2002.5 Peugeot 406 fuel

29-07-2002
OPENING THE BONNET
From inside:pull the handle on the
lefthand side under the fascia.
From outside: lift the catch and
raise the bonnet.
Bonnet struts
These open the bonnet and hold it
open.
To close
Lower the bonnet and release it at
the end of its travel. Check that the
bonnet is properly locked. FILLING WITH FUEL
Fill with fuel with the engine switched
off.
To open the fuel filler flap, firmly pull
the handle on the floor on the left of
the driver's seat.
If you are filling up your tank, do not
continue after the 3rd cutoff of the
pump; this could cause your vehicle
to malfunction.
The capacity of the tank is approxi
mately 15.4 gallons (70 litres).
A filler cap hook is provided on
the inside of the fuel filler flap.
YOUR 406 IN DETAIL
110

29-07-2002
PETROL / LPG DUALFUEL VERSION
166
Filling the LPG tank
(Capacity approximately 46 litres)
– switch off the ignition,
– unscrew the cap protecting thefiller opening,
– lock the filler nozzle onto the opening (if necessary, screw the
appropriate adapter*, located in
the insulated compartment, onto
the filler opening first),
– push the button on the pump,
– once filling has stopped automati cally, unlock the filler nozzle,
– screw the protective cap back onto the filler opening.
* according to destination. Petrol gauge
When the low petrol level indicator
comes on, fill the tank without delay
as the engine can only start using
petrol. Furthermore, a low petrol
level may result in fuel circuit faults.
Gas gauge
If the outside temperature is high,
the gas level indicated by the fuel
gauge may be slightly higher than
the actual level. Safety advice
The safety valve must be
closed before any mainte
nance or repair work is
carried out on your vehicle. To
close it, switch off the ignition.
Ensure that there is no risk that
the loads carried may damage the
tank.
Testing the tank
Decree of 18/01/43 and applica
tion of article 3 of the A.M. of
24/11/82.
The maximum interval between
successive tests is eight years.
However, the test must be repeat
ed whenever the vehicle is sold, if
this sale takes place more than
5 years following the last test.
It is imperative that any work on
the LPG feed system is carried
out by a PEUGEOT dealer.

29-07-2002
Range
The display shows the distance that
can still be covered with the fuel
remaining in the tank.
Note:this figure may rise if there is a
change in driving style or road sur
face, causing a significant drop in
current fuel consumption.
If there are less than 3 litres of fuel in
the tank, only three segments will be
displayed. Average consumption
This is the ratio between the amount
of fuel consumed and the distance
travelled since the computer was last
reset to zero.
The display stops at 30 l/100km.
Current fuel consumption
This gives the fuel consumption
recorded during the last two sec
onds. This function is only displayed
when the vehicle is travelling at more
than 12 m.p.h. (20 km/h).
The display stops at 30 l/100km. Average speed
This is obtained by dividing the dis
tance travelled by the period of time
the vehicle has been in use (with the
ignition on), since the computer was
last reset to zero.Distance travelled
This shows the distance travelled
since the computer was last reset to
zero.
After the trip computer has been
reset to zero, the range data
becomes meaningful only after the
vehicle has been in use for a certain
period.
If horizontal segments are displayed
instead of figures when driving, con
tact a PEUGEOT dealer.
YOUR 406 IN DETAIL
138

29-07-2002
PETROL / LPG DUALFUEL VERSION167
Puncture
Insulated storage compartment
This is located in the boot and con
tains:
the temporary tyre repair cans 1
(your 406 LPG does not have a
spare wheel),
the adaptors 2 necessary for
filling the LPG tank in some
countries,
the towing eye 3.
Fuses
The LPG functions are protected
by the two fuses Ain the fuse box
located in the engine compartment.
Using the repair cans
(Refer to the directions on the cans
also)
if possible, remove the object
which caused the puncture,
rotate the wheel so that the valve is in the same position as the
figures 2 or 10 on a clock,
shake the cans vigorously before use. In very cold weather, warm
the cans between your hands for
few minutes,
hold the valve with one hand and with the other press the injection
nozzle on the can firmly onto the
valve, holding it straight,
maintain the pressure firmly for one minute, carry out the same operation with
the second can, then drive imme
diately, at a moderate speed , to
the nearest garage.
The cans enable you to carry out
a temporary repair.
After use, the tyre must be
changed.
As the cans are pressurized, they
must not be exposed to a temper
ature above 50°C.
Store them away from heat in the
insulated storage compartment.

