2003 ASTON MARTIN DB AR1 Q wheel

F - Owner Maintenance
1-F-27 The DB AR1 may then be winched onto a transporter or towed to a safe
location using a rope, provided that the following precautions are observed:
Transporting
If the vehicle is to be transported on a trailer or flat bed transporter, the
handbrake must be applied and the wheels chocked. Vehicles fitted with
Touchtronic transmission must have the gear selector lever moved to N or
D but NEVER in P. The parking lock may be damaged if the vehicle is
transported with the gear selector lever in P.
Four tie-down brackets are provided, two on each axle. These are NOT
suitable for solid bar towing.
Front Axle Tie-Down Rear Axle Tie Down
Vehicles with Defective Touchtronic Transmission
The vehicle must be carried on a transporter or towed with the rear wheels
clear of the ground (see suspended towing) or towed with the propeller shaft
disconnected at the final drive input flange. If the propeller shaft is
disconnected, it must be firmly secured away from the final drive flange.

F - Owner Maintenance
1-F-29 3. Raise the vehicle using a 'spectacle frame' type lifting device with a cradle
positioned under each front wheel as shown below.
Rear Suspended Tow
Caution: To prevent body damage ensure an adequate clearance is
maintained between the car body and (1) the ground and (2) the 'spectacle
frame' of the towing vehicle while your car is being towed.
1. Remove the ignition key from the ignition/steering lock.
2. Raise the vehicle using a 'spectacle frame' style lifting device where a
cradle is positioned under each rear wheel as indicated below.
Towing by Another Vehicle
WARNING: When the engine is stationary, there will be no power assistance to
the steering or brakes. Therefore be prepared for relatively heavy steering and
the need for greatly increased brake pedal pressure.
The vehicle may be towed short distances by another provided that a speed
of 48 km/h (30 mph) is not exceeded. Do not tow for more than 24km (15
miles). When being towed, the vehicles gear lever, or gear selector lever
(automatic transmission), must be in Neutral or position N with the ignition
key turned to position II to release the steering lock and to render the horn,
indicators and brake lights operational.

F - Owner Maintenance
1-F-42
Bulb and Fuse Replacement
A kit of replacement bulbs, fuses etc. is supplied. Any item used from the kit
should be replaced at the earliest opportunity so that the full kit is always
available.
On vehicles fitted with the space-saver spare wheel the kit is stored in the
wheel insert.
On vehicles without the spare wheel the kit is stored in the insert under the
boot floor covering. The kit contents are market dependant and typically
include:
12V, 5W (Festoon) C5W Number Plate Light
12V, 5W (capless) W5W Side Lights/Side Repeater Lights
12V, 55W H1 Headlight Main and Dip Beam
Note: From August 2002 dip beam bulbs 12V, 55W H1 Philips Blue Vision for all
countries except North America.
12V, 55W H3 Headlight/Fog light (not USA)
12V, 3W W3W Side Markers LH/RH, Front
and Rear
Fuse Extractor Key
Note: Spare bayonet fuses are located in the toolkit

F - Owner Maintenance
1-F-44
Headlight Dipped Beam Bulb Replacement
The dipped beam lights are accessed through panels in the wheel arch liners.
1. Turn the steering to the opposite lock to the defective light (i.e. full right
lock to access the left dipped beam light and vice versa).
2. Using a screwdriver from the tool kit, release the quarter turn fastener on
the access cover in the wheel arch liner and remove the cover.
3. Remove and replace the bulb following the instructions for the main
beam on the previous page.
4. Refit and secure the access cover.

