2002.5 Peugeot 307 SW Dag radio

22-07-2002
YOUR 307 SW IN DETAIL
56
RADIO Notes on radio reception
Car radio/telephone receivers are subject to phenomena which do not affect domestic radio sets. Both MW/LW and FM are sub-
ject to various forms of interference. This is not a reflection on the quality of the equipment, but is due to the nature of the signalsand the way in which they are transmitted.
On MW/LW interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of the increasing distance from the transmitter, deflection of the signals by obstacles ( moun-
tains, hills, buildings etc.) or of being in an area which is not covered by a transmitter. Selecting the radio
Press"SOURCE" several times.
Selecting a waveband Briefly pressing button "BND/AST" to select the FM1, FM2 , FMast and AM wavebands.
Automatic station search Briefly press button Mor Nto search for the station immediately above or below.
The search stops at the first station found. If the TAtraffic programme is selected, only stations broadcasting this type of programme are
selected.
Searching for a station occurs first in "LO"sensitivity (selection of the most powerful transmitters) for scanning of the wave-
band, then in "DX"sensitivity (selection of the weaker and more distant transmitters).
To make a direct search in "DX"sensitivity, briefly press button Mor Ntwice.

22-07-2002
YOUR 307 SW IN DETAIL
58
RDS SYSTEM Using the RDS (Radio Data System) function on FM Radio Data System allows you to continue to listen to the same station whatever the frequency it is using for the region you are going through. Switch the function on or off by pressing the "RDS"button briefly.
The multifunction screen will show: - RDS if the function is active,
- "(RDS)" if the function is active but not available.
RDS station following
This display indicates the name of the station selected. The audio/telephone is continuously searching for the station which has the best reception and which is transmitting the same programme.
Traffic information pprogramme Press the ''TA/PTY'' button to switch the function on or off.
The multifunction screen will show: - TA if the function is selected,
- "(TA)" if the function is selected but not available.
Any traffic information flash will be given priority, whatever source you are listening to (radio, CD or CD changer).If you wish to interrupt the broadcasting of a message, press the ''TA/PTY''button to switch the function off.
Note: the volume of the traffic information is independent of the volume of normal radio/telephone listening . You can
adjust it by using the volume button. The setting will be stored and will be used when the next messages are broadcast. Regional following mode (REG) When they are part of a network, certain stations broadcast regional programmes in the various areas they serve. With regional following mode you can keep listening to the same programme.
To do this, press the "RDS"button to switch the function on or off.

22-07-2002
YOUR 307 SW IN DETAIL59
PTY function This allows you to listen to stations broadcasting a specific type of programme (news, culture, sport, rock etc.). When FM is selected, press button "TA/PTY"for more than two seconds to switch the function on or off.
To find a PTYprogramme:
- select the PTYbutton,
- turn button Gto scroll down the different types of programmes offered,
- when the programme of your choice is displayed press button Mor Nto carry out an automatic
search (after an automatic search the PTYfunction is switched off if no station has been found).
In PTY mode the different types of programmes can be stored in memory. To do this, press the preselection buttons "1"to
"6' ' for more than two seconds. Recalling the type of programme stored in the memory is by brief pressure on the corrres-
ponding button.
EON system
This system connects stations which are part of the same network. It enables traffic information or a PTYprogramme trans-
mitted by a station which is part of the same network as the station to which you are listening, to be broadcast. The service is available when you have selected the TAtraffic information programme or the PTYfunction.
Contextual menu The contextual menu allows you to access the following functions:- "Inputting a frequency"- "Display Radio text" to display information connected with the station being listened to.

