5-2
OPERATION AND IMPORTANT RIDING POINTS
1
2
3
45
6
7
8
9
EAU00433
Starting offNOTE:
Before starting off, allow the engine
to warm up.1. While pulling the rear brake lever
with your left hand and holding
the grab bar with your right hand,
push the scooter off the center-
stand.
2. Sit astride the seat, and then
adjust the rear view mirrors.
3. Switch the turn signal on.4. Check for oncoming traffic, and
then slowly turn the throttle grip
(on the right) in order to take off.
5. Switch the turn signal off.
1
1. Grab bar
EAU00434
Acceleration and
decelerationThe speed can be adjusted by open-
ing and closing the throttle. To
increase the speed, turn the throttle
grip in direction a. To reduce the
speed, turn the throttle grip in direc-
tion b.
ab
5GJ-9-EV 5/26/01 11:04 AM Page 37
6-8
1
12
Panel F
To remove the panelRemove the panel screws.
To install the panel1. Place the panel in the original
position, and then install the
screws.Cowling B
To remove the cowling
1. Remove panels C and E.
2. Remove the cowling screws and
bolts.
3. Unhook the cowling from the
holder at the bottom.
4. Unhook the front of the cowling
by pushing it up, and then pull
the cowling out.
1. Screw (×2) 1. Bolt (×2)
2. Screw (×2)
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
56
7
8
9
2
1
2
Cowling A
To remove the cowling1. Remove the rear view mirrors by
removing the nuts.
2. Remove the cowling screws.
To install the cowling1. Place the cowling in the original
position, and then install the
screws.
2. Install the rear view mirrors by
installing the nuts.1. Screw (×2)
2. Nut (×4)
5GJ-9-EV 5/26/01 11:04 AM Page 49
