20
PRE-OPERATION CHECKS
Before using this motorcycle, check the following points:
Item Routine Page
Fuel9Check fuel level/top up as required. 22Engine oil9Check oil level/add oil as required. 23, 42–44Front brake9Check operation and lever free play. Adjust if necessary.
9Check fluid level and fluid leakage Fill with DOT3 or 51–52, 54–57
DOT4 brake fluid if necessary.Rear brake9Check operation and pedal free play. Adjust if necessary. 53, 55Throttle grip/Housing9Check for smooth operation. Lubricate/Adjust if necessary. —Drive chain9Check chain slack and condition. Adjust if necessary. 58–61Wheels/Tires9Check tire pressure, wear, damage and spoke tightness. 24–25Control/Meter cable9Check for smooth operation. Lubricate if necessary. —Brake and shift pedal shafts9Check for smooth operation. Lubricate if necessary. 62Brake lever pivot9Check for smooth operation. Lubricate if necessary. 62Center and sidestand pivots9Check for smooth operation. Lubricate if necessary. 62Fittings/fasteners9Check all chassis fittings and fasteners.
—
9Tighten/Adjust, if necessary.Lights and signals9Check for proper operation. —Switches9Check for proper operation. —Battery9Check fluid level, fill with distilled water if necessary. 64–66
5SD O/M-1 9/4/01 2:49 PM Page 20 (1,1)
EAK00000
CLEANING AND
STORAGE
EAK01302*A. CLEANING
Frequent, thorough cleaning of your mo-
torcycle will not only enhance its appear-
ance but will improve its general perfor-
mance and extend the useful life of many
components.
1. Rinse the dirt and degreaser off with a
garden hose.EUU34602cCExcessive hose pressure may cause water
seepage and deterioration of wheel bear-
ings, front fork, brakes, transmission seals
and electrical parts.2. After cleaning the motorcycle, dry all
surfaces with a chamois, clean towel,
or soft absorbent cloth.3. Dry the chain and lubricate it to pre-
vent rust.
4. Automotive-type wax may be applied
to all painted and chrome-plated sur-
faces. When finished, start the engine
and let it idle for several minutes.
EAK00700B. STORAGE
Long term storage (60 days or more) of
your motorcycle will require some preven-
tive procedures to guard against deteriora-
tion. After thoroughly cleaning the motor-
cycle, prepare for storage as follows:
1. Drain the fuel tank, fuel lines, and car-
buretor float bowl(s).
2. Remove the empty fuel tank, pour a
cup of SAE 10W30 or 20W40 motor oil
in the tank, shake the tank to coat the
inner surfaces thoroughly and drain
off the excess oil. Reinstall the tank.
69
5SD O/M-3 9/4/01 2:50 PM Page 69 (1,1)