22-07-2002
YOUR 307 SW IN DETAIL69
Voice commands The voice commands make it possible to use pre-recorded words or phrases to control a certain number of functions of the
RT3 audio/telephone. Activation of the voice commands Press the button on the end of the lights stalk to activate this function. Example: to recall the radio station stored on button 3, the key words are: "Radio" "Memory" "3" .
To use these key words, you must say the word "Radio", wait for the audible confirmation signal, then say the word
"Memory" , wait for the audible confirmation signal, then end with the word "3", wait for the audible confirmaton signal which
will carry out the action requested. Notes:
- in the absence of any voice commands, this function will be switched off after approximately ten seconds,
- if a command is not understood, a double audible signal is emitted. Saying the word "Help"displays all of the commands available on the screen.
List of commands available
- To change the source (Radio, CD, CD changeur, telephone) : "RADIO" / "CD" / "CHANGER" / "CALL"
- For the radio : "LISTEN" / "PREVIOUS" / "FOLLOWING" / "MEMORY" + N¡ / "AUTOSTORE"
- For the CD : "LISTEN" / "PLAY" / " PREVIOUS TRACK" / "FOLLOWING TRACK" / "TRACK NUMBER" + N¡ / "SHUFFLE" / "SCAN" / "LOOP"
- for the CD changer : "LISTEN"/ "PLAY" / " PREVIOUS TRACK" / "FOLLOWING TRACK" / "TRACK NUMBER" + N¡ / "PREVIOUS DISC" / "FOLLOWING DISC" /
"DISC NUMBER" + N¡ / "SHUFFLE" / "SCAN" / "LOOP"
- For the telephone : "CALL" / "REPEAT" / " PEUGEOT SERVICE"
- For the navigation/card : "STOP GUIDANCE" / "RE-START GUIDANCE" / "REDUCE ZOOM " / "INCREASE ZOOM "
- Various :
"CANCEL" / "HELP"

22-07-2002
YOUR 307 SW IN DETAIL71
CD CHANGER
This is located in the centre of the fascia under the radio. It holds up to 5 discs.
To load the changer, insert the discs with the printed side upwards.
To remove a disc, press and hold one of the buttons "1"to "5" .
The use of copied compact discs may cause faults.
Insert circular compact discs only.

22-07-2002
YOUR 307 SW IN DETAIL
72
SATELLITE NAVIGATION SYSTEM Introduction The satellite navigation system guides you, by means of vocal andvisual instructions (graphics), to yourchosen destination. The heart of the system lies in the use of a map data base and GPS(Global Positioning System). Withthis system you can fix the positionof your vehicle by means of a satelli-te network. The system uses the following elements:
- the CD-ROM drive,
- the configuration CD-ROM,
- the navigation CD-ROM,
- the last voice message recallcontrol,
- the control keypad,
- the CT monochrome screen or the DT colour screen. The CD-ROM drive
This is part of the RT3 radio/telephone. 1.
Ejection button on CD-ROM.
2. CD-ROM housing.
The navigation CD ROMThis contains all the map data. It must be inserted in the drive, printed face upwards.
Use only CD-Roms approved by PEUGEOT. The last voice message recall control Pressing for more than two seconds on the button at the end of the lights stalk repeats the last voice information.
Certain functions or services
described may vary depending on the version of CD-ROM or the
country where the vehicle is sold.
For security reasons, the inputting of navigationinformation by the drivermust be carried out when
the vehicle is stationary.

22-07-2002
YOUR 307 SW IN DETAIL73
Dial; this has two functions: Ð Rotation of the dial:
This allows you to move roundthe screen and thus select a function.
It also allows you : Ð with a "setting" type parameter, after selection, to increase or decreasethe
value,
Ð with a "list"type parameter, to open the list and scroll throughthe values.
Ð with mapguidance, to increase the zoom.
Ð Pressing the dial: This allows:
Ð access to the list of controls (contextual menu) of the permanent display, if
there is no other display superimposed.
Ð confirmation of the selected function or the modified value.
Ð selection of a "setting" or "list" type parameter for modification.
"MODE" button:
Ð Brief press: modification of permanent display (audio system, navigation / gui- dance...),
Ð Pressing for more than two seconds displays general information
"ESC" button:
Ð Brief press: cancellingof operation in progress or erasingof last superimpo-
sed display.
Ð Pressing for more than two seconds: erasing of all superimposed displays and return to the permanent display.
"MENU" button:
Ð Brief pressure: access to the general menu.
Ð Pressing for more than two seconds: acces to the help menu.
The control pads These let you select and validate the functions, controls and programmesdisplayed. The control pad is an integral part of
the RT3 radio/telephone.