2003 ASTON MARTIN DB AR1 Q warning

B - Controls
1-B-21
Electric Window Switches
On either side of the gear selector lever are two identical
rocker switches to control the movement of the electric
windows.
With the ignition on and the doors closed, press and hold
the down (hollow) arrow to lower the window.
Press and hold the up (solid) arrow to raise the window.
Note: The electric window will only operate if the door is
closed.
Electric Window 'One Touch Down' Feature
Briefly press and release the down (hollow) arrow to lower the window fully.
Pressing the button again will stop downward window movement.
WARNINGS: Clear all obstructions before raising the window. When leaving the
vehicle, remove the ignition keys. Misuse of window switches, especially by
children, can cause injury.
Note: If battery power to the electric windows has been interrupted for any
reason, they will fail to operate correctly until reset using the procedure described
in 'Owner Maintenance'.

B - Controls
1-B-22
Cigar Lighter and Ashtray
The cigar lighter is located to the left of the ashtray and may be used when
the ignition switch is in positions I or II. It is heated by pushing down until
it clicks. The lighter will pop up when ready for use.
WARNING: The cigar lighter is heated to "Red Heat" when in use. Take care to
avoid burns and do not allow children to play with the lighter.
The ashtray may be removed for cleaning by sliding back the lid and pulling
the tray upwards. After cleaning it should be replaced and pushed down
until the locating springs click into position.

B - Controls
1-B-24
Closing the Bonnet (Hood)
To close the bonnet, hold near the centre of the rear edge and lower until
approximately 18 inches (450 mm) from the latch mechanisms and then
release it. After closing the bonnet, ensure that both left and right hand
latches have fully engaged by pulling up at either side of the bonnet rear
edge.
WARNING: Before closing the bonnet, ensure that no one is obstructing the
closing area and that hands and clothing are clear. Remove tools, cleaning cloths,
etc. from the engine compartment.
Boot (Trunk) Release
There are four methods for opening the boot.
1. The boot lid may be released at any time using the right hand button on
the key fob.
ASTON MARTIN

B - Controls
1-B-26
Accessory Socket
The accessory socket is mounted in the centre armrest beside the boot open
switch and may be used to power any 12 volt vehicle accessory requiring a
current of less than 15 amps.
The accessory socket is only live when the ignition key is inserted and the
switch is turned to position I or II.
WARNING: Damage to the electrical circuits will result if more than 15 amps is
drawn from the accessory socket.
Only connect accessories which are designed for use in a motor vehicle.
Read the manufacturer's instructions and ensure that you do not connect any
device which would exceed the current rating of the accessory socket.

C - Driving
1-C-3
Fuel Filler Cap
The fuel filler cap is located on the
left side of the car, to the left of the
boot (trunk) lid. The filler flap is
unlocked automatically upon turning
off the alarm or upon operating the
central locking system by unlocking
either door lock with the ignition
key.
Lift the filler flap. Release the filler
cap by rotating a quarter turn
anticlockwise, then lift off the cap.
WARNINGS: Fuel vapour is highly flammable, toxic and explosive. Always switch
off the ignition before refuelling. Do not overfill the fuel tank. Do not inhale fuel
fumes.
Never carry additional fuel in portable containers. They may leak, explode or
cause a fire, whether full or partially empty.
If you handle fuel improperly, it can ignite or explode and cause injury. Do not
smoke or light a flame while refuelling. Do not use mobile phones at filling
stations.
Do not use the car if there is fuel leakage or a persistent smell of fuel.

C - Driving
1-C-4
Fuel Filling
The unleaded fuel tank filler neck has a restricted opening which will only
accommodate the fuel supply nozzle of unleaded fuel pumps.
To avoid fuel spillage, stop filling at the first automatic cutoff of the fuel
supply nozzle.
Catalytic Converters
The DB AR1 exhaust system contains 3-way catalytic convertors which
convert harmful exhaust gasses into less noxious substances and so reduce
environmental pollution. Catalytic converters operate at high temperatures
and continue to radiate a considerable amount of heat after turning off the
engine.
WARNINGS: Leaded fuel will cause irreparable damage to the catalytic converters.
If you do inadvertently put leaded fuel into a DB AR1, DO NOT START THE
ENGINE. DO NOT DRIVE THE CAR. Contact your Aston Martin Dealer immediately.
Do not park over dry grass, leaves or other combustible material. A significant
fire risk exists because of residual heat in the catalytic converters.
Do not drive through deep water. The rapid cooling of the catalyst may cause it
to break up. Replacement catalytic converters are expensive.

C - Driving
1-C-6
Warning Light Indications at Ignition On
As the ignition is switched on, the DB AR1 electronic control units each
complete a self check to ensure correct operation. During these checks, the
warning lights on the instrument panel will illuminate as follows:
• Bulb Check - All warning lamps illuminate for about three seconds as a
bulb check. (The Sport and Transmission Fail lamps are not illuminated
on manual transmission vehicles).
• The Ignition and Oil Pressure warning lights illuminate until the engine
starts.
• The Check Engine light will illuminate during the engine management
self-check and will extinguish when the starter button is pressed.
• The Seat Belt warning light illuminates and a gong sounds for six seconds
if the driver's seat belt is not fastened. On fastening the seat belt, the gong
immediately ceases. The warning lamp extinguishes at the end of the six
second warning period.
• The ABS and Traction Control warning lights illuminate and extinguish
if the system self checks are satisfactory.
• The Brake warning light will illuminate and extinguish if the brake fluid
level is within specification.
• The SRS Airbag warning light will illuminate and extinguish if the SRS
Airbag control system check is satisfactory.
Only the handbrake (parking brake) warning light should stay on after the
engine has started and is running correctly. The handbrake warning light will
extinguish as the handbrake is fully released.
Note: Other Information lights may remain on (e.g. Main Beam Warning or Low
Screen Wash) dependant on the vehicle state and switch settings at the time.

C - Driving
1-C-7 If either the ABS or Brake Fluid Warning lights remain illuminated, refer to
the description of Brake Warnings during Driving later in this section.
Starting the Engine - Hot or Cold
WARNINGS:
Before driving the vehicle, ensure that you are wearing appropriate footwear to
efficiently operate the floor mounted pedals.
Ensure that floor mounted pedal movement is not restricted by floor mats or
other objects trapped beneath the pedals.
Manual Transmission - The engine can only be started with the clutch
pedal fully depressed.
Touchtronic Transmission - The engine can only be started when the gear
selector lever is in Park or Neutral.
Place the gear selector lever in Neutral (Park on Touchtronic vehicles) and
check that the handbrake is applied. Fully depress the clutch pedal on
manual transmission vehicles.
Insert the ignition key and rotate it to position II. Press the
starter button, wait until the engine fires, then release the
starter button.
Note: Do not press the accelerator during engine starting. The Electronic Engine
Management System automatically compensates for cold or hot start conditions
and makes appropriate adjustments to the fuel/air mixture and engine idle speed
without driver intervention.