2002 HONDA PASSPORT lights

D – IGNITION
F – GAUGES
G – ADJUSTING REAR AND
SIDE VIEW MIRRORS
H – SHIFTING
I – PARKING
J – HEADLIGHTS
K – WINDSHIELD WIPERS
L
– TURN SIGNALS
M – HEATER CONTROLS
N – MAP LIGHT AND MOONROOF
E – STARTING THE ENGINE
SWITCH
BRAKE
51Off to a Good Start
Interior

52 Off to a Good Start
D IGNITION SWITCH
See page 101.
E STARTING THE ENGINE
See page 157.
FGAUGES
See page 58.
GADJUSTING REAR AND
SIDE VIEW MIRRORS
See page 105.
HSHIFTING
For automatic, see page 76.
For manual, see page 83.
For four-wheel drive, see pages
80 and 84.
I PARKING BRAKE
See page 86.
JHEADLIGHTS
See page 72.
KWINDSHIELD WIPERS
See page 70.
LTURN SIGNALS
See page 75.
MHEATER CONTROLS
See page 120.
NMAP LIGHT AND
MOONROOF
See pages 112.
OPUTTING FUEL IN
THE VEHICLE
See page 197.
Interior

55Instruments and Controls
This section explains the controls
and displays that contribute to the
daily operation of your Honda.
All the essential controls are
within easy reach.
Control Locations56
. . . . . . . . .
Indicators and Gauges 57 . . . . . .
Gauges 58 . . . . . . . . . . . . . . . . . .
Tachometer 58 . . . . . . . . . . . .
Speedometer 58
. . . . . . . . . . .
Odometer 58 . . . . . . . . . . . . .
Trip Odometer/
Reset Knob 58 . . . . . . . . . . .
Fuel Gauge 59 . . . . . . . . . . . .
Engine Coolant
Temperature Gauge 60 . . . .
Indicator Lights 61 . . . . . . . . . . .
Switches70 . . . . . . . . . . . . . . . . .
Windshield Wiper/Washer 70
Headlights 72 . . . . . . . . . . . . .
Illumination Control 73 . . . . .
Rear Window Defogger 74 . .
Rear Window Wiper/
Washer 74 . . . . . . . . . . . . . .
Turn Signals75 . . . . . . . . . . . .
Hazard Warning Flasher 76 . . Automatic Transmission76
. . . .
Transfer Control
(4WD Models)80 . . . . . . . . .
5-Speed Manual Transmission 83 Transfer Control
(4WD Models)84 . . . . . . . . .
Parking Brake 86 . . . . . . . . . . . .
Accelerator Pedal87 . . . . . . . . . .
Clutch Pedal 87 . . . . . . . . . . . . .
Instruments and Controls

HIGH BEAM INDICATOR LIGHT
SEAT BELT REMINDER LIGHT
BRAKE SYSTEM INDICATOR LIGHT
CHARGING SYSTEM INDICATOR LIGHT
61Instruments and Controls
Seat Belt Reminder
As a reminder to you and your
passengers, this light will come
on for about six seconds each time
the key is turned to the “
ON”
position.
The beeper will also operate for
about six seconds after turning the
key to the “
ON” position if the
driver ’ s seat belt is not fastened.
Brake System
The service braking system is a
split system designed so that one
part will provide some braking
action if there is a loss of
hydraulic pressure in the other
part of the system.
To serve as a reminder, the
“
BRAKE” system light is
designed to come on while the
parking brake is set and the key is
turned to the “
ON” position. Have
Indicator Lights

62Instruments and Controls
the system repaired if the light
does not come on when the key is
turned to the “
ON” position
without the engine running or
when the parking brake is set.
This light does not eliminate the
need for brake inspection and
maintenance. The brake fluid
level must be checked regularly.
See the maintenance section of
this manual for other brake
checks.
If the light remains on after
engine start up with the parking
brake released, or comes on
during operation of the vehicle, it
may mean that there is something
wrong with the brake system.
What to do?
1. Check to see if the parking brake has been fully released. 2. If it has, pull off the road and
stop carefully. Remember that:
•Stopping distances may be
longer.
•You may have to push
harder on the pedal.
•The pedal may go down
farther than normal.
3. Have the vehicle towed to the nearest Honda dealer for
repair.
Do not continue to drive with the
brake system light on. There may
be a serious problem with the
braking system. Driving under
this condition is hazardous and
could lead to an accident.
The brake system light does not
indicate that the parking brake is
fully set. When applying the
parking brake, always pull it up as
far as possible.
High Beam
The headlight high beam indicator
lights up when the headlights are
on high beam.
Charging System
This light should come on when
the key is turned to the “
ON”
position and the alternator is not
charging. The light may stay on at
engine idle; however, it should go
off and stay off above the normal
engine idle speed. If the light
comes on while driving, the
charging system should be
checked at once so the battery will
not completely discharge. Stop the
engine, and check for a broken
drive belt. If it is broken, or if the
drive belt is not responsible for
the trouble, have your Honda
dealer inspect and correct the
fault. If the drive belt is broken,

