2002 MAZDA MODEL 626 light

5-29
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q50-EA-01G





Immobilizer System Warning/
Security Indicator Light
Immobilizer system warning light
When the key is in the ignition switch,
this light serves as the immobilizer system
warning light.
If the immobilizer system is working
properly, the light will come on when the
ignition switch is turned to the ON or
START position. The light will go out
when confirmation by the immobilizer
system is completed.
If the light flashes rapidly, fails to come
on, or comes on and stays on, it indicates
a system malfunction. If any of these
occur, contact an Authorized Mazda
Dealer as soon as possible.
Security indicator light
When there is no key in the ignition
switch, and the theft-deterrent system has
been armed, the light will flash once every
3 seconds. This indicates that the system
is working properly.





Headlight High-Beam Indicator
Light
This light indicates one of two things:
• The high-beam headlights are on.
• The turn signal lever is in the flash-to-
pass position.





Rear Window Defroster
Indicator Light
This light comes on when the rear
window defroster is on.
J94S.book Page 29 Saturday, June 23, 2001 1:04 PM

5-30
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q50-EA-01G





O/D OFF Indicator Light
This light comes on when the overdrive
has been turned off.





Cruise Set Indicator Light
This light comes on when a cruising speed
is set.





TCS OFF Indicator Light
This light comes on when the ignition
switch is turned to the ON position.
It goes off when the engine is started. It
also comes on when you switch off the
traction control system or when the
system has a malfunction.
If the overdrive-off indicator light
flashes, the transaxle has an electrical
problem. Continuing to drive your
Mazda in this condition could cause
damage to your transaxle. Consult an
Authorized Mazda Dealer as soon as
possible.
CAUTION
NOTE
After starting the engine on very cold
days, the TCS OFF indicator will
remain on and TCS will not operate
until the engine is warm.
J94S.book Page 30 Saturday, June 23, 2001 1:04 PM

5-31
Driving Your Mazda
Warning/Indicator Lights and Beeps
Form No. 8Q50-EA-01G





Ignition Key Reminder
If the ignition switch is in the LOCK or
ACC position, a beep will sound when
any door is opened.





Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when any door is opened.
Beeps
J94S.book Page 31 Saturday, June 23, 2001 1:04 PM

5-32
Driving Your Mazda
Form No. 8Q50-EA-01G
Switches and Controls





Headlights
To turn on the lights, turn the knob on the
end of the control lever.





Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when any door is opened.





Headlight High-Low Beam
Push the lever forward for high beams.
Pull it back for low.





Flashing the Headlights
To flash the headlights, pull the lever fully
toward you. The headlight switch need
not be on, and the lever will return to the
normal position when released.
Lighting Control
Lever Position OFF
Headlights Off Off OnTaillights
Parking lights
License lights
Side-marker lights Off On On
NOTE
•
If the light switch is left on, the
lights will automatically switch off
30 seconds after turning the ignition
switch to the LOCK position or
removing the key.
The lights will automatically switch
back on when the ignition switch is
turned to the ACC or ON position.
• To prevent discharging the battery,
don ’t leave the lights on while the
engine is off.
Low beams High beams
J94S.book Page 32 Saturday, June 23, 2001 1:04 PM

5-33
Driving Your Mazda
Switches and Controls
Form No. 8Q50-EA-01G





Turn Signal
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will self-cancel after
the turn is completed.
If the indicator light continues to flash
after a turn, manually return the lever to
its original position.
Green indicators on the dashboard show
which signal is working.
Lane-change signals
Move the lever slightly toward the
direction of the change —until the
indicator flashes— and hold it there. It
will return to the off position when
released. In Canada, vehicles must be driven with
the headlights on during daytime
operation.
For that reason, the daytime running lights
automatically turn on when the ignition
switch is turned to the ON position.
Turn and Lane-Change
Signals
NOTE
If an indicator light stays on without
flashing or if it flashes abnormally, the
turn signal bulb may be burned out.
Right turn
Right lane change
OFF
Left lane
change Left turn
Daytime Running Lights
NOTE
The running lights go off when the
parking brake is applied.
J94S.book Page 33 Saturday, June 23, 2001 1:04 PM

5-35
Driving Your Mazda
Switches and Controls
Form No. 8Q50-EA-01G
One-touch wipers
For a single wiping cycle, push the lever
up to MIST.





Windshield Washer
Pull the lever toward you and hold it to
spray washer fluid. In the OFF or INT
position, the wipers will be activated until
the lever is released.
If the washer doesn ’t work, inspect the
fluid level (page 8-20). If it ’s OK, consult
an Authorized Mazda Dealer. The rear defroster clears frost, fog, and
thin ice from the rear window.
The ignition switch must be in the ON
position.
Push the switch to turn on the rear
window defroster; the indicator light will
come on.
Push the switch again to turn it off.
Rear Window Defroster
Don
’t use sharp instruments or
window cleaners with abrasives to
clean the inside of the rear window
surface. They may damage the
defroster grid inside the window.
NOTE
This defroster is not designed for
melting snow. If there is an
accumulation of snow on the rear
window, brush it off before using the
defroster.
CAUTION
J94S.book Page 35 Saturday, June 23, 2001 1:04 PM

5-36
Driving Your Mazda
Switches and Controls
Form No. 8Q50-EA-01G
To sound the horn, press around the
mark of the steering wheel.The hazard warning lights should always
be used when you stop on or near a
roadway.
The hazard warning lights warn other
drivers that your vehicle is a traffic hazard
and that they must take extreme caution
when near it.
Depress the hazard warning switch and all
four turn signals will flash at once.
HornHazard Warning Flasher
NOTE
•
The turn signals don ’t work when
the hazard warning lights are on.
• Check local regulations about the
use of hazard warning lights while
the vehicle is being towed. They
may forbid it.
J94S.book Page 36 Saturday, June 23, 2001 1:04 PM

6-1
Form No. 8Q50-EA-01G
6Interior Comfort
Use of various features for drive comfort, including air-conditioning
and audio system.
Climate Control System .............................................................. 6- 2
Operating Tips ......................................................................... 6- 2
Vent Operation ......................................................................... 6- 3
Manual Type ............................................................................ 6- 6
Audio System ............................................................................... 6-11
Antenna ................................................................................... 6-11
Operating Tips for Audio System ............................................ 6-11
Audio Set ................................................................................. 6-19
Safety Certification .................................................................. 6-36
Interior Equipment ..................................................................... 6-37
Interior Lights .......................................................................... 6-37
Accessories .............................................................................. 6-38
Storage Compartments ............................................................ 6-41
Sunvisors ................................................................................. 6-44
J94S.book Page 1 Saturday, June 23, 2001 1:04 PM