2002 Acura MDX Owner's Manual

Check the operation of your vehicle’s
exterior lights at least once a month.
A burned out bulb can create an
unsaf e condition by reducing your
vehicle’s visibility and the ability to
signal your intentions to other
drivers.
Lights
Maint enance293
H HI
IGGH H B
BEEA
A M
M H
HE
EA
A D
DL
LIIGGH HT
T
F
FO OG G L
LIIGGH HT
T
L
LO
OW W B
BEEA
A M
M H
HE
EA
A D
DL
LIIGGH HT
T T
TU
UR RNN S
SIIGGN NAAL
L
P
P A
A R
RKKIINNG G L
LIIGGH HT
T/
/
S
SI IDD E
E M
M A
AR
RKKEER
R
01/09/07 12:42:04 31S3V610_298

Check the f ollowing:Headlights (low and high beam)
Parking lights
Taillights
Brake lights
High-mount brake light
Turn signals
Back-up lights
Hazard light f unction
License plate light
Side marker lights
Daytime running lights
(Canadian models)
If you f ind any bulbs are burned out,
replace them as soon as possible.
Refer to the chart on page to
determine what type of replacement
bulb is needed. 343
Lights
Maint enance294
B BA
A C
CKK--U
UP P L
LIIGGH HT
T
S
ST
TO
OP P/
/T
T A
A I
ILLL LIIGGH HT
TS
S
L
LIICCE EN
NS SEE P
PL
LAA T
TE
E L
LIIGGH HT
TS
S
T
T
U
UR RNN S
SIIGGN NAAL
L//
H
H A
AZ
ZA
A R
RDD L
LIIGGH HT
T H
H
I
IGGH H-
-M
M O
OUUNNTT B
BRRAA K
KEE L
LIIGGH HT
T
T
T A
A I
ILL L
LIIGGH HT
TS
S/ /
S
SI IDD E
E M
M A
AR
RKKEER
R L
LIIGGH HT
T
01/09/07 12:42:10 31S3V610_299

Open the hood.
Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
cargo area or pull a trailer,
readjustment may be required.
Adjustment of the headlights should
be perf ormed by a Acura technician
or other qualif ied mechanic.
Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
Your vehicle has halogen headlight
bulbs, two on each side. When
replacing a bulb, handle it by its steel
base and protect the glass from
contactwithyourskinorhard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.
1.
2.
CONT INUED
Replacing a Headlight Bulb
Headlight A iming
Lights
Maint enance295
C CO ON NNNEEC
CT TO
OR R
B
BU
UL LBBHalogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.
01/09/07 12:42:20 31S3V610_300

Remove the electrical connector
f rom the bulb by squeezing the
connector to unlock the tab, then
slide the connector of f the bulb. Remove the socket f rom theheadlight assembly by turning it
one-quarter turn counterclockwise.
Push the electrical connector onto
the new bulb.
Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Turn on the headlights to test the
new bulb. To remove the f ront turn signal
bulb, push it in slightly and turn it
counterclockwise. To remove the
side marker bulb, pull it straight
out of its socket.
Testthelightstomakesurethe
new bulb is working. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place. Install the new bulb into the
socket.
1.
2. 3.
4.
5.
3.
4.
5.
6. Replacing Front Turn Signal/
Parking and Side Marker Light
Bulbs
Lights
Maint enance296
T T
A
A B
B
01/09/07 12:42:34 31S3V610_301

Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
Your car uses halogen f og light
bulbs. See page f or inf ormation
on replacing a halogen bulb.
Remove the electrical connector
fromthebulbbysqueezingthe
connector to unlock the tab, then
slide the connector of f the bulb.
Push the electrical connector onto
the new bulb.
Use a wrench to loosen the light
assembly’s mounting bolt.
Remove the light assembly f rom
the bumper.
1.
2.
3.
4.
5.
295
CONT INUED
ReplacingaFogLightBulb
Lights
Maint enance297
C CO
ON NNNEEC
CT TO
OR R
B
BO
OL LTT
01/09/07 12:42:44 31S3V610_302

Turn on the headlights to test the
new bulb. Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Put the light assembly into the
bumper. Tighten the mounting
bolt.Remove the socket by turning it
one-quarter turn counterclockwise.
Open the tailgate. Use a
screwdriver protected with a cloth
to pry open the two covers.
Determine which of the f our bulbs
is burned out: stop/taillight, turn
signal/hazard lights, side marker
light, or back-up light. Remove the two screws and
remove the rear light assembly
f rom the rear pillar. Remove the burned out bulb. To
remove the stop/taillight, back-up
or side marker light bulb, pull the
bulb straight out of its socket. To
remove the turn signal/hazard
light bulb, push it in and turn it
counterclockwise until it unlocks.
1.
2.
3.
4.
8. 6.
7.
5.
Replacing Rear Bulbs
Lights
Maint enance298
01/09/07 12:42:57 31S3V610_303

Put the socket back into the light
assembly and turn it clockwise to
lock it in place. Test the light to make sure the
new bulb is working. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Install the new bulb into the
socket.
Push the socket into the light
assembly and turn it clockwise
until it locks.
Testthelightstomakesurethe
new bulb is working.
Install the rear light assembly in
the body.Tighten the two screws.
Snap the covers back into position.
Remove the light assembly cover
by prying caref ully with a cloth-
covered screwdriver in the
notches along the top edge.Then
pivot the cover out and down.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.Place the cover back into the light
assembly. Push it up until it locks
in place.
1. 4.
5.
6.
2. 3.
6.
7.
8.
9. Replacing a High-mount Brake
Light Bulb
Lights
Maint enance299
01/09/07 12:43:09 31S3V610_304

The individual map lights, cargo area
light, tailgate light, and the vanity
mirror lights come apart the same
way. They do not all use the same
bulb.Removethelensbycarefully
prying on the edge of the lens with
a f ingernail f ile or a small f lat-tip
screwdriver. Do not pry on the
edge of the housing around the
lens.
Use a small phillips screwdriver to
remove the lens f rom the license
plate light assembly.
Remove the bulb by pulling it
straight out. Push the new bulb
into the socket.
Reinstall the lens.
1.
2.
3. 1.
Replacing a Rear License Plate
Bulb
Replacing Bulbs in the Interior
Lights
Lights
Maint enance300
F FR
RO ON NTT I
INND DI
IVV I
IDD U
UA AL
L M
M A
AP
P L
LIIGGH HT
T
01/09/07 12:43:19 31S3V610_305