2002 Peugeot 607 Dag change time

YOUR 607 IN DETAIL
52
GENERAL FUNCTIONS On/off
With the ignition key in the accessories position (1st notch) or with the ignition on (2nd notch), press button
A to switch the set on or off.
The set can operate for 30 minutes without the vehicle ign ition being switched on.
Antitheft system
The audio system is coded in such a way that it can operate on ly on your vehicle. It would not function if fitted to another
vehicle.
This system is automatic and requires no action on your part.
ADJUSTING THE SOUND Adjusting the volume
Turn buttonAto increase or decrease the volume.
Note: the automatic volume correction function "CAV", which depends on the speed of the vehicle, is acces
sible using the audio menu on the multifunction display.
AUDIO SETTINGS Press the 'AUDIO' button several times in succession to access the bass (BASS), treble (TREB), loudness
(LOUD), fader (FAD) , balance (BAL)and automatic volume correction (CAV).
Exit from audio mode is automatic after a few seconds without p ressing any button, or by pressing the
'AUDIO' button after adjusting the balance.
Note: bass and treble settings are specific to each source. It is possibl e to set them differently for radio,
cassette (RM2 audio) or CD changer.

Selecting telephone mode / Entering a number / Switching off the microphone
To change to telephone mode, press the 'TEL' button or for more than 2 seconds on the steering column
remote control.
Insert your SIM card fully into the slot at the front (use only t he new generation 3V SIM card with bank card
format).
Note: the SIM card must not be taken out while the audio/telepho ne system is still in use. If you forget to do this, an audi
ble signal will sound for a few seconds after the ignition is switched off.
Enter your PIN number and confirm with the 'OK' button in order to access the network. The welcome screen is
displayed.
Note: the PIN code is erased each time the ignition is switched off , but the ''PIN code protection'' function may be
cancelled.
Enter the number of the person you wish to speak to on the di gital keypad and pres the 'OK'button to make the call.
To switch off the microphone midcommunication, press the 'TEL'button.
Cancelling the PIN code request
To cancel the PIN code request, select 'PIN code protection' in the 'Telephone parameters' menu and confirm; select 'OFF'
and confirm, then input your PIN code and confirm.
Receiving / Ending a call
When a ringing sounds to let you know that a call is waiti ng, you can choose either to accept it by press
ing the 'OK'button or not to accept it by pressing button Por by selecting 'Refuse call' using the steer
ing column remote control, pressing the end to confirm.
If you do not accept it, the call is diverted to your voice mai l (if this service is available and active).
To end the call, press button Por the end of the steering wheel remote control.
Note: Not accepting or ending a call by means of the steering whee l control returns the system to radio mode.
Receiving two incoming calls
During a call, when there is another incoming call, you are i nformed of this by a ring and a message. You may choose:
– to accept the call by pressing button 2 then "OK"; the first caller is put on hold and you are in contact wit h the second.
However, pressing button 2 again allows you to return to th e first caller,
– to finish the call you are on and talk to the second call er by pressing button 1 then "OK",
– not to accept the new call by pressing button "C".
YOUR 607 IN DETAIL 63

Using the menusFrom the welcome screen, press the "MAN" button to access the menus.
Press the "MAN" button to change from one menu to another on the list, in order to reach the one you require.
Inside each menu: Cancel a function using button P,
Move around using buttons Mand L,
Confirm a function with the "OK" button,
Change the values with buttons Fand H,
Clear using the "C"button.
Note: during communication, the menus are accessible with the exception of functions which depend on the network (mes
sage service, sending a message etc.). In this case, to cancel any o peration, use the "TEL"button rather than button P, as
this allows you to return to the welcome screen at any time.
Handset
To change to the
'confidential'function during a call, lift the handset located in the front armrest; the 'hands free' function
is then neutralised.
To return to the 'hands free'function during the call, replace the handset on its support .
'PEUGEOT' call* To call PEUGEOT's Customer Contact Centre and access the services available:
– press button Othen confirm by pressing Oagain or the 'OK' button,
– or, press button Oto display the "Services"menu, select the
''Peugeot Service"* function then confirm (see paragraph on ''Services'').
Emergency call*:
– directly enter the number 11 2(it is not necessary to insert your SIM card or enter the PIN code),
– or, press button Oto display the "Services"menu and select the 'Emergency call'*function then confirm (see paragraph
on ''Services'').
YOUR 607 IN DETAIL
64

