2002.5 Peugeot 307 Break ESP

09-09-2002
CHANGING A BULB
Front lights
Note:on the right–hand side, remove the style cover, fixed
with two plastic screws, to access the bulbs. Handle the
bulbs with a dry cloth.
1 Dipped beam headlamps (H755W).
2 Main beam headlamps (H155W).
3 Front fog lamps (H155 W). Turn the protective cover corresponding to the faulty
bulb a quarter of a turn and remove it.
Disconnect the connector.
Press the end of the securing clip to free it. Change the
bulb.
When fitting the new bulb, ensure that the direction
notches are positioned correctly and the securing clip
is fixed properly.
Reconnect the connector.
Refit the protective cover, positioning it with the arrow
upwards, then turn it a quarter of a turn to the right. The headlamps are fitted with polycarbonate glass with a
protective coating.
Do not clean them with a dry or abra
sive cloth, nor with a detergent or solvent product. Use
a sponge and soapy water.
4 Side lights W 5 W. Pull the socket rearwards, remove the bulb and change
it.
5 Direction indicators (PY 21 W amber). Turn the bulb holder a quarter of a turn and remove it.
Change the bulb.
Note : In certain climatic conditions (low temperature,
humidity), condensation inside the headlamp glass is
normal ; it disappears a few minutes after the lights are
switched on.
PRACTICAL INFORMATION
148

09-09-2002
Engine compartment fuses
Fuse box
To access the fuse box in the engine
compartment (beside the battery): unclip the cover.
Carefully close the cover and refit
the style cover when you have fin
ished.
PRACTICAL INFORMATION 153
The electrical system of
your vehicle is designed to
operate with standard or
optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a PEUGEOT
dealer.
PEUGEOT will not accept respon
sibility for the cost incurred in
repairing your vehicle or for recti
fying the malfunctions resulting
from the installation of acces
sories not supplied and not rec
ommended by PEUGEOT and not
installed in accordance with its
instructions, in particular where
the equipment in question con
sumes more than 10 mil
liamperes.
* The maxifuses provide addi tional protection for the electrical
systems. All work must be car
ried out by a PEUGEOT dealer.
Fuse N° Rating Functions
1* 30 A Fan unit.
2* 30 A ESP/ABS pump motor.
3* 30 A ESP/ABS solenoid valves.
4* 60 A Builtin Systems Interface supply.
5* 70 A Builtin Systems Interface supply.
6* — Not used.
7* 30 A Ignition switch, power.
8* 70 A Power steering electropump unit.

09-09-2002
Fuse N° RatingFunctions
1 10 A Automatic gearbox reversing lights switch Automatic gearbox starting inhibitor relay
control Manual gearbox reversing lights switch Vehicle speed sen sor
Water in diesel sensor.
2 15 A Canister solenoid valve Fuel pump.
3 10 A Power steering control unit ABS or ESP control unit.
4 10 A Injection control unit Fan unit relay control Additional heating relay control
Automatic gearbox control unit Automatic gearbox sequential cont rol
Automatic gearbox shiftlock relay.
5 15 A Particulate emission filter control unit.
6 15 A Front fog lamps.
7— Not used.
8 20 A Fan unit relay control Engine management control unit supply
Injection pump (Diesel).
9 15 A Left dipped beam.
10 15 A Right dipped beam.
11 10 A Right main beam.
12 10 A Left main beam.
13 15 A Horn.
14 10 A Front and rear headlamp wash pump.
15 30A Oxygen sensors Exhaust gas recirculation solenoid valve Ignition co il
Diesel high pressure regulator Injectors supply (petrol) Preheat co ntrol unit
Air flow sensor (Diesel) Engine management control unit (Diesel)
Injection pump (Diesel) Diesel heater.
16 40A Petrol engine air pump with automatic gearbox.
17 30A Front wiper low/high speed.
18 40A Air conditioning blower.
PRACTICAL INFORMATION
154