2002 YAMAHA BEAR TRACKER 250 oil dipstick

8-13 1. Dipstick 2. Maximum level mark
3. Minimum level mark
1. Jauge 2. Repère de niveau maximum
3. Repère de niveau minimum
1. Varilla de nivel de aceite 2. Marca de nivel máximo
3. Marca de nivel mínimo
EBU00866
Engine oil
Engine oil level measurement
1. Place the machine on a level place.
2. Warm up the engine for several minutes and
stop it. Wait at least ten minutes for the oil to
drain back into the crankcase before check-
ing the oil level.NOTE:_ Be sure to wait at least ten minutes until the oil lev-
el settles before checking. _3. Remove the dipstick and wipe it off with a
clean rag. Insert the dipstick in the filler hole
without screwing it in.
4. Remove the dipstick and inspect the oil level.
5. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
add oil to raise it to the proper level.CAUTION:_ Make sure no foreign material enters the
crankcase. _
EE.book Page 13 Monday, June 25, 2001 2:27 PM

8-15 1. Drain bolt 2. O-ring
3. Compression spring 4. Oil strainer
1. Boulon de vidange 2. Joint torique
3. Ressort de compression 4. Crépine d’huile
1. Perno de drenaje 2. Junta tórica
3. Muelle de compresión 4. Tamiz de aceite
Engine oil replacement and oil filter element
cleaning
1. Place the machine on a level place.
2. Warm up the engine for several minutes and
stop it.
3. Place a container under the engine.
4. Remove the dipstick and drain bolt to drain
the oil.CAUTION:_ When removing the drain bolt, the compres-
sion spring, oil strainer and O-ring will fall out.
Take care not to lose these parts. _
EE.book Page 15 Monday, June 25, 2001 2:27 PM

8-17 1. Oil filter cover
2. Oil filter
3. O-ring
1. Couvercle du filtre à huile
2. Filtre à huile
3. Joint torique
1. Tapa del filtro de aceite
2. Filtro de aceite
3. Junta tórica
5. Remove the oil filter cover and oil filter.
6. Clean the oil strainer and oil filter with solvent.
7. Inspect the O-ring and replace if damaged.
8. Install the oil filter, O-ring, and oil filter cover.
9. Replace the oil strainer, compression spring,
O-ring and drain bolt. Then, tighten the drain
bolt and oil filter cover bolts to the specified
torques.CAUTION:_ Before installing the drain bolt, be sure to in-
stall the O-ring, compression spring and oil
strainer. _10. Fill the engine with oil and install the dipstick.Tightening torque:
Drain bolt (engine):
43 Nm (4.3 m·kgf)
Oil filter cover bolt:
10 Nm (1.0 m·kgf)
EE.book Page 17 Monday, June 25, 2001 2:27 PM