2001 PRIUS (EWD414U)
When the ignition SW is turned ON, the current flows from WIPER fuse to wiper and washer SW TERMINAL 17 and front
wiper motor TERMINAL 2 or the current flows from WASHER fuse to washer motor TERMINAL 2.
1. LO POSITION
When the wiper and washer SW is at LO position, the current flows from wiper and washer SW TERMINAL 17 to TERMINAL
7 to front wiper motor TERMINAL 5 to TERMINAL 4 to GROUND, and the front wiper motor runs at low speed.
2. HI POSITION
When the wiper and washer SW is at HI position, the current flows from wiper and washer SW TERMINAL 17 to TERMINAL
8 to front wiper motor TERMINAL 3 to TERMINAL 4 to GROUND, and the front wiper motor runs at high speed.
3. INT POSITION
When the wiper and washer SW is at INT position, the wiper relay is activated and the current flows from wiper and washer
SW TERMINAL 17 to TERMINAL 2 to GROUND. This current activates the intermittent circuit, and the current flows from
wiper and washer SW TERMINAL 17 to TERMINAL 7 to front wiper motor TERMINAL 5 to TERMINAL 4 to GROUND, and
operates the front wipers.
4. WASHER CONTINUOUS OPERATION
When the wiper and washer SW is pulled to WASHER position (Washer SW ON position), the current from the WASHER
fuse flows to washer motor TERMINAL 2 to TERMINAL 1 to wiper and washer SW TERMINAL 11 to TERMINAL 2 to
GROUND, and operates the washer motor to emit a water spray. At the same time, the current flows from the WIP fuse to
wiper and washer SW TERMINAL 17 to TERMINAL 7 to front wiper motor TERMINAL 5 to TERMINAL 4 to GROUND, and
operates the front wiper motor.
C12 FRONT WIPER AND WASHER SW
2±GROUND : Always continuity
7±GROUND : Approx. 12 volts with the front wiper and washer SW at LO position
Approx. 2 to 12 seconds intermittently with the front wiper and washer SW at INT position
8±GROUND : Approx. 12 volts with the front wiper and washer SW at HI position
16±GROUND : Approx. 12 volts with the ignition SW on unless the front wiper motor at STOP position
17±GROUND : Approx. 12 volts the ignition SW at ON or ST position
F9 FRONT WIPER MOTOR
2±1 : Closed unless the wiper motor at STOP position
: PARTS LOCATION
CodeSee PageCodeSee PageCodeSee Page
C1236J737W135
F934J1737
J137J1837
: JUNCTION BLOCK AND WIRE HARNESS CONNECTOR
CodeSee PageJunction Block and Wire Harness (Connector Location)
2G31Engine Room Main Wire and Instrument Panel J/B (Cowl Side Panel LH)
2I31Cowl Wire and Instrument Panel J/B (Cowl Side Panel LH)
2N31Floor Wire and Instrument Panel J/B (Cowl Side Panel LH)
: CONNECTOR JOINING WIRE HARNESS AND WIRE HARNESS
CodeSee PageJoining Wire Harness and Wire Harness (Connector Location)
IA142Engine Room Main Wire and Cowl Wire (Cowl Side Panel LH)
IH142Floor Wire and Engine Room Main Wire (Left Kick Panel)
: GROUND POINTS
CodeSee PageGround Points Location
IE42Cowl Side Panel LH
IG42Cowl Side Panel RH
SYSTEM OUTLINE
SERVICE HINTS