3-1
EBU00032
DESCRIPTION AND MACHINE
IDENTIFICATION
1. Storage box
2. Air filter
3. Fuel tank cap
4. Oil cooler / cooling fan
5. Reverse lock release
wire
6. Rear brake pedal
7. V-belt housing
8. Auxiliary DC connector
9. Drive select lever
10. Fuel cock
11. Rear shock absorber
12. Fuses13. Recoil starter
14. Engine oil level window
15. Oil filter
16. Rear brake lever
17. Left handlebar switches
18. Parking brake
19. Starter (choke) lever
20. Speedometer
21. Main switch
22. Fuel level gauge
23. On command four-
wheel drive switch
24. Throttle lever
25. Front brake lever
26. Horn
NOTE:
The machine you have purchased may differ
slightly from those shown in the figures of this
manual.
8-15
EBU00537
Engine oil
1. Engine oil level measurement
a. Place the machine on a level place.
b. Warm up the engine for several minutes
and stop it.
c. With the engine stopped, check the oil lev-
el through the level window located at the
lower part of the left side crankcase cover.
NOTE:
Wait a few minutes until the oil level settles be-
fore checking.
d. The oil level should be between the maxi-
mum and minimum marks. If the level is
low, fill engine with sufficient oil to raise it
to the specified level.
CAUTION:
Be sure no foreign material enters the crank-
case.
1. Level window 2. Minimum level mark
3. Maximum level mark
1. Hublot de contrôle du niveau 2. Repère de niveau minimum
3. Repère de niveau maximum
1. Ventanilla de nivel de aceite 2. Marca de nivel mínimo
3. Marca de nivel máximo