64Instruments and Controls
and the engine. Stop as soon as it
is safe, turn off the engine, and
call for assistance.

If you keep driving with the
malfunction indicator lamp on,
you can damage your vehicle ’s
emissions controls and engine.
Those repairs may not be covered
by your vehicle’ s warranties.
Reduced Power
Indicator
This light comes on for a few
seconds when you turn the key to
the “ON” position
If it comes on at any other time, it
indicates that there is a problem in
the throttle “drive-by-wire”
system. With the light on, your
vehicle goes into “limp home” mode — the engine runs on three
cylinders, and the accelerator
pedal no longer controls engine
speed.
As soon as it is safe, pull off the
road and turn off the engine.
Restart the engine to reset the
system. If the light remains on, or
comes on again while driving,
have the vehicle towed to your
Honda dealer for repair.
Turn Signal
Indicators
A green light flashing on the
instrument panel lets you know
that the front and rear turn signal
lights are working. If the light
stays on and does not flash, check
for a burned out bulb. If there is
no light when the lever is moved,
check the fuse and bulb.
Whenever the Hazard Warning Flasher Switch is on, both turn
signals will flash.
Low Fuel Indicator
This light comes on when the tank
becomes nearly empty. Fill up the
tank as soon as possible.
If the low fuel indicator light
comes on when the fuel tank is
not nearly empty, have the fuel
tank sensing unit and related
components inspected and
repaired by your Honda dealer.
Driving on a road with many
sharp curves may cause the fuel
indicator light to blink
intermittently. This is normal.

67Instruments and Controls
as indicated by the “
U/S” (upshift)
light on the instrument panel.
If vehicle speed drops below
20 mph (30 km/h), or if the
engine is not running smoothly,
you should downshift to the next
lower gear. You may need to
downshift two or more gears to
keep the engine running smoothly
or for satisfactory performance.
This indicator comes on for a few
seconds when you turn the
ignition switch to the “ON”
position.4-Wheel Drive
(4WD) Indicator
4WD models only
This indicator lights when the
4-Wheel Drive system is engaged.
With the 4WD-2WD switch in the
“
OFF” or 2WD position, this light
will come on to provide a “bulb
check” when the key is turned to
the “
ON” position, but should go
out after the engine is started.
If the 4WD-2WD switch is in the
“
ON” or 4WD position, this light
will come on when the key is
turned to the “
ON” position and
remain on after the engine is
started.
Anti-Lock Indicator
This light will come on and go out
when the ignition switch is turned
to the “
ON” position. (If the light
does not come on, see your Honda
dealer to have the system
repaired.)
If the light remains on after
engine start-up or comes on
during operation of the vehicle,
stop as soon as possible and turn
the key off. Then start the engine
to reset the system. If the light
stays on, or it comes on again
while you’re driving, the anti-lock
brake system should be checked
at your Honda dealer.
Until you get it fixed, you ’ll have
normal brakes, but you won ’t
have anti-lock.

72 Instruments and Controls
In cold weather, warm the
windshield with the defrosters
before using the washers. This
will help prevent icing of the
windshield that may block your
vision.
Headlights
The rotating switch on the left
lever controls the lights. Rotating
this switch to the
position
turns on the instrument panel
lights and all exterior lights
except the headlights. Rotating
the switch to the
position turns
on the headlights.
To change between low beams
and high beams, pull back on the lever until you hear a click, then
let go. The high beam indicator
will light (see page 62) when the
high beams are selected.
To flash the high beams, pull the
lever back about half way and
then let it go. The high beams will
stay on for as long as you hold the
lever back, no matter what
position the headlight switch is in.