2002 PEUGEOT 807 battery

YOUR 807 IN DETAIL
110
SUNROOFS You have three sunroofs each with
an independent control.
However, the front passengers' con
trol can also operate the two rear
sunroofs simultaneously.
•partially open the roof: press and
hold part Aof the switch.
•to open the roof completely:
press part Aof the switch briefly.
•to close it completely: press part
B of the switch briefly, then keep it
pressed.
•safety autoreverse
When the sunroof is sliding closed
and meets an obstacle, it stops then
opens again.
Note: in the presence of ice, if the
sunroof does not close, press the
control until the roof is fully open,
then close the roof. Note:
following reconnection of the
battery, if the sunroof does not close,
release the control and press it sev
eral times until the roof is fully
closed. Continue to press the control
for approximately five seconds after
closing.
Disarming of the 2 nd
and 3 rd
row
controls:
– press the rear electrical functions disarming switch.
Note: the sunroof shutter is manual.
To open it, lift the handle and slide it
rearwards.
To close it, slide it forwards until the
handle locks. OPENING THE BONNET
From inside:
– lift the cover at the left foot of the
passenger seat.
– pull the control upwards.
From outside: lift the catch and
raise the bonnet.
Bonnet strut
Secure the strut to hold the bonnet open.Before closing the bonnet, replace
the strut in its housing.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked.
"Bonnet open" warning
This warning is linked to the alarm
option only.
With the engine running or the
vehicle moving, a diagram on the
multifunction display, accompanied
by an audible signal, warns you that
the bonnet is not properly closed.
18-11-2002

YOUR 807 IN DETAIL119
ELECTRIC WINDOWS
1 Driver's electric window switch.
2 Passenger electric window switch.
3 Rear right electric window switch.
4 Rear left electric window switch.
5 Rear electric windows disarm ing switch (child safety).
red strip visible: switches acti vated.
red strip covered: switches dis armed. You have two options:
Manual operation: 
press or pull switch 1, without
going beyond the point of resis
tance. The window stops when
the switch is released.
Automatic operation:  or pull switch 1beyond the point
of resistance. One touch com
pletely opens or closes the win
dow.
Note: the electrical functions of the
electric windows are disarmed one
minute after switching off the
ignition.
Safety autoreverse
When the window rises and meets
an obstacle, it stops and lowers
again.
Note: in the event of ice, if the win
dow does not rise, press the switch
until the window is fully open, then
pull it again until the window closes.
Note: following reconnection of the
battery, if the window does not rise,
release the switch and pull it several
times until the window is fully
closed. Continue to hold the switch
for approximately one second after
the window has closed. Disarming
For the safety of your children, press
switch
5to disarm all of the electrical
controls in the rear:  electric windows,
 sliding side doors,
 sunroofs.
Always remove the igni
tion key on leaving the
vehicle, even for a short
time.
18-11-2002

YOUR 807 IN DETAIL
132


: snow programme
P ark: to immobilise the vehicle or start the engine ,
with the handbrake on or off.
R everse: to reverse(select this function with the
vehicle stationary, engine at idle).
N eutral: to start the engine and to park, with the
handbrake on.
Note: if function Nis engaged inadvertently while
driving, allow the engine to return to idle before
engaging function Dto accelerate.
D rive: for drivingin automatic mode.
M anual: for drivingin manual mode.
Moving off
With the engine running, to move off
from position P:
 it is essential to press the
brake pedal to exit position P,
 select function R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
You can also move off from position N:
 release the handbrake, with your
foot on the brake
 select function R, D or M, then
gradually release the pressure
on the brake pedal; the vehicle
moves off immediately.
WARNING
When the engine is at idle, brakes not
applied, if function R, D or M is
selected the vehicle moves even with
out the accelerator being pressed.
For this reason, do not leave
children unsupervised inside the
vehicle, with the engine running .
When maintenance operations need
to be carried out with the engine
running, apply the handbrake and
select position P.
"PORSCHE TIPTRONIC SYSTEM" AUTOMATIC GEARBOX
The four speed
automatic gearbox offers a choice between the comfort of inte
gral automatic operation , enhanced by a snow programme, or the pleasure of
manual gear changing .
Gear selection gate  Move the lever in the gate to select a function.
Once the function is selected, the corresponding indicator lig ht appears on
the instrument panel display.
If the battery is flat and the lever is in position P, it will be impossible
to change to another position.
18-11-2002

