1
General information and controls
14
d Warning:
To ensure that no air enters
the brake or clutch hydraulic
circuits:
Do not turn the fitting on the
handlebar.
d Warning:
The left and right stub handle-
bars must be repositioned
symmetrically if at all. Make
sure that lines and cables run
correctly. Avoid damage to
electrical wiring.
Retaining screw 1 must
always be tightened to the
correct torque value.
If you do not have a suitable
torque wrench, have the han-
dlebars adjusted by a special-
ist workshop, preferably a
BMW motorcycle dealer.
Adjusting handlebars
1
10rsbkg2.book Seite 14 Dienstag, 19. November 2002 4:56 16
1
General information and controls
15
Adjusting reach A/B Slacken, but do not fully remove screw 1
Remove holder from serra-
tions
Move in direction A or B until
reach is correct Re-assemble the holder cor-
rectly in its retaining serra-
tions
Tighten the retaining screw 1 to
a torque of 20 Nm
Adjusting handlebars
A
B
10rsbkg2.book Seite 15 Dienstag, 19. November 2002 4:56 16
