Page 262 of 370
8-21
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
CAUTION:
Be sure no foreign material enters the crank-
case.
10. Warm up the engine for several minutes
at idle speed. Check for oil leakage while
warming up.
CAUTION:
If oil leakage is found, stop the engine immedi-
ately and check for the cause.
Recommended oil:
See page 10-2.
Oil quantity:
Periodic oil change:
2.4L
With oil filter replacement:
2.5 L
Total amount:
3.2 L
Page 264 of 370
8-23
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
Oil pressure check
1. Put a cloth around the cylinder.
2. Slightly loosen the oil gallery bolt in the
cylinder head.
3. Start the engine and keep it idling until oil
begins to seep from the oil gallery. If no oil
comes out after one minute, turn the en-
gine off so it will not seize and find the
cause.
4. Start the engine, and then check the oil
pressure.
5. After checking, tighten the oil gallery bolt
to the specified torque.CAUTION:Be sure to check the oil pressure after replac-ing the engine oil. Tightening torque:
Oil gallery bolt:
7 Nm (0.7 m·kg)
1. Oil gallery bolt
1. Boulon de rampe de graissage
1. Perno del conducto de aceite
Page 272 of 370

8-31
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
6. Inspect the element. If damaged, replace
it.
7. Apply SAE 10W30 motor oil to the ele-
ment.NOTE:The element should be wet but not dripping.
8. Apply all-purpose grease to the air filter
element seat.
9. Reinstall the element to the element
guide.
10. Reinstall the element assembly and parts
removed for access.NOTE:The air filter element should be cleaned every
20 ~ 40 hours. It should be cleaned and lubri-
cated more often if the machine is operated in
extremely dusty areas. Each time filter element
maintenance is performed, check the air inlet
to the filter case for obstructions. Check the air
cleaner rubber joint to the carburetor and man-
ifold fittings for an airtight seal. Tighten all fit-
tings securely to avoid the possibility ofunfiltered air entering the engine.
1. Unlock
1. Déverrouiller
1. Levántelo1. Element retaining plate 2. Guide
3. Air filter element
1. Plaquette de retenue d’élément 2. Guide
3. Élément du filtre à air
1. Element plate 2. Guía
3. Elemento filtrante
Page 284 of 370
8-43
Yuki_Data:Yuki_data:Yuki:Yuki_1:ATV:HM00B067_YFM350X-60:YFM350-8.frame
EL
3. Refill with the same type of brake fluid.
Mixing fluids may result in a harmful
chemical reaction and lead to poor brake
performance.
4. Be careful that water does not enter the
master cylinder when refilling. Water will
significantly lower the boiling point of the
fluid and may result in vapor lock.
5. Brake fluid may deteriorate painted sur-
faces or plastic parts. Always clean up
spilled fluid immediately.
6. Have a Yamaha dealer check the cause if
the brake fluid level goes down.