PRACTICAL INFORMATION
140
Only use products
approved by PEUGEOT.
To ensure best perfor
mance from components
as important as the
power steering and the braking
system,
PEUGEOT selects and offers
quite specific products.
CHECK ...
Battery
At the start of winter, have your bat
tery checked by a PEUGEOT dealer.
Air filter and pollen filter
Have the filter elements replaced
regularly. If you drive in dusty con
ditions, change them twice as
often.
Brake pads
Brake pad wear depends on the
style of driving, in particular for vehi
cles which are used in town, over
short distances .
It may be necessary to check the
thickness of the pads, even between
services.
Handbrake
Where the handbrake travel is too
great or there is a reduction in the
performance of the system, the
handbrake should be adjusted, even
between services. Have the system
checked by a PEUGEOT dealer. Fuel supply cutoff
In a serious collision, a mechanism
automatically prevents fuel from
reaching the engine.
The flashing of this warning
light is accompanied by the
message "Fuel circuit dis
armed" on the multi–func
tion display.
To reestablish the fuel supply :  switch off the ignition.
 remove the key.
 check that there is no odour or
leakage of fuel outside the vehi
cle.
 put the key back in the ignition
 switch on the ignition and start.
Manual gearbox
This does not need an oil change.
Check the level, according to the
manufacturer's service schedule.
Automatic gearbox
This does not need an oil change.
Have the level checked by a
PEUGEOT dealer in accordance
with the manufacturer's service
schedule.
Oil filter
Change the filter regularly, in accor
dance with the service schedule.
18-11-2002

PRACTICAL INFORMATION
148
Battery compartment fuses
Fuse box
To access the fuse box in the battery
compartment (floor in front of the dri
ver's seat):
 unclip the cover.
Carefully close the cover when
you have finished.
Fuse N° Rating Functions
1* 40 A Right electric sliding side door.
2* 40 A Left electric sliding side door.
3* 30 A HIFI amplifier.
4* 30 A Not used or Additional heating (Diesel).
* The maxifuses provide
additional protection for
the electrical systems. All
work must be carried out
by a PEUGEOT dealer.
18-11-2002

PRACTICAL INFORMATION
152
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position Less than a minute after switching
off the ignition, operate the wipers
stalk to position the wiper blades
along the windscreen uprights
(maintenance position).
Changing a front wiper blade  Lift the wiper arm, then disconnect
the windscreenwash pipe.
 Unclip the blade and remove it.
 Fit the new blade.
 Reconnect the windscreenwash
pipe and push back the wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the
wipers stalk.
Changing the rear wiper blade  Lift the wiper arm, then unclip the
blade and remove it.
 Fit the new blade and push back
the wiper arm. ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, courtesy lights,
audio equipment etc.) can only be
used for thirty minutes, to prevent
discharging the battery.
After thirty minutes, the message
"Economy mode active"
appears
on the multifunction display and the
active functions are put on standby.
To resume use of these functions,
start the engine and let it run for a
few seconds.
Aflat battery will pre
vent the engine from
starting.
18-11-2002

BATTERY
To charge the battery using a battery charger:– Disconnect the battery,
– Follow the instructions for use given by the battery charger man ufacturer,
– Reconnect starting with the negative (–) terminal,
– Check that the terminals and connectors are clean. If they are covered with
sulphate (white or greenish deposit), disconnect them and clean them.
To start the vehicle from another battery: – Connect the red cable to the positive (+) terminals of the tw o batteries,
– Connect one end of the green or black cable to the negat ive (–) terminal of the
slave battery,
– Connect the other end of the green or black cable to an e arth point on the bro
ken down vehicle as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect th e cables.
It is advisable to disconnect the battery if the vehicle is not to be used for
a period of more than one month.
PRACTICAL INFORMATION 153
Before disconnecting
the battery, you must
wait for 2 minutes after
switching off the igni
tion.
Never disconnect a terminal when the engine is running.
Never charge a battery without first disconnecting the terminals.
Close the windows and sun roofs before disconnecting the
battery. If they do not operate
normally following reconnection
of the battery, they must be rein
tialised (see sections "Electric
windows Safety autoreverse"
and "Sunroofs Safety auto
reverse".
After every reconnection of the battery, switch on the ignition
and wait 1 minute before start
ing to allow the electronic sys
tems to be initialised. If slight
difficulties are experienced after
this, please contact a
PEUGEOT dealer.
18-11-2002