Page 144 of 174
29 07 2002
Amber bulbs must be
replaced by bulbs of iden
tical specification and
colour.
In certain weather conditions (low
temperatures, humidity), the
presence of condensation on
the inside of the headlamp
glass is normal; it disappears a
few minutes after the lights have
been switched on.
CHANGING A BULB
1 Dipped beam headlamps
2 Main beam headlamps
2 bulbs (H7 55W)
Press the tab and remove the protective cover corresponding to the faulty bulb.
Disconnect the connector.
Press the end of the securing clip to remove it. Change the b ulb.
When fitting, ensure that the direction notches are positi oned correctly and that
the securing clip is corrrectly fixed.
Reconnect the connector.
Refit the protective cover.
3 Side lights (W 5 W)
Turn the socket using the lever and remove it. Change the bul b.
4 Direction indicators (P 21 W)
Turn the bulb holder a quarter turn and remove it. Change t he bulb.
Note: only handle H7 bulbs using a dry cloth.
To replace the left hand bulbs, remove the protective battery co ver.Direction indicator (WY 5 W)
Pull the rear section of the trans
parent cover and release the
assembly.
Turn the connector a quarter turn and remove it.
Change the bulb.
MAINTENANCE OF YOUR 406
37
Page 145 of 174
29 07 2002
Third brake light saloon
(5 W5W bulbs)
Lower the two metal clips on either
side of the light and slide the cover
towards the rear.
Remove the bulb holder.
Change the faulty bulb. Rear lights, saloon
1 Direction indicators (P 21 W).
2 Reversing lights (P 21 W).
3 Brake lights/Side lights (P 21/5 W).
4 Side lights (P 21/5 W).
5 Fog lamp (P 21 W).
These 5 bulbs are changed from inside the boot:
remove the retaining clips then release the carpet,
remove the connector by pressing the tab
A,
remove the bulb holder by squeezing the tabs,
change the faulty bulb.
MAINTENANCE OF YOUR 406
38
Page 146 of 174
29 07 2002
Tailgate lights
Open the flap using the cut out pro
vided.
Disconnect the connector by releas
ing tab A.
Unscrew the two nuts.
Remove the light by squeezing the
two tabs B. Extract the bulb holder by pressing
the tabs
C.
Change the faulty bulb.
1 Side lights (P 21/5 W).
2 Reversing lights (P 21 W).
3 Fog lamp (P 21 W). Number plate lights (W 5 W)
Remove the translucent protector.
Change the faulty bulb.
MAINTENANCE OF YOUR 406
40
Page 147 of 174
29 07 2002
Rear lights, estate
Wing lights
To remove the trim, pull the handle
towards you and release the panel
upwards.Open the flap using the ignition key.
Remove the connector by pressing
the metal bar
A.
Unscrew the wing nut B.
Release the light. To gain access to the bulbs, press
the tabs and release the bulb holder.
1 Brake/side lights (P21/5 W).
2 Direction indicators (P 21 W).
Change the faulty bulb.
MAINTENANCE OF YOUR 406
39
Page 148 of 174
29 07 2002
Tailgate lights
Open the flap using the cut out pro
vided.
Disconnect the connector by releas
ing tab A.
Unscrew the two nuts.
Remove the light by squeezing the
two tabs B. Extract the bulb holder by pressing
the tabs
C.
Change the faulty bulb.
1 Side lights (P 21/5 W).
2 Reversing lights (P 21 W).
3 Fog lamp (P 21 W). Number plate lights (W 5 W)
Remove the translucent protector.
Change the faulty bulb.
MAINTENANCE OF YOUR 406
40
