Page 36 of 1767
qA
Depress brake pedal and move selector
lever to ªDº position.
1. Set A/T mode switch to ªAUTOº posi-
tion.
2. Depress and release accelerator pedal
quickly.
Does SPORT indicator lamp come on for
about 3 seconds after accelerator pedal is
depressed?
Ye s
ENo
Go to 4. SPORT Indicator
Lamp Does Not Come On,
AT-96.
Turn ignition switch to ªOFFº position.
Perform self-diagnosis and note NG
items:
Refer to SELF-DIAGNOSIS
PROCEDURE, AT-14.
Go to ª2. Check at idleº, AT-35.
SAT869E
SAT754A
NAT309
H
H
H
H
H
H
TROUBLE DIAGNOSIS Ð Basic Inspection
Road Test (Cont'd)
AT-34
Page 50 of 1767

Terminal
No.Item ConditionJudgement
standard
28Power source
(Back-up)
or
When turning ignition switch to
ªOFFº.Battery voltage
When turning ignition switch to ªONº. Battery voltage
29Revolution sensor
(Measure in AC rang)
When vehicle cruises at 30 km/h (19
MPH).1V or more
Voltage rises gradually in
response to vehicle
speed.
When vehicle parks. 0V
34Park/neutral ªDº position
switch
When setting selector lever to ªDº
position.Battery voltage
When setting selector lever to other
positions.Approximately 0V
35Park/neutral ªRº position
switchWhen setting selector lever to ªRº
position.Battery voltage
When setting selector lever to other
positions.Approximately 0V
36Park/neutral ªNº or ªPº
position switchWhen setting selector lever to ªNº or
ªPº position.Battery voltage
When setting selector lever to other
positions.Approximately 0V
39 Engine speed signal
When engine runs at idle speed. 0.8V
When engine runs at 2,000 rpm. Approximately 2.2V
40 Vehicle speed sensor
When moving vehicle at 2 to 3 km/h
(1 to 2 MPH) for1m(3ft)ormore.Voltage varies between
less than 1V and more
than 4.5V
42Throttle (accelerator)
position sensor
(Power source)
Ð 4.5 - 5.5V
42 Ground Ð Ð
43 SPORT indicator lamp
When setting A/T mode switch in
ªSPORTº position.Approximately 0V
When setting A/T mode switch in
other position.Battery voltage
44A/T mode switch
ªSPORTºWhen setting A/T mode switch in
ªSPORTº position.Battery voltage
When setting A/T mode switch in
other position.Approximately 0V
47A/T fluid temperature
sensorWhen ATF temperature is 20ÉC
(68ÉF).Approximately 1.5V
When ATF temperature is 80ÉC
(176ÉF).Approximately 0.5V
TROUBLE DIAGNOSIS Ð General Description
TCM Terminals and Reference Value (Cont'd)
AT-48
Page 97 of 1767
2. SPORT or SNOW Indicator Lamp Does Not
Come On
SYMPTOM:
SPORT or SNOW indicator lamp does not come on when turn-
ing A/T mode switch to the appropriate position.
Is 1. O/D OFF, SPORT or A/T CHECK
Indicator Lamp Does Not Come On OK?
Ye s
ENo
Go to 1. SPORT Indicator
Lamp Does Not Come On,
AT-92.
Check the following items:
IA/T mode switch
Refer to AT-92.
ISNOW indicator lamp
IHarness continuity between ignition
switch and A/T mode switch
IHarness continuity between A/T mode
switch and TCMENG
Repair or replace dam-
aged parts.
3. O/D OFF Indicator Lamp Does Not Come On
SYMPTOM:
O/D OFF indicator lamp does not come on when setting over-
drive control switch to ªOFFº position.
Check the following items:
IOverdrive control switch
IO/D OFF indicator lamp
IHarness continuity between ignition
switch and O/D OFF indicator lampENG
Repair or replace dam-
aged parts.
NAT309
NAT232
H
DIAGNOSTIC PROCEDURES FOR SYMPTOMS
AT-95
Page 1343 of 1767

Model Variation
Body Grade Engine Transmission Group A (RHD)Group B (South)
Group C (Cen-
tral)Group D (North)
H/TSE
ªLuxury/
EleganceºTD27Ti FS5R30A KVPNRVF-UEC KVPNLVF-UGC KVPNLVF-USC
ZD30ETiFS5R30A KWSNRVF-UEC KWSNLVF-UGC KWSNLVF-USC
RE4R01A KWSNRVA-UEC KWSNLVA-UGC KWSNLVA-USC
SR
ªSportºTD27Ti FS5R30A KVPNRUF-UEC KVPNLUF-UGC KVPNLUF-USC
ZD30ETiFS5R30A KWSNRUF-UEC KWSNLUF-UGC KWSNLUF-USC
RE4R01A KWSNRUA-UEC KWSNLUA-UGC KWSNLUA-USC
S ªComfortº TD27Ti FS5R30A KVPNRQF-UEC KVPNLQF-UGC KVPNLQF-USC
WagonSE
ªLuxury/
EleganceºTD27Ti FS5R30A TVPURVF-UEC TVPULVF-UGC TVPULVF-USC
ZD30ETiFS5R30A TWSURVF-UEC TWSULVF-UGC TWSULVF-USC
RE4R01A TWSURVA-UEC TWSULVA-UGC TWSULVA-USC
SR
ªSportºTD27Ti FS5R30A TVPURUF-UEC TVPULUF-UGC TVPULUF-USC
ZD30ETiFS5R30A TWSURUF-UEC TWSULUF-UGC TWSULUF-USC
RE4R01A TWSURUA-UEC TWSULUA-UGC TWSULUA-USC
S ªComfortº TD27Ti FS5R30A TVPURQF-UEC TVPULQF-UGC TVPULQF-USC
Prefix and suffix designations:
KBFNLVFR20EGC
C : Standard
E : RHD models
G : South/Central Europe
S : North Europe
U : Turbo
F : 5-speed manual transmission
A : Automatic transmission
Q : S grade
U : SR grade
V : SE grade
L : Left-hand drive
R : Right-hand drive
N : 4-wheel drive, short wheelbase
U : 4-wheel drive, long wheelbase
VP : TD27Ti engine
WS : ZD30DDTi engine
K : Hardtop
T : Wagon
IDENTIFICATION INFORMATION
GI-28
Page 1349 of 1767
NISSAN recommends that a dolly be used as illustrated when tow-
ing 4-wheel drive models.
Towing with four wheels on ground or towing with front
(rear wheels on ground) or rear wheels (front wheels
on ground) raised
Observe the following restricted towing speeds and distances.
Speed:
Below 50 km/h (30 MPH)
Distance:
Less than 65 km (40 miles)
If the speed or distance must necessarily be greater, remove the
front and rear propeller shafts beforehand to prevent damage to the
transmission.
TOWING POINT
IAlways pull the cable straight out from the vehicle. Never
pull on the hook at a sideways angle.
IUse proper towing equipment when towing. Otherwise, the
vehicle body will be damaged.
Front
IOnly R.H. hook may be used for towing purposes. Use L.H.
hook only for securing the vehicle during transportation.
Rear
IEither hook can be used for towing purposes.
A platform should be used.
EGI018
EGI019
EGI020
LIFTING POINTS AND TOW TRUCK TOWING
Tow Truck Towing (Cont'd)
GI-34