extinguish if the brake fluid
level is within specification.
• The SRS Airbag warning light will illuminate and extinguish if the SRS
Airbag control system check is satisfactory.
Only the handbrake (parking brake) warning light should stay on after the
engine has started and is running correctly. The handbrake warning light will
extinguish as the handbrake is fully released.
Note: Other Information lights may remain on (e.g. Main Beam Warning or Low
Screen Wash) dependant on the vehicle state and switch settings at the time.

F - Owner Maintenance
1-F-41 Boot Fusebox
F1 10A Reverse Light Relay
F2 20A Security System & Tilt Sensors
F3 5A +12V Ignition
F4 5A Boot Switch Logic Relay, Security System Control Unit
F5 30A Accessory Terminal
F6 5A RH Fog Lamp, Powertrain Control Modules
F7 20A Fuel Pump 2, Secondary Powertrain Control Module
F8 10A HM Stop Light, LH Stop Light
F9 10A Boot Lamps, Radio Aerial Motor
F10 10A Accessory Socket
F11 20A Not Used
F12 20A Not Used
F13 10A Airbag Control Unit
F14 30A Not Used
F15 20A Fuel Pump 1, Primary Powertrain Control Module
F16 10A Rear Fog Light Relay
F17 10A Manual Gearbox Cooling Pump
F18 10A Accessory Terminal
F19 10A RH Tail, Side, Side Marker and
Number Plate Lamps
F20 20A Premium ICE Amplifier
F21 10A LH Tail, Side, Side Marker and
Number Plate Lamps
F22 20A Manual - Exhaust By-pass System
Automatic - Not Used