Page 169 of 294

166Driving Tips
indicator in three or more places
around the tire.
Maintenance
In addition to proper inflation,
correct wheel alignment helps to
decrease tire wear. You should get
your vehicle’
s suspension parts
inspected often, and aligned when
needed.
The tires were properly balanced
at the factory. They may need to
be rebalanced at some time before
they are worn out. Have your
dealer check the tires if you feel a
consistent vibration while driving.
A tire should always be
rebalanced if it is removed from
the wheel for repair.
Make sure the installer balances
the wheels when you have new
tires installed. This increases riding comfort and tire life. Your
vehicle’
s original tires were
dynamic or “spin” balanced at the
factory. For best results, have the
installer perform a dynamic
balance.
Tire Rotation
To help increase tire life and
distribute wear more evenly, you
should have the tires rotated every
7,500 miles (12,000 km).
FRONT
4 WHEEL 5 WHEEL
Move the tires to the positions
shown in the diagram each time
they are rotated.
Replacing Tires and Wheels
The tires that came with your
vehicle were selected to match its
performance capabilities while
providing the best combination of
handling, ride comfort, and long
life. You should replace them with
radial tires of the same size, load
range, speed rating, and maximum
cold tire pressure rating (as shown
on the tire’ s sidewall). Mixing
radial and bias-ply tires on your
vehicle can reduce its braking
ability, traction, and steering
accuracy.
Page 170 of 294

167Driving Tips
We urge you not to install
oversize tires and wheels that
would change your vehicle’s
ride height and possibly affect
handling and stability.
Installing improper tires on
your vehicle can affect
handling and stability. This
can cause a crash in which
you can be seriously hurt or
killed.
Always use the size and type
of tires recommended in this
owner’s manual.
It is best to replace all four tires at
the same time. If that is not
possible
or necessary, then replace
the two front tires or the two rear
tires as a pair. Replacing just one
tire can seriously affect your
vehicle’s handling.
The
ABS works by comparing the
speed of the wheels. When
replacing tires, use the same size
originally supplied with the
vehicle. Tire size and construction
can affect wheel speed and may
cause the system to work
inconsistently.
If you ever need to replace a
wheel, make sure the
replacement’s specifications
match the wheels that originally
came on your Honda. Replacement wheels are available
at your Honda dealer.
Wheels and Tires
Wheels:
16 x 7 JJ
Tires:
Standard on
LX 2WD
225/75R16
Standard on all other models
245/70R16
See page 250 for information
about DOT Tire Quality Grading.
Page 172 of 294

169Driving Tips
Wheel Replacement
Considerations
Damaged wheels must be
replaced. For example, replace
wheels if they are bent, cracked or
heavily rusted, or if wheel nuts
often become loose. Also replace
wheels that leak air (except some
aluminum wheels that can be
repaired). See your Honda dealer.
Do not use bent wheels that have
been straightened, and do not use
tubes in leaking wheels designed
for tubeless tires. Such wheels
may have structural damage and
could fail without warning.
Maximum loads, maximum
inflation pressures, wheel
identification codes, and wheel
sizes are stamped on each wheel.
Service-tested and approvedwheels are available from your
Honda dealer.
When obtaining wheels for any
reason from any other source, the
replacement wheels should be
equal in load capacity, inflation
pressure capacity, diameter, width,
offset and mounting configuration
to those originally installed on
your vehicle. A wheel of the
wrong size or type may adversely
affect load carrying capacity,
wheel and bearing life, brake
cooling, speedometer/odometer
calibration, stopping ability,
headlight aim, bumper height,
vehicle ground clearance, and tire
or tire chain clearance to the body
and chassis. Replacement with
used wheels is not advised: They
may have been subjected to harsh
treatment or very high mileage and
could fail without warning.
Installing wheels and/or tires that
have a higher load carrying limit
than those that originally came on
your vehicle does not increase the
GAWR or GVWR of the vehicle.
Page 242 of 294
Technical Data239
Rear Axle
Models2WD4WDModels2WD4WD
Gear ratio4 3004 300Gear ratio4.3004.300
Lubricant capacity1.87 U.S. quarts(1.77 liters)
Front Axle (4WD Model)
Gear ratio4.300
Lubricant capacity1.6 U.S. quarts (1.5 liters)
Shift-on-the-Fly System
Lubricant capacity0.13 U.S. quarts (0.12 liters)
Wheels and Tires
Tire size225/75R16245/70R16
Wheel size16 x 7 JJ16 x 7 JJ
Tire pressure29 psi (200 kPa)26 psi (180 kPa)
Wheel nut
tightening torque87 lb.ft (118 N.m )
Page 273 of 294

Off-Road Precautions
For your safety and the safety of your passengers, please follow
these precautions:
Don't
Modify Your Vehicle
We urge you not to install aftermarket
"lift kits," oversize
wheels and tires, or alter your
vehicle
in any other way that
would
change the vehicle's
suspension
or ride height. Such
modifications can make handling
difficult and unpredictable, and
they could cause you to lose
control, roll over and be seriously hurt
or killed. Wear Seat Belts
Seat belts are just as important
off-road as on pavement. Seat belts can hold you in position onrough
and bumpy trails and when
driving on hills. If you don't wear
your seat belt, you could bounce
around
and strike the interior of
the
vehicle, or even lose control
and crash. Whenever you drive,
make
sure you and your passengers always wear seat belts.
If
children or infants are along for
th
e ride, see that they are properly
secured,
and never let a passenger
ride in the cargo compartment. In a rollover crash, an unbelted
person
is more likely to die than a
person
wearing a seat belt.
Drive
Smart
Off-road surfaces and conditions
can change quickly and
unexpectedly.
It takes time to
learn
how to read the terrain and
develo
p off-road driving skills. So
always use good judgment. Don't drive faster than conditions
warrant,
and if you ever feel
uncomfortable about a given
situation,
don't do it. Off-Road Driving Information