2002.5 Peugeot 406 radio

29-07-2002
RADIO
Notes on radio reception
Car radio receivers are subject to phenomena which do not affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of the
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings etc), or of being in an area wh ich is not covered by a transmitter.
Selecting radio mode Press button B.
Selecting a waveband Briefly press button Bto select the FM1, FM2, FMast and AM wavebands.
Automatic station search Briefly press button Kor Lto search for the station immediately above or below.
By continuing to press the button in the direction selected, you will obtain contin
uous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
If the TA traffic programme is selected, only stations broadcasting this type of programme are selected.
Searching for a station occurs first in " LO" sensitivity (selection of the most powerful transmitters) during scan ning of the
waveband, then in " DX" sensitivity (selection of the weakest and most distant transmitte rs).
To make a direct search in " DX" sensitivity, press button Kor Ltwice.
YOUR 406 IN DETAIL
88

RDS
Using the RDS (Radio Data System) function on FMRadio Data System allows you to continue listening to the sa me station, whatever frequency it is using for
the region you are going through.
Briefly press the " RDS" button to switch the function on or off; the display wil l show:
"RDS" if the function is selected.
"(RDS)" if the function is selected but not available.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best
reception and which is transmitting the same programme.
Traffic information programme
Press the "TA"button to switch the function on or off.
The display will show: "TA" if the function is selected,
" (TA) " if the function is selected but not available.
Any traffic information flash will be given priority, whatever source you are listening to (radio, CD or CD changer).
If you wish to interrupt a message, press the "TA"button; this switches the function off.
Note: the volume of traffic information announcements is inde pendent of the volume of normal radio listening. You
can adjust it using the volume button. The setting will be stored and will be used when the next messages are broad
cast.
Regional following mode
When they are part of a network, certain stations broadcast regi onal programmes in the various areas they
serve.
With regional following mode you can keep listening to th e same programme.
Press the " RDS" button for more than two seconds to switch the function on or off.
YOUR 406 IN DETAIL
90
29-07-2002

29-07-2002
THE SATELLITE NAVIGATION
SYSTEM
Introduction
The satellite navigation system guides
you to the destination of your choice
by means of vocal and visual instruc
tions.
The heart of the system lies in the use
of a map database and GPS (Global
Positioning System). This enables
your position to be located by means
of several satellites.
The satellite navigation system con
sists of the following components:
the remote control,
the display,
the control unit,
the last voice message recall control,
the CD ROM.
Some functions or services
described in this guide may vary depending on the CD ROM version or the country.The remote control
There is a storage compartment for the remote control in front of the ashtray.
Pointing the remote control at the screen enables the informat ion contained in
the various menus to be selected.
Direction arrows:
These enable you to move around the screen and
thus select a function.
On the welcome screen only, the Up and Down
buttons enable the brightness of the screen to be
adjusted.
menu : this button allows access to the main menu. It can
be used at any time.
esc : escape button
"Short press": cancels the current operation and
returns to the previous screen.
"Press for more than 2 seconds": returns to the
welcome screen.
This button can be used in any menu. It is inactive
during guidance.
mod : mode button
"Short press": changes between date, navigation
and radio.
val : Confirmation button
Confirms the function selected.
YOUR 406 IN DETAIL 95

29-07-2002
Main menu
Switch on the ignition.
Press the "Menu"button to access the main menu.
Select a function using the direction arrows, then confirm ( "VAL" button). The
"Navigation/guidance" menu offers various options
for selecting guidance:
By entering the address of a new destination.
By selecting a service (Hotel, station, airport...) available in a town.
By selecting an address stored in one of the two directo ries.
By resuming previously interrupted guidance or by stop ping current guidance. Two messages may be displayed
depending on the previous actions: "Resume guid
ance" or "Stop guidance" .
Radio functions are suspended when the system is in guidance mode.
YOUR 406 IN DETAIL
98
Navigation / Guidance
Following selection of the "Navigation/guidance"menu,
a screen warns you about the use of the navigation sys
tem. Follow the regulations in force and do not use the
remote control while driving.
Press the "VAL"button to access the next screen.