F - Owner Maintenance
1-F-55 Aston Martin recommends the use of 'AUTOGLYM' car care products or
preparations of similar reputable manufacture for adding to the washing
water. The use of mild 'detergents' as directed by the manufacturers will also
help. When dust and mud have been removed with a hose brush and water,
finally dry with a chamois leather, which should be rinsed regularly in clean
water.
WARNING: Washing and polishing agents containing silicone should not be
applied to glass. This will reduce the efficiency of the windscreen wipers, causing
smears which will reduce visibility, particularly during darkness and in the rain.
During the winter months, it is advisable to wash the car more frequently,
paying particular attention to the underside to combat the detrimental
effects of any salt and sand contamination picked up from treated roads.
Polishing
Approximately twice a year, a good quality polish should be applied and
then buffed, using a soft lint-free cloth.
Alloy wheel rims should be treated with a cleaner which is specifically
manufactured for this purpose.

F - Owner Maintenance
1-F-58
Storing the Car - Recommendations
Note: These recommendations apply to new and pre-owned cars either in
Dealer or customer ownership.
When ever the car is not in use always cover the car with it's fabric cover.
If the vehicle is not to be used for periods up to six months it should be stored
in a dry, well ventilated building.
Drive the car for a sufficient distance to warm the oil in the engine, torque
convertor, transmission and final drive unit; this ensures complete lubrication
of the internal components.
Check the engine coolant level. Top up if necessary with the correct
antifreeze/water solution.
In order to take the weight off the tyres, raise the car with a jack and place
supports under the front and rear suspension.
If the vehicle is not raised from the ground, increase the tyre pressures to 3.4
bar 340 kpa 50 psi. Cover the tyres to exclude any light. Rotate the wheels
1/4 turn every month to avoid tyre flat spots.
The battery should be removed and cleaned. Fully charge the battery on a
trickle charger and recharge once a month.
Once a month
Reconnect the battery and ventilate the storage area. Start and run the
engine until fully warmed up. Check that there are no fluid leaks. Check
and correct the tyre pressures if necessary.
Run the Air Conditioning system to keep the internal parts of the Air
Conditioning system lubricated.

G - Specifications
1-G-1
Contents
Body ................................................................................................. 1-G-2
Engine ............................................................................................... 1-G-2
Power and Torque Graphs ................................................................. 1-G-3
Transmission - Manual....................................................................... 1-G-4
Transmission - Automatic ................................................................... 1-G-4
Final Drive ......................................................................................... 1-G-4
Steering ............................................................................................. 1-G-4
Suspension........................................................................................ 1-G-5
Brakes ............................................................................................... 1-G-5
Towing .............................................................................................. 1-G-5
Wheels and Tyres .............................................................................. 1-G-6
Exterior Features ................................................................................ 1-G-7
Interior Features ................................................................................ 1-G-7
Lights ................................................................................................ 1-G-8
Exterior Dimensions and Clearances.................................................. 1-G-9
Interior Dimensions .........................................................................1-G-10
Weights ........................................................................................... 1-G-10
Capacities........................................................................................ 1-G-11
Recommended Fluids ......................................................................1-G-12

G - Specifications
1-G-4
Transmission - Manual
Tremec T 56 six speed transmission
Gear Ratios
1st 2nd 3rd 4th 5th 6th Reverse
2.66:1 1.78:1 1.30:1 1.00:1 0.79:1 0.62:1 2.9:1
Transmission - Automatic
ZF 5HP-30 five speed automatic transmission with manual gearshift control
using the special selector lever or steering wheel mounted gear shift buttons.
Gear Ratios
1st 2nd 3rd 4th 5th Reverse
3.55:1 2.24:1 1.54:1 1.00:1 0.79:1 3.68:1
Final Drive
GKN Powerlock limited slip differential.
Ratios Manual = 4.09:1 Auto = 3.06:1
Steering
Rack and pinion power-assisted steering. 2.76 turns lock to lock.
Column tilt and reach adjustments.
Turning Circle Kerb to Kerb - 11.4 metres
Wall to Wall - 11.8 metres
Toe-In 0° + 5' front, 0° 12' ± 6' rear
(at half laden ride height of 137 mm front, 141 mm rear)