8B±2WIPER/WASHER SYSTEM
Windshield Wiper/Washer System
General Description
The circuit consists of the starter switch, windshield wiper
& washer switch, windshield wiper motor, windshield
washer motor and alarm & relay control unit.
When the windshield wiper & washer switch is turned on
with the starter switch on, the battery voltage is applied to
the wiper motor to activate the wiper.
The washer motor squirts glass cleaning fluid while the
washer switch is being pushed. The alarm & relay control
unit relay is used to control motion of the wiper.
Windshield Wiper And Washer Switch
Removal and Installation
Refer to Combination Switch in Steering section.
Windshield Wiper Motor
Removal
1. Disconnect the battery ground cable.
2. Disconnect the connector(2).
3. Remove 4 mounting bolts.
4. Remove the nut of the wiper motor shaft, and
disconnect the linkage.
5. Remove the windshield wiper motor(1).
CAUTION: To facilitate the removal of the nuts, be
sure to put out the tip portion of the linkage
sufficiently through the mounting hole of the motor
by sliding the linkage slowly.
880RW002
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Tighten the wiper motor shaft nut to the specified
torque.
Torque: 14 N´m (122 lb in)
2. Remove the wiper arms on both sides, and rotate the
wiper motor until it gets to the autostop position to
secure windshield wiper correct operation.
8B±8WIPER/WASHER SYSTEM
Rear Wiper/Washer System
General Description
The circuit consists of the starter switch, rear wiper &
washer switch, rear wiper motor, rear washer motor and
Alarm & relay control unit.
When the rear wiper & washer switch is turned on with the
starter switch on, the battery voltage is applied to the
wiper motor to activate the wiper.
The washer motor squirts glass cleaning fluid while the
washer switch is being pushed. The alarm & relay control
unit is used to control motion of the wiper.
Rear Wiper and Washer Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the dash side trim panel(1).
3. Remove the lower cover assembly(2).
821RW254±1
4. Remove the rear wiper & washer switch (4).
Disconnect the connector.
Push the lock from the back side of the lower cover
assembly (3).
825R200028
Installation
To install, follow the removal steps in the reverse order,
noting the following point:
1. Push the switch with your fingers until it locks
securely.
