2002 Peugeot 607 Dag spare wheel

PEUGEOT SERVICING 25
Level
Operations Description of operation 1st service
A C Intermediate
DRAIN/REFILL Engine oil Bleed fuel filter (diesel) Oil filter Fuel filter
*(petrol)REPLACE Fuel filter element (diesel) Air filter element Spark plugs (petrol) Engine oil (check + topup) Manual gearbox oil (check + topup) Battery (check + topup) if cap is removableLEVEL Screen wash (check + topup) Coolant (check + topup) Brake fluid (check + topup) Power steering fluid (check + top up according to specification ) Operation of lights and indicators Condition of glass, headlamp and light lenses and mirrors Horn Windscreen washer jets Condition of wiper blades Condition and tension of the ancillary drive belts Handbrake Condition of hydraulic circuits (hoses and covers)CHECK Condition of rubber boots and gaiters Brake pads o Play in hubs, link rods, ball joints, flexible mountings Shock absorbers Rear drum brake lining wear Condition and pressure of tyres (including spare wheel) Emission control check as per current legislation (petrol) Smoke opacity (diesel) Pollen filter (according to specification)o
Visual check of the whole vehicle


: All driving conditions o: Arduous conditions * According to destination
SERVICE
ROAD TEST
A AND C SERVICE LEVELS AND THE INTERMEDIATE VISIT
Courtesy vehicle

139
TYRE UNDERINFLATION
DETECTION
Sensors check the tyre pressure
during driving, and trigger a warning
in the event of malfunction (speed
greater than 15mph [25 km/h]).
Flat tyreWhen this warning light
comes on, accompanied by
an audible signal and the
message 'Tyre pressure
low' on the multifunction
display, have the tyre pressure
checked as soon as possible.
Puncture
This warning light, accom
panied by an audible signal
and the message 'Punc
tured tyre(s) detected' on
the multifunction display, is
followed by illumination of the
'STOP' warning light.
Stop immediately, avoiding any sud
den movement of the steering wheel
and the brakes.
Change the damaged (punctured or
very deflated) tyre, and have the tyre
presure checked as soon as possible.
Note: if the damaged tyre is tem
porarily stored in the boot, it will
again emit this message to remind
you of the necessity of having it
repaired. This will prevent another
warning of the same type being dis
played. Sensor(s) not detected
This warning light, accom
panied by an audible signal
and the message ' X tyre
pressure sensor(s) miss
ing ' on the multifunction
display, indicates that underinflation
detection is absent from one (or sev
eral) tyre(s).
Contact a PEUGEOT dealer to
replace the faulty sensor(s).
Note: this message is also displayed
when one of the tyres is away from
the vehicle (being repaired) or when
a wheel without a sensor is fitted.
LES INFORMATIONS PRATIQUES
All repairs and changing
of tyres on a wheel fitted
with this system must be
carried out by a
PEUGEOT dealer.
The tyre underinflation detec
tion system is an aid to driving
which does not replace the
need for the driver to be vigilant
or to drive responsibly.
This system does not remove the
necessity for having the tyre pres
sure (including that of the spare
wheel) checked regularly, to
ensure optimum dynamic perfor
mance of the vehicle and to pre
vent premature wear of the tyres,
particularly in the case of arduous
driving conditions (heavy load,
high speed).
The system may temporarily be
disturbed by radio broadcasts on
a frequency close to it.

PRACTICAL INFORMATION
140
CHANGING A WHEEL
Park the vehicle on level, stable
and nonslippery ground.
Apply the handbrake, engage first
or reverse gear (position
Pfor the
automatic gearbox) and switch off
the ignition.
Access to the spare wheel and the
jack in the boot
Detach the luggage net.
Lift the boot carpet using the lifting
hook. Secure this hook behind the
boot seal. Tools available
The following tools are located in the
polystyrene holder in the centre of
the spare wheel:
1
Wheelbrace.
2 Centralising tool.
3 Wheelbrace extension.
4 Jack fitted with a system which
enables it to be folded or unfold
ed rapidly.
5 Removable towing eye.
6 Alloy wheel trim remover.
7 Trim cover tool. Removal
For vehicles with alloy wheels fit
ted with wheel trims, pull the
centre trim by using tool
6in one
of the holes.
Loosen the wheel bolts.
Take the jack from the tool kit and
fold it by pressing the ends A.