29072002
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery),
unclip the cover.
Carefully close the cover when
you have finished.The electrical system of
your vehicle is designed
to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
Some electrical accessories or
the way in which they are fitted
can have damaging effects on the
operation of your vehicle; the
electronic control circuits, the
audio circuit and the battery
charging circuit.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for recti
fying the malfunctions resulting
from the installation of acces
sories not supplied and not rec
ommended by PEUGEOT and not
installed in accordance with its
instructions, in particular where
the equipment in question con
sumes more than 10 mil
liamperes. *The maxifuses provide addition
al protection for the electrical sys
tems. All work must be carried out
by a PEUGEOT dealer.
Fuse N° Rating Functions
1* 10 A Reversing lights– Double injection relay Oil
temperature Oil level Air conditioning compressor.
2* 15 AFuel pump, canister solenoid valve.
3* 10 AControl unit.
4* 10 AEngine control unit and automatic gearbox.
5 10 A Particulate Emission Filter control unit Rear
windscreen relay.
6 15 AFront fog lamps.
7 20 AHeadlamp wash.
8* 20 A Direct petrol injection engine control unit Clutch pedal.
9* 15 ALefthand dipped beam lights.
10* 15 A Righthand dipped beam lights
MAINTENANCE OF YOUR 406
44

29-07-2002
PETROL / LPG DUALFUEL VERSION167
Puncture
Insulated storage compartment
This is located in the boot and con
tains:
the temporary tyre repair cans 1
(your 406 LPG does not have a
spare wheel),
the adaptors 2 necessary for
filling the LPG tank in some
countries,
the towing eye 3.
Fuses
The LPG functions are protected
by the two fuses Ain the fuse box
located in the engine compartment.
Using the repair cans
(Refer to the directions on the cans
also)
if possible, remove the object
which caused the puncture,
rotate the wheel so that the valve is in the same position as the
figures 2 or 10 on a clock,
shake the cans vigorously before use. In very cold weather, warm
the cans between your hands for
few minutes,
hold the valve with one hand and with the other press the injection
nozzle on the can firmly onto the
valve, holding it straight,
maintain the pressure firmly for one minute, carry out the same operation with
the second can, then drive imme
diately, at a moderate speed , to
the nearest garage.
The cans enable you to carry out
a temporary repair.
After use, the tyre must be
changed.
As the cans are pressurized, they
must not be exposed to a temper
ature above 50°C.
Store them away from heat in the
insulated storage compartment.

29-07-2002
1.8 Litre 16V 2 Litre 16V1 749 1 997
82.7 x 81.4 85 x 88 16 16
85 100
5 500 6 000
160 190
4 000 4 100
Unleaded Unleaded Ye s Ye s
Ye s Ye s
Manual Automatic Manual Automatic
(5speed)(4speed)(5speed)(4speed)
4.25 4.25 4.25 4.251.9 – 1.9 –
154
TECHNICAL DATA
PETROL ENGINES
MODELS:
Model codes 8B6FZ 8BRFN
8E6FZ 8ERFN 8F6FZ 8FRFN
ENGINES
Capacity (cm 3
)
Bore x stroke
Number of valves
Max. power: EU standard (KW)
Max. power at engine speed (r.p.m)
Max. torque: EU standard (Nm)
Max. torque at engine speed (r.p.m)
Fuel
Catalytic converter
Electronic injection
GEARBOX
CAPACITIES (in litres)
Engine (with filter replacement)
Gearbox Final drive

29-07-2002
TECHNICAL DATA155
PETROL ENGINES
MODELS:
Model codes 8BR6F 8BRLZ
8ER6F 8ERLZ 8FRLZ
ENGINES
Capacity (cm 3
)
Bore x stroke
Number of valves
Max. power: EU standard (KW)
Max. power at engine speed (r.p.m)
Max. torque: EU standard (Nm)
Max. torque at engine speed (r.p.m)
Fuel
Catalytic converter
Electronic injection
GEARBOX
CAPACITIES (in litres)
Engine (with filter replacement)
Gearbox Final drive 2 Litre 16V 2 litre HPI
16V
1 997 1 997
85 x 88 85 x 88 16 16
100 103
6 000 6 000
190 192
4 100 4 000
Leaded Unleaded Ye s Ye s
Ye s Ye s
Manual Manual
(5speed)(5speed)
4.25 4.25
1.9 1.9