2002 YAMAHA BEAR TRACKER 250 recommended oil

5-13
EBU00485*
Engine oil
Make sure the engine oil is at the specified level.
Fill with oil as necessary. (See pages 8-13 ~ 8-21
for details.)
Recommended oil:
Recommended engine oil classification:
API Service SE, SF, SG type or higher
-20˚ -10˚ 0˚
10˚20˚ 30˚40˚50˚C
10W/30
15W/4020W/4020W/50
10W/40
5W/30
EE.book Page 13 Monday, June 25, 2001 2:27 PM

5-17
EBU00493
Final gear oil
Make sure the final gear oil is at the specified level.
Add oil as necessary. (See pages 8-23 ~ 8-27 for
details.)
If desired, an SAE 80W90 hypoid gear oil may be
used for all conditions.NOTE:_ GL-4 is a quality and additive rating, GL-5 or GL-6
rated hypoid gear oils may also be used. _
EBU00151
Throttle lever
Check to see that the throttle lever operates cor-
rectly. It must open smoothly and spring back to
idle position when released. Repair as necessary
for proper operation.Recommended oil:
SAE 80 API GL-4 Hypoid gear oil
EE.book Page 17 Monday, June 25, 2001 2:27 PM

8-8 * It is recommended that these items be serviced by a Yamaha dealer.
** Lithium soap base grease.
NOTE:Recommended brake fluid: DOT 4
Brake fluid replacement:
1. When disassembling the master cylinder or cali-
per, replace the brake fluid. Normally check the
brake fluid level and add fluid as required.
2. On the inner parts of the master cylinder and cal-
iper, replace the oil seals every two years.
3. Replace the brake hoses every four years, or if
cracked or damaged.
WARNING
Indicates a potential hazard that could
result in serious injury or death.
Wheels*•Check balance/damage/runout.
•Repair if necessary.Wheel bearings*•Check bearing assemblies for looseness/damage.
•Replace if damaged.Front and rear
suspension*•Check operation.
•Correct if necessary.Steering system*•Check operation.
•Correct if damaged.
•Check toe-in.
•Adjust if necessary.Steering shaft*
•Lubricate every 6 months**.Fittings and Fasteners*•Check all chassis fittings and fasteners.
•Correct if necessary.Battery*•Check specific gravity.
•Check that the breather hose is working properly.
•Correct if necessary.
ITEM ROUTINEINITIAL EVERY
1
month3
months6
months6
months1
year
EE.book Page 8 Monday, June 25, 2001 2:27 PM

8-19
CAUTION:_ Be sure no foreign material enters the crank-
case. _11. Warm up the engine for several minutes at
idle speed. Check for oil leakage while warm-
ing up.CAUTION:_ If oil leakage is found, stop the engine immedi-
ately and check for the cause. _
Recommended oil:
See page 10-2.
Oil quantity:
Periodic oil change:
1.5 L
With oil filter replacement:
1.6 L
Total amount:
1.8 L
EE.book Page 19 Monday, June 25, 2001 2:27 PM

8-25 1. Drain bolt
1. Boulon de vidange
1. Tapón de vaciado
4. Remove the oil filler bolt and the drain bolt to
drain the oil.
5. Install the drain bolt and tighten it to the spec-
ified torque.
6. Fill the final gear case with oil.CAUTION:_ Be sure no foreign material enters the final
gear case. _
Tightening torque:
Drain bolt (final gear case):
23 Nm (2.3 m·kgf)
Recommended oil:
See page 10-3.
Oil quantity:
Periodic oil change:
0.25 L
Total amount:
0.27 L
EE.book Page 25 Monday, June 25, 2001 2:27 PM

8-47 1. Minimum level mark
1. Repère de niveau minimum
1. Marca de nivel mínimo
EBU00755
Brake fluid level inspection
Insufficient brake fluid may let air enter the brake
system, possibly causing the brakes to become in-
effective.
Before riding, check that the brake fluid is above
the lower level and replenish when necessary.
Observe these precautions:
1. When checking the fluid level, make sure the
top of the master cylinder is level by turning
the handlebars.
2. Use only the designated quality brake fluid.
Otherwise, the rubber seals may deteriorate,
causing leakage and poor brake perfor-
mance.
3. Refill with the same type of brake fluid. Mixing
fluids may result in a harmful chemical reac-
tion and lead to poor brake performance.
4. Be careful that water does not enter the mas-
ter cylinder when refilling. Water will signifi-
cantly lower the boiling point of the fluid and
may result in vapor lock. Recommended brake fluid: DOT 4
EE.book Page 47 Monday, June 25, 2001 2:27 PM

8-63
EBU00570
Cable inspection and lubrication
WARNING
_ Inspect cables frequently and replace if dam-
aged. Corrosion can result when the outer cov-
ering of control cables becomes damaged.
Cables can also become frayed or kinked. Op-
eration of controls could be restricted, which
could cause an accident or injury. _Lubricate the inner cables and the cable ends. If
the cables do not operate smoothly, ask a Yamaha
dealer to replace them.
Recommended lubricant:
Engine oil
EE.book Page 63 Monday, June 25, 2001 2:27 PM

10-2
10
Engine:
Type Air-cooled 4-stroke, SOHC
Cylinder arrangement Single cylinder, forward-inclined
Displacement 229.6 cm


Bore
× stroke 71
× 58 mm
Compression ratio 8.7:1
Starting system Electric starter and recoil starter
Lubrication system Wet sump
Engine oil:
Type
Recommended engine oil classification API Service SE, SF, SG type or higherModel YFM250X
-20˚-10˚0˚
10˚20˚30˚40˚50˚C
10W/30
15W/4020W/4020W/50
10W/40
5W/30
EE.book Page 2 Monday, June 25, 2001 2:27 PM