PRACTICAL INFORMATION 141
Fold the jack by pressing at the
ends
Aand place it in one of the
four locations Eunderneath the
vehicle (the nearest one to the
wheel to be changed).
Extend the jack, first by hand, pul
ling the ends Athen using wheel
brace 1and the extension 3.
Remove a wheel bolt at the top
and fit the centralising tool 2in its
place.
Unscrew the other bolts and
remove the wheel.
Fitting a wheel
Position the wheel using the cen
tralising tool to assist you.
Tighten the bolts by hand and
remove the centralising tool.
Partly tighten the bolts using the
wheelbrace.
Fold the jack and remove it.
Fully tighten the bolts using the
wheelbrace.
Replace the wheel trim.
Put the tool holder back in posi
tion. This helps to keep the boot
floor in its correct position, to pre
vent any deformation of the floor
when loaded.
Tighten the spare wheel securing
strap to prevent noise and for your
safety in the event of impact. For your safety, always
change the wheel:
– on level, stable, nonslippery
ground,
– with the handbrake applied,
– with first or reverse gear engaged (position Pfor the
automatic gearbox),
Never go underneath a vehicle
which is supported only by a
jack (use a ramp).
After changing the wheel:
– have the tightening of the bolts and the tyre pressure checked
by a PEUGEOT dealer as soon
as possible.
– have the punctured wheel repaired and refit it to the vehi
cle as soon as possible.
Tyres fitted with the Tyre Under
Inflation Detection System.
These wheels have a pressure
sensor. Have them repaired by a
PEUGEOT dealer.

Special features of alloy wheels*
Bolt covers
Alloy wheel bolts are covered by
chrome trims.
Use tool7to remove the trims before
slackening the bolts. Antitheft bolts*
If your wheels are fitted with an anti
theft bolt (one per wheel), the
chrome trim and then the plastic
cover must be removed using tool
7,
before unscrewing the bolt using one
of the two antitheft sockets (which
were given to you on delivery of your
vehicle along with the duplicate keys
and the confidential card) and the
wheel brace 1.
Note: make a careful note of the
code number engraved on the head
of the antitheft socket. This will
enable you to obtain duplicate anti
theft sockets from a Peugeot dealer.
* According to model and destination
PRACTICAL INFORMATION
142
7
Fitting the spare wheel
If your vehicle is fitted with a steel
spare wheel, when fitting it, it is
nor
mal to notice when tightening the
bolts that the washers do not come
into contact with the rim. The spare
wheel is secured by the coneshape
of each bolt.
Fitting snow tyres
If you fit snow tyres mounted on steel
wheels to your vehicle, it is essential
to use special bolts available from
your PEUGEOT dealer.
7

PRACTICAL INFORMATION 153
Special features of the
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
– lever in position
N,
– tow the vehicle at less than 30 mph (50 km/h) over a maximum
distance of 30 miles (50 km).
– do not add oil to the gearbox.
TOWING YOUR VEHICLE
Without lifting (4 wheels on the road)
You should always use a tow bar.
The towing eye is inside the spare wheel.
From the front:
 Unclip the bottom of the cover, using the flat part of th e towing eye.
 Screw in the towing eye until it locks.
From the rear:  Unclip the top of the cover using the flat part of the to wing eye,
 Screw in the towing eye until it locks.
Lifting (2 wheels only on the road )
It is preferable to raise the vehicle by the wheels.
Never use the radiator crossmember.
ParticularitŽs de la bo”te de vitesses automatique
When towing with the
engine switched off,
there is no braking assis
tance.