2002.5 Peugeot 406 warning

WARNING LIGHTS AND INDICATORS
A permanently lit warning light, or flashing with the engine running, is an
indication of a malfunction in the relevant unit. Some warn ing lights may
be linked to buzzers and a message on the multi–function display. Do n ot
ignore this warning: contact a PEUGEOT dealer as quickly a s possible.
If the Central (STOP) warning light comes on when you are d riving, stop
your vehicle immediately where it is safe to do so.
Central (STOP) warning light
Linked to the "engine oil pressure", ''the low brake fluid l evel'', '' the
coolant temperature gauge'' and ''electronic brake force distrib u
tion system fault'' warning lights.
It comes on each time the ignition is switched on.
Stop immediately if it flashes with the engine running.
Contact a PEUGEOT dealer.
Engine oil pressure warning light
Linked to the central (STOP) warning light.
Stop immediately if it comes on with the engine running.
It indicates either:
– insufficient oil pressure,
– lack of oil in the lubrication circuit. Top up the oil le vel.
Contact a PEUGEOT dealer as soon as possible. Low coolant level
warning light
Stop immediately.
Allow the engine to cool before top
ping up.
The cooling system is pressurised.
In the event of a breakdown and to
prevent the risk of scalding, turn the
cap to the first notch to allow the
pressure to drop.
Once the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.
Fuel filler cap warning
light
This comes on if the fuel
cap is not correctly screwed
on or is missing.
YOUR 406 IN DETAIL
128
29-07-2002

Handbrake, low brake fluid level and electronic brake force
distribution warning light.
This comes on each time the ignition is switched on.
It indicates either:
– that the handbrake is on or has not been released correctly,
and when coupled with the central (STOP) warning light:
– an excessive drop in the brake fluid level (if the light remai ns on even with the
handbrake released),
– lit at the same time as the ABS warning light, it indicates a malfunction of the
electronic brake force distribution system.
Stop immediately.
Contact a PEUGEOT dealer.
Antilock braking system (ABS) warning light
This comes on for 3 seconds each time the ignition is switched o n.
If it comes on at over 8 m.p.h. (12 km/h), it indicates a malfun ction of the
ABS.
However, the vehicle retains conventional servoassisted braking.
Contact a PEUGEOT dealer.
Clogging of the
particulate emission
filter warning light
(diesel engine)
Display of this warning light is
accompanied by an audible signal.
The flashing of this light while the
engine is running is caused either by
the particulate emission filter being
overloaded or by the engine running
too long at idle (white smoke from
the exhaust). There is a risk of the fil
ter clogging if the same conditions of
operation are maintained.
As soon as possible, drive for at
least three minutes at a speed
exceeding 37 m.p.h. (60 km/h), if dri
ving conditions allow this.
If the light comes on, contact a
PEUGEOT dealer as soon as
possible. Front brake pad wear warning light
For your safety, have the pads replaced as soon as this light co
mes on.
YOUR 406 IN DETAIL 129
ESP Electronic
Stability Programme
operation indicator
light
This flashes when the system is
operating.
It is lit continuously if disarmed or if
there is a fault.
29-07-2002

29-07-2002
Passenger air bag
disarming
warning light
Illumination of this warning
light is accompanied by an audible
signal and a message on the multi
function display.
If the passenger air bag is disarmed,
the indicator light comes on when
the ignition is switched on and
remains on.
In all cases, if the warning light flash
es, contact a PEUGEOT dealer.
Air bag warning light
The warning light comes on
for 6 seconds when the igni
tion is switched on.
Illumination of this warning light, with
the engine running, is accompanied
by an audible signal and a message
on the multifunction display indicat
ing the cause of the front or side air
bag fault.
Contact a PEUGEOT dealer.
Water in diesel filter warning light
(according to destination)
Contact a PEUGEOT dealer as soon as possible.
There is a risk of damage to the injection system.
Diesel preheating indicator light
If the engine is warm enough, the light will not come on
and you can
start the engine without waiting.
If the light comes on, wait until it goes out before tryin g the starter.
Engine diagnostics warning light
This comes on each time the ignition is switched on.
If it is lit continuously with the engine runnning, this
indicates a fault in
the emission control system.
If it flashes with the engine running, this indicates a ma lfunction in the injection
or ignition system. There is a risk of damage to the catalytic con verter (petrol
engine only).
Contact a PEUGEOT dealer as soon as possible. Battery charge warning light
This comes on each time the ignition is switched on.
If it comes on with the engine running it can indicate:
– faulty operation of the charging circuit,
– loose battery or starter terminals,
– a cut or slack alternator belt,
– an alternator fault.
Contact a PEUGEOT dealer. YOUR 406 IN DETAIL
130