YOUR 607 IN DETAIL
66
Storing numbers in the telephone directory (SIM)
In the 'Phonebook' menu, validate the 'New Entry' function with the 'OK'button.
Using the alphanumerical keypad input the name, telephone number and address (the memory number) or keep the one
suggested. Confirm each operation with the 'OK'button.
To access a number in the memory: – look for and select it in the menu 'Find by name'or 'Find by address ' of the 'PHONEBOOK' menu and
press the 'OK'button to make the call,
– or press the end of the steering wheel remote control for more than two seconds, look for and select the
number, then press the end of the remote control to make the call,
– or enter the memory number using the keypad, then press button Ffollowed by the 'OK' button to make the
call.
Note: the first nine numbers in this list are directly accessible. Hold one of the nine buttons of the keypad down, then press
the 'OK' button to call.
Selecting the previous item of a menu Press button Mas many times as necessary to select the required item. Confirm with the 'OK' button.
Selecting the following item of a menu Press button Mas many times as necessary to select the required item. Validate wi th the 'OK' button.
Accessing mini messages
In telephone mode: when the buzzer sounds and the 'envelope' symbol is displayed o n the screen, you can access new
messages by pressing the 'MAN' button.
In radio mode: when the symbol appears, you must change to telephone mode (pre ss the "TEL" button) to be able to
access the new messages.
Note: the old stored messages are accessible. In the 'SMS'menu, confirm the 'Messages received' function with the 'OK'
button, then select the message using button 'M'or 'L' to consult it.

YOUR 607 IN DETAIL
68
'CALL SETTINGS'
Network search: if the automatic mode is active, your telephone will automat ically select the cellular network available which
is compatible with your SIM card. In manual mode, you must choose f rom the list of networks the one which matches the
operator who supplied you with your SIM card.
Voice mail: allows you to call your voice mail to listen to the latest messa ges received.
Call broadcast: activates the receipt of information issued by your network (depen ding on subscription agreement).
Call waiting: in the case of two simultaneous calls, you can go from one to the other.
Call diverting: allows incoming calls to be diverted to your voice mail or to an other telephone number.
My phone number: allows three telephone numbers to be stored.
Barring: allows the possibilities of calls from the telephone to be restricted (it is necessary to use PIN 2 code).
Call ID display: allows your number to be disclosed to or withheld from the perso n being called (depending on subscription
agreement).
'TELEPHONE SETTINGS'
Cumulative time: tells you the total duration of incoming and outgoing cal ls.
Ring tone: allows you to select a call ring from the six options.
Ring volume: allows you to adjust the volume of the incoming call ring.
Operating tone: allows you to activate or disarm the sound signal (bleep) emitte d each time a button is pressed, and to
adjust the volume.
TEL position: allows you to select the monitor speakers (left side/right side/b oth).
Automatic answer: allows you to programme the automatic reply (after five seconds) to an incoming call.
Automatic redial: when your call is not successful, automatic recall (ten times maximum) o f the same number.
PIN request: protects your SIM card against any unauthorised use.
PIN change: lets you change your pin code.
Language select: lets you select the displayed language (French/English/German/Spa nish/Italian/Dutch).
Master reset: lets you store the initial parameters of your telephone, with out erasing the information in the memory.

