2002.5 Peugeot 307 Break light

09-09-2002
Fuse N° RatingFunctions
1 10 A Automatic gearbox reversing lights switch Automatic gearbox starting inhibitor relay
control Manual gearbox reversing lights switch Vehicle speed sen sor
Water in diesel sensor.
2 15 A Canister solenoid valve Fuel pump.
3 10 A Power steering control unit ABS or ESP control unit.
4 10 A Injection control unit Fan unit relay control Additional heating relay control
Automatic gearbox control unit Automatic gearbox sequential cont rol
Automatic gearbox shiftlock relay.
5 15 A Particulate emission filter control unit.
6 15 A Front fog lamps.
7— Not used.
8 20 A Fan unit relay control Engine management control unit supply
Injection pump (Diesel).
9 15 A Left dipped beam.
10 15 A Right dipped beam.
11 10 A Right main beam.
12 10 A Left main beam.
13 15 A Horn.
14 10 A Front and rear headlamp wash pump.
15 30A Oxygen sensors Exhaust gas recirculation solenoid valve Ignition co il
Diesel high pressure regulator Injectors supply (petrol) Preheat co ntrol unit
Air flow sensor (Diesel) Engine management control unit (Diesel)
Injection pump (Diesel) Diesel heater.
16 40A Petrol engine air pump with automatic gearbox.
17 30A Front wiper low/high speed.
18 40A Air conditioning blower.
PRACTICAL INFORMATION
154

CHANGING A FUSE
The fuse boxes are located under
the fascia (left hand side) and in the
engine compartment.
The spare fuses and special pliers A
are fixed to the inside of the lid of the
fascia panel fuse box.
Removing and changing a
fuse
Before changing a fuse you must find
out the cause of the fault and have it
corrected. The fuse numbers are
indicated on the fuse box. Use the special pliers A.
Always change a faulty fuse for
one of the same rating. Fascia fuses
Unscrew the bolt a quarter of a
turn with a coin, then pull the
handle to open the cover and
access the fuses.
PRACTICAL INFORMATION 151
Fuse N° Rating Functions
1 10 A Rear fog lamp.
2 15 A Rear screen wiper.
4 15 A Front electric window/sunroof.
5 15 A Left brake light including trailer.
7 20 A Rear courtesy light, front courtesy light, map readers
Lighter 12 V front socket Glove box lighting.
Correct
PliersAIncorrect
09-09-2002

09-09-2002
PRACTICAL INFORMATION
152
Fuse no. Rating
Functions
9 30 AElectric windows Press operation windows (incompatible with nonp ress operation windows)
Sunroof.
10 15 A Diagnostic socket 12 volt rear socket.
11 15 A Audio equipment Multi–function display Steering wheel cont rols Automatic gearbox.
12 10 A Front right and rear right side lights Number plate and trai ler lighting Central locking switches light
ing/ alarm/hazard warning lights Air conditioning/ashtray ligh t Automatic gearbox switches lighting
Lighter Headlamp beam corrector.
14 30 A Door opening/closing controls Deadlocking controls.
15 30 A Rear windows.
16 5 A Engine fuse box Alarm Particulate emission filter Steering whee l controls Air bags.
17 10 A Rear right brake light, 3rd brake light.
18 10 A Diagnosic socket Steering wheel controls Brake pedal (stop) and cl utch switches Coolant level
switch Second brake switch.
19 30 A PARC shunt.
22 10 A Front left and rear left side lights
Number plate and trailer lighting.
23 15 A Alarm siren Interior alarm control unit.
24 15 A Instrument panel Audio equipment Multifunction display Air conditioning Rear parking aid.
26 30 A Heated rear screen.

09-09-2002
CHANGING A WINDSCREEN
WIPER BLADE
Placing the wiper blades in the
maintenance position Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade Lift the wiper arm, then unclip the
blade and remove it.
Fit the new blade and push back
the arm.
Note : the shortest blade is fitted on
the vehicle's righthand windscreen
wiper arm.
To return the windscreen wipers
to their normal position, switch on
the ignition and operate the wiper
stalk. ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, electric
windows, sunroof, courtesy lights,
audio equipment etc.) can only be
used for thirty minutes, to prevent
discharging the battery.
After thirty minutes, the message
"Economy mode active"
appears
on the multi–function display and the
active functions are put on standby.
To resume use of these functions,
start the engine and let it run for a
few seconds. LOAD REDUCTION FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com
partment of diesel vehicles, etc.)
may be switched off temporarily,
depending on the level of battery
charge.
Reactivation of these functions is
automatic, once the battery charge is
sufficient.
Note:
at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
PRACTICAL INFORMATION 155
A flat battery will prevent
the engine from starting.

09-09-2002
BATTERY
To charge the battery using a battery charger:
Disconnect the battery,
Follow the instructions for use given by the battery charger manufacturer,
Reconnect starting with the negative (–) terminal,
Check that the terminals and connectors are clean. If they are covered with sul
phate (white or greenish deposit), disconnect them and clean t hem.
To start the vehicle from another battery:
Connect the red cable to the positive (+) terminals of the tw o batteries,
Connect one end of the green or black cable to the negat ive (–) terminal of the
slave battery,
Connect the other end of the green or black cable to an e arth point on the bro
ken down vehicle, as far as possible from the battery,
Operate the starter, let the engine run.
Wait for the engine to return to idle, then disconnect th e cables.
PRACTICAL INFORMATION
156
Never disconnect a ter
minal when the engine
is running.
Never charge a battery without
first disconnecting the terminals.
Close the sunroof before dis
connecting the battery. If it does
not operate normally following
reconnection of the battery, you
must reinitialise the sunroof
and its safety autoreverse sys
tem (see section "Doors and
windows § Sunroof").
After every reconnection of the
battery, switch on the ignition and
wait 1 minute before starting to
allow the electronic systems to
be initialised. If slight difficulties
are experienced after this,
please contact a PEUGEOT
dealer.
It is advisable to disconnect the battery if the vehicle is not to be used
for a period of more than one month.

09-09-2002
TOWING A TRAILER,
CARAVAN, BOAT etc.
Only use original PEUGEOT tow
bars that have been tested and
approved from the design stage of
your vehicle. The tow bar must be fit
ted by a PEUGEOT dealer.
Your vehicle is basically designed for
transporting people and luggage but it
may also be used for towing a trailer.
Driving with a trailer subjects the
towing vehicle to more significant
stress and its driver must be particu
larly careful.
Air density decreases with altitude,
thus reducing engine performance.
Above 1000 metres, the maximum
towing load must be reduced by 10%
and so on for every 1000 metres of
altitude.Driving advice
Distribution of loads
Distribute the load in the trailer so
that the heaviest items are as close
as possible to the axle and the nose
weight approaches the maximum
permitted without exceeding it.
Cooling
Towing a trailer on a slope increases
the temperature of the coolant.
As the fan is electrically controlled,
its cooling capacity is not dependent
on the engine speed.
On the contrary, use a high gear to
lower the engine speed, and reduce
your speed.
The maximum towing load on a long
slope depends on the gradient and
the outside temperature.
In all cases, pay attention to the
coolant temperature.
If the warning light comes on, stop
the vehicle and switch off the engine
as soon as possible.Tyres
Check the tyre pressures of the tow
ing vehicle and of the trailer, observ
ing the recommended pressures.
Braking
Towing increases the braking distance.
Lights
Check the electrical signalling on the
trailer.
Side wind
Take into acount the increased sen
sitivity to side wind.
PRACTICAL INFORMATION
158