2-47
When you operate the rear window defogger, it also
warms both outside mirrors to help clear them of fog
or ice. See ªRear Window Defoggerº in the Index for
more information.
The mirrors can also be programmed for
personalization. For more information, see ªMemory
Seat and Mirrorsº and ªSecondary Information Centerº
in the Index.
Curb View Assist Mirror
For this function to work, it must be enabled in the SIC.
See ªSecondary Information Centerº in the Index for
more information.
Your vehicle is equipped with the curb view assist
mirror feature. When the vehicle is shifted into
REVERSE (R) there will be a three second delay
before the curb view assist mirror(s) tilt to a preselected
position. This feature may be useful in allowing you
to view the curb when you are parallel parking.
When the vehicle is shifted out of REVERSE (R) and a
five second delay has occurred, the selected mirrors will
return to the original position.If further adjustment is needed after the mirror is tilted,
the mirror controls may be used.
You can also adjust the angle of tilt for each outside
mirror by doing the following:
1. Place the vehicle in REVERSE (R) and allow
the mirrors to tilt (be sure this feature is enabled
in the SIC).
2. Change the angle of mirror tilt to your liking with
the mirror controls.
The mirrors are now set to the desired position.
This feature can also be disabled/configured through the
SIC. See ªSecondary Information Centerº in the Index
for more information.
Driver's Outside Auto-Dimming
Rearview Mirror
The driver's outside mirror will adjust for the glare of
any headlamps behind you. This feature is controlled
by the on and off settings on the electrochromic mirror.
See ªElectrochromic Day/Night Rearview Mirror with
Compass and Temperatureº earlier in this section.
6-42
The vehicle should not have any snow, ice or mud
attached to it.
The vehicle should be fully assembled and all other
work stopped while headlamp aiming is being done.
The vehicle should be normally loaded with a full
tank of fuel and one person or 160 lbs. (75 kg) on
the driver's seat.
Tires should be properly inflated.
Start the vehicle and rock it to level the suspension.
Headlamp aiming is done with the vehicle low beam
lamps. The high beam lamps will be correctly aimed if
the low beam lamps are aimed properly.
The headlamp aiming devices are under the hood near
the headlamps.
If you believe your headlamps need horizontal
(left/right) adjustment, follow the horizontal aiming
procedure. If you believe your headlamps need only
vertical (up/down) adjustment, follow only the vertical
aiming procedure.
Adjustment screws can be turned with an E8 Torx
socket or T15 Torx screwdriver.