The control pad
This lets you select and confirm the functions, controls and programmes dis
played. It is located by the side of the screen.
Dial; this has two functions:
– Rotation of the dial:This allows you to move roundthe screen and thus select a
function.
It also allows you: – with a 'setting' type parameter, after selection, to increase
or decrease the value,
– with a 'list'type parameter, to open the list and scroll
through the values.
– Pressing the dial:
This allows:
– confirmation of the selected function or the modified value.
– selection of a 'setting' or 'list' type parameter for modifica
tion.
– cancelling of a superimposed display.
'MENU' button:
This allows access at any time to the general menu.
'MODE' button:
– brief press: – monochrome screen C: selection of functions (audio sys
tem, navigation / guidance...),
– colour screen: access to the list of controls (context menu)
of the function being displayed.
– Pressing for more than two seconds puts the screen on standby.
'ESC' button:
– brief press: cancelling of operation in progress and return to the
previous screen or erasing of a superimposed display.
– pressing for more than two seconds returns to the welcome screen. 71
SATELLITE NAVIGATION
SYSTEM
Introduction
The satellite navigation system
guides you, by means of vocal and
visual instructions (graphics), to
your chosen destination.
The heart of the system lies in the
use of a map data base and GPS
(Global Positioning System). With
this system you can fix the position
of your vehicle by means of a satel
lite network.
The system uses the following ele
ments:
– the control pad,
– the CDROM drive,
– the last voice message and route change recall control,
– the map data in CDROM format,
– the monochrome or colour screen.
Certain functions or services
described may vary depending
on the version of CDROM or the
country where the vehicle is sold.
YOUR 607 IN DETAIL

YOUR 607 IN DETAIL
79
Navigation options
From the main menu, 'Navigation options'gives you
access to the following programmes:
– management of the directories. This allows details of a stored address to be renamed or deleted, by selecting
the directory and the details to be modified,
– voice synthesis volume adjustment, Once the function has been selected, adjust the volume
of the voice synthesis using the dial, the audio system
button or the steering wheel stalk, then confirm.
Note: the voice synthesis volume can also be adjusted
during a message using the audio system button or the
steering wheel stalk.
– deletion of all data stored in both directories. Guidance tools
Access to the
'Guidance tools' menu is by pressing the
dial at any time during guidance.
It enables:
– the current guidance criterion to be changed,
– the programmed destination to be displayed or changed,
– the voice synthesis volume to be adjusted (see ''Navi
gation options'' ' paragraph),
– the current guidance to be stopped.

Map configuration
This function offers various possibilities to optimise and
enhance the display of the route:
– map orientation,
– type of services displayed,
– selection of scale.
Map orientation
This function allows orientation of the map to be selected:
North or according to the direction of the vehicle.
Note: the "vehicle orientation" option is only active if the
display scale is less than or equal to 1km.
Types of services displayed
This function allows the required service to be displayed.
From the list presented, select the service(s) required (for
insertion), the service(s) not required (for deletion), or
choose 'Any'(parking, hotel, restaurant, service station,
cinema...).
Changing the route
This function allows you, for example, to avoid a tailback
on the route which has been worked out.
Using the 'Navigation/Guidance' context menu, or by
holding down the last voice message recall control, you
can introduce a change to the route that had been worked
out, at any time during guidance.
This change occurs on the stretch between your present
position and a point located at a distance which has to b e
input, using the initial route.
Enter a distance between 1 and 10 km, using the alphanu
meric keypad, then confirm.
The system takes this change into account and suggests
new guidance, having invalidated the section selected. Details of the route
At all times during guidance, the submenu
'Details of the
route' gives you access to the following functions:
– destination selected,
– see the places to be travelled through (display of roads, streets and towns to be passed),
– see the route on the map (change to map display).
A pointer located on the side indicates your position in rela
tion to the route.
Geographical information
The submenu 'Geographical information' presents the
GPS information regarding the position of the vehicle.
YOUR 607 IN DETAIL
85