29-07-2002
Door open warning
light
When the engine is running, the warning light indicates
that a door has not been
closed properly or that the
boot is open.
Electronic immobiliser
warning light
This indicates a malfunction of the electronic immobiliser.
Contact a PEUGEOT dealer.
Low fuel level
warning light.
When this warning light
comes on, you have
enough fuel to drive at least 30 miles
(50 km). The tank capacity is approx
imately 70 litres (15.4 gallons). Coolant temperature indicator
When the needle is in zone
A,the
temperature is correct.
When the needle is in zone B, the
temperature is too high. The central
(STOP) warning light flashes.
You must stop immediately.
Contact a PEUGEOT dealer.
Seat belt not fastened
warning light
With the engine running, the
indicator light comes on
when the driver's seat belt is
not fastened.
YOUR 406 IN DETAIL
131

29-07-2002
Door open warning
light
When the engine is running, the warning light indicates
that a door has not been
closed properly or that the
boot is open.
Electronic immobiliser
warning light
This indicates a malfunction of the electronic immobiliser.
Contact a PEUGEOT dealer.
Low fuel level
warning light.
When this warning light
comes on, you have
enough fuel to drive at least 30 miles
(50 km). The tank capacity is approx
imately 70 litres (15.4 gallons). Coolant temperature indicator
When the needle is in zone
A,the
temperature is correct.
When the needle is in zone B, the
temperature is too high. The central
(STOP) warning light flashes.
You must stop immediately.
Contact a PEUGEOT dealer.
Seat belt not fastened
warning light
With the engine running, the
indicator light comes on
when the driver's seat belt is
not fastened.
YOUR 406 IN DETAIL
131

29-07-2002
Display BThis enables the following information to be displayed:
– the time,
– the date,
– the outside temperature (the °C symbol flashes when there is a risk of ice),
– the radio displays,
– the status of the doors. The display shows you whether a doo r, the boot or the
bonnet is open and if the fuel filler cap is missing.
– the warning messages (e.g. ''battery low'') or information messa ges (e.g. "top
up fuel tank''), displayed temporarily, can be cleared by pressin g button 1or 2
– the trip computer.
Setting the parameters
Press button 1for two seconds to access the settings. The information flashes
to show it is ready to be modified.
Then, individual presses on button 1 allow you to scroll through the various data
in the following sequence:
– language in which the information is displayed,
– unit of distance (kms or miles),
– unit of temperature (Celsius or Fahrenheit),
– time format (12 then 24 hour mode)
– hour,
– minutes,
– year,
– month,
– day,
Pressing button 2allows you to change the information selected. Maintain the
pressure for rapid scrolling.
After ten seconds without action, the display returns to the ma in screen and the
modified data are recorded.
YOUR 406 IN DETAIL 135

29-07-2002
Display CThis enables the following information to be displayed:
– the time,
– the date,
– the outside temperature (the °C symbol flashes when there is a risk of ice),
– the radio displays,
– the status of the doors. The display shows you whether a doo r, the boot or the
bonnet is open,
– the warning messages are displayed temporarily (e.g. "top up fue l tank'') and
can be cleared using the remote control,
– the trip computer (see following page),
– the satellite navigation system (see corresponding section).
Setting the parameters
The remote control allows you to access the settings. Accessing the different
menus is described in the section on the Satellite Navigation System.
YOUR 406 IN DETAIL
136

29-07-2002
SEATS
Manual adjustment of the front seats
1 Forwardsbackwards adjustmentLift the lever and slide the seat forwards or backwards.
2 Seat cushion angle adjustment Lift the lever to set the best angle.
3 Driver's seat height adjustment Pull the telescopic handle forwards and pivot it up or
down.
4 Seat back angle adjustment Turn the knob to obtain the best angle.
5 Head restraint height and tilt adjustment
The settting is correct when the top of the head
restraint is level with the top of the head.
To raise the head restraint, pull it upwards.
To lower the head restraint, it is necessary to push
simultaneously:
the button on the lefthand side on top of the seat
back,
the head restraint downwards.
The head restraint has a frame with notches which
prevents it from dropping down (safety device in case
of impact).
To remove the head restraint, press the tab.
Warning: never drive with the head restraints removed.
They must be in place and correctly adjusted.
6 Front armrests The front armrests can be folded or removed.
To remove them, press the button between the armrest
and the side of the seat and pull the armrest.
YOUR 406 IN DETAIL 111