8-17
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
1. Drain bolt 2. O-ring
3. Compression spring 4. Oil strainer
1. Boulon de vidange 2. Joint torique
3. Ressort de compression 4. Crépine à huile
1. Perno de vaciado 2. Junta tórica
3. Muelle de compresión 4. Tamiz de aceite
Engine oil replacement and oil filter element
cleaning
1. Place the ATV on a level surface.
2. Warm up the engine for several minutes,
and then stop it.
3. Place a container under the engine.
4. Remove the dipstick, and then remove the
drain bolt to drain the oil.
CAUTION:
When removing the drain bolt, the compres-
sion spring, oil strainer and O-ring will fall out.
Take care not to lose these parts.
8-19
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
1. Oil filter cover 2. Oil filter
3. O-ring
1. Couvercle du filtre à huile 2. Filtre à huile
3. Joint torique
1. Tapa del filtro de aceite 2. Filtro de aceite
3. Junta tórica
5. Remove the oil filter cover and oil filter.
6. Clean the oil strainer and oil filter with sol-
vent.
7. Check the O-ring for damage and replace
it if necessary.
8. Install the oil filter, O-ring, oil filter cover,
oil strainer, compression spring and drain
bolt. Tighten the drain bolt to the specified
torque.
CAUTION:
Before installing the drain bolt, be sure to in-
stall the O-ring, compression spring and oil
strainer.
9. Fill the engine with oil, and then install the
dipstick. Tightening torque:
Drain bolt (engine):
32 Nm (3.2 m·kg)
Filter cover bolt:
10 Nm (1.0 m·